SUP’AIR Walibi 2 Manual de usuario
SUPAIR-VLD
PARC ALTAÏS
34 RUE ADRASTÉE
74650 ANNECY CHAVANOD
FRANCE
45°54.024’N / 06°04.725’ E
RCS 387956790
Revision Indice
English version
User’s manual
2
Thank you for your choice of a WALIBI². We are proud to join you on your journey
in our common passion : paragliding.
SUP’AIR has been designing, producing and selling accessories for free ying
activities since 1984. By choosing a SUP’AIR product you benet from almost
thirty years of expertise, innovation and listening. This is also our philosophy :
working endlessl
We trust that you will nd this user’s manual comprehensive, explicit and hopefully
pleasant to read. We advise you to read it carefully !
On our website www.supair.com, you will nd the last up to date information about
this product. If you have any further questions, feel free to ask one of our retailers.
And of course, the entire SUP’AIR team are at your disposal through info@supair.
com
We wish you many safe ying and enjoyable hours, and happy landings
The SUP’AIR team
3
List of contents 3
Introduction 4
Technical specications 5
Harness overview 6
Components 6
Rescue parachute setup assembly. 7
Adjustable reserve parachute pocket. 8
Reserve parachute installation in the pocket. 8
Installing the reserve parachute in its pocket. 9
Position setting 11
Leaning angle setting 12
Shoulders’ straps adjustments. 12
Chest strap adjustment. 12
Flight behavior 13
Pre-Flight control 14
Take-off 15
In ight 16
Landing 16
Wash and care of your harness 17
Storage and transport 17
Lifetime 17
Care 17
Repair 18
Materials 18
Recycling 18
Environmental friendly practices 18
Warranty 19
Disclaimer 19
Pilot’s gear 19
Service Book 20
List of contents
Pictures credits: SUP’AIR
4
Welcome to the tandem world.
With the WALIBI², you are equipped with a tandem harness designed with an integrated
reserve parachute pocket and an AirBag protection. This harness is targeting intensive
professional use.
The split-leg design facilitates the running phase and enables the pilot to adopt an ergo-
nomic posture with the passenger seat locked in place between his legs after takeoff.
Introduction
After reading this manual, we suggest you check your harness by hanging in it before ying.
N.B : Three important icons will help you when reading this manual
Advice Caution ! Danger !!
5
Taille S Taille M/L
Pilot size 155-175 cm 170-195 cm
Harness weight (+ carabiners+speedbar) 3610 g 3650 g
Designed for Paragliding only Parapente uniquement
Back height (cm) 58 68
Leaning setting height (cm) 28 34
Seat length (cm) 40 47
Carabiners height (cm) 40 40
Impact damping system : Airbag (Volume) Ye s Ye s
Impact damping system : Bumpair (Thick-
ness) No No
Homologation EN 1651 - LTF EN 1651 - LTF
Flight : tandem (Pilot- Passenger) Pilot Pilot
Flight : acrobatic ying No No
Take-off: Winching No No
Quick-out carabiners compatibility No No
Technical specications
A
B
C
D
E
F
A
B
C
D
E
F
Back height (cm)
Leaning setting height (cm)
Seat length (cm)
Seat width (cm)
Carabiners height (cm)
Carabiners distance (cm)
This harness is delivered with two 30 mm Biners ( 138 g. for the set ).
6
1
2
3
Harness
30 mm Aluminium self-locking biner
Reserve parachute handle (W)
Components
123
Harness overview
1
2
3
4
5
6
Automatic ventral buckle
Rectangular push-through leg straps
buckles.
Ventral width adjustment
Leaning setting
Shoulders straps adjustment
Reserve parachute handle (W)
This illustration will help you during your reading.
1
2
3
4
5
6
4
4Mini Bump
4
5
5Walibi Palte Wood
6
7
Connecting the handle to the rescue parachute’s deployment bag
Place the handle inside the
middle webbing loop and
make a lark’s head knot with
the handle.
Fasten tightly the lark’s head
knot and verify the solidity of
the link.
The handle must be connected to the central loop.
Rescue parachute setup assembly.
Thank you for comprehensively reading the following ! We will
recommend you to have your reserve parachute initially installed
by someone competent and familiar with the procedure.
Open the Mini-Bump zip located at the bottom of the dorsal pocket. Insert
the Mini-Bump through the dorsal pocket and slide it behind the reserve
parachute pocket.When done, close the Mini-Bump pocket.
8
Installing the reserve parachute in its pocket.
Thank you for comprehensively reading the following ! We will recommend
you to have your reserve parachute initially installed by someone com-
petent and familiar with the procedure.
Insert the reserve parachute inside the harness
parachute pocket by opening all the aps. The
POD must be positioned with the handle at the top
with risers and lines at the bottom. Push the risers
through the guiding sleeves ( the risers must be
located behind the parachute ).
Push the cord through the right loop ( if
the handle is located to the right ).
Push the loop through the lower ap grom-
met. The yellow cable will also be pushed
through the lower ap guide located near
the grommet.
Push the cord through the upper ap grom-
met.
The reserve parachute pocket volume is va-
riable in size.You rst must adjust its volume
according to that of your reserve parachute.
Adjustable reserve parachute pocket.
Reserve parachute installation in the pocket.
The pocket volume can slightly be in-
creased by using the lateral aps external
grommets.
The harnesses are delivered by default,
with the “small” volume setting correspon-
ding to the X-TRALITE BI-SUP’AIR reserve
parachute size.
Small volume default set-
ting.
Pull on the rear ap, remove
the cord from it grommet.
Push the piece of line/cord,
underneath the connection
strap, then through the exter-
nal grommet.
9
8910
Upon setup completion, conduct an extraction sequence
during a hang-test to verify that all works properly before
duplicating the installation procedure again...
Push the yellow cable through the loop and gently
pull the cord out. Push the cord through the left loop. Push the loop through the lower ap grom-
met.
Push the loop through the upper grommet
ap grommet and push the yellow cable
through it ( loop ).
The yellow cable locks the reserve parachute pocket
aps in place. Tuck the upper ap inside its lower
stretchable pocket. Check before every igth for the
yellow cable to be properly inserted through the two
loops keeping the reserve parachute pocket securely
Position the handle in its folding sleeve. It
may not protrude from the harness.
Handle positioning in it holding sleeve.
10
Pilot Passenger.
Parachute riser.
Toward the « B « or
« C « wing risers.
« André Rose «
System.
Install the risers inside the lateral guiding sleeve.
The risers come out of each strap guide.
Connect the risers atop each spreader-bar (
main hooking location ), with the maillon rapide
trapeze stainless steel 6 mm + the flexible elastic
rings.
On both sides, push the small recoil » André Rose
« strap / webbing, through the main paraglider
carabiner riser, and connect it to the « B « or «
C « paraglider riser using a triangular ( Delta
shaped ) Maillon - riser denomination can vary
from manufact
Pilot Passenger.
Tabla de contenidos
Otros manuales de Accesorios de SUP’AIR
SUP’AIR
SUP’AIR DELIGHT 4 SPORT Manual de usuario
SUP’AIR
SUP’AIR VIP2 Manual de usuario
SUP’AIR
SUP’AIR ALTIRANDO LITE Manual de usuario
SUP’AIR
SUP’AIR DELIGHT 4 Manual de usuario
SUP’AIR
SUP’AIR ALTIRANDO LITE 2 Manual de usuario
SUP’AIR
SUP’AIR ACCESS 2 AIRBAG Manual de usuario
SUP’AIR
SUP’AIR EVO Lite Manual de usuario
SUP’AIR
SUP’AIR EVO XC3 Manual de usuario
SUP’AIR
SUP’AIR ACRO Base M Manual de usuario
SUP’AIR
SUP’AIR SHAMANE Manual de usuario
SUP’AIR
SUP’AIR PARAMOTEUR EVO Manual de usuario
SUP’AIR
SUP’AIR ACCESS AIRBAG Manual de usuario
SUP’AIR
SUP’AIR PIXAIR 2 Manual de usuario
SUP’AIR
SUP’AIR PERMANENT AIRBAG Manual de usuario
SUP’AIR
SUP’AIR Pixair Manual de usuario
SUP’AIR
SUP’AIR ALTIRANDO 3 Manual de usuario
SUP’AIR
SUP’AIR EVASION BUMP Manual de usuario
SUP’AIR
SUP’AIR Bump'Air Series Manual de usuario
SUP’AIR
SUP’AIR Skypper2 Manual de usuario
SUP’AIR
SUP’AIR ACRO 3 Manual de usuario
