Superdry Totech N2 Manual de usuario
N2 Auto Flow instructions
Installation Instructions
Auto Purge System
N2 Auto Flow instructions
Holes for N2 system (Side)
Installation instructions
Step 1: Unscrew and remove the nuts on the side of the N2 Auto Flow.
N2 Auto Flow instructions
Step 2: Slide the N2 system through the holes on the side of the cabinet and re-mount the nuts.
N2 Auto Flow instructions
Step 3: Connect one end of the installation cable onto the connector coming out of the N2 system,
the other end of the extension cable plugs into the control box.
Display settings
1. All the functions are set on the control panel.
2. N2 Purging time: Press both DOWN and H/T on the front panel, the setpoint in minutes will flash on
the screen, then press UP or DOWN to change the time. Press SET to confirm the new set value.
Contents
- Auto-Flow control device
- Instruction manual
- Installation cable
Technical data
Power supply: Direct from power supply cabinet
N² Connection: 6mm hose connection
N² Pressure: 1 – 6 bar
N² Standby- amount: 0 – 25 L/min
N² Purge: 0 – 25 L/min
CE- Declaration
N2 Auto Flow instructions
With this document we declare,
Totech Europe BV
Paxtonstraat 11
8013 RP Zwolle
That the Auto Purge System is in conformation with the following EG standards:
EN55011: 1998+A1:1999+A2:2002
EN61000-6-2:2001
2006/95/EG
2004/108/EG
Totech Europe B.V.
Gerhard Kurpiela,
Technical director
Tabla de contenidos
Manuales populares de Purgador automático de otras marcas
SeaSTAR
SeaSTAR POWER PURGE JR HA5445 Manual de usuario
Hansen
Hansen AUTO-PURGER M Instrucciones de funcionamiento
BPS
BPS YZ102 Manual de usuario
Redi Controls
Redi Controls Redi-Purge PRG-113-C3 Manual de instrucciones
Danfoss
Danfoss IPS 8 Manual de instrucciones
Spectron
Spectron BE55+56-SP Manual de usuario
