Strong SRT 5220 Manual de usuario
Digital Terrestrial Twin Tuner
Receiver SRT 5220
User Manual
Picture similar
PART 1 • English
1
English
TABLE OF CONTENTS
1.0 INSTRUCTION 2
1.1 Safety Instructions 2
1.2 Storage 3
1.3 Equipment Set-up 3
1.4 Features & Accessories 4
2.0 CONNECTION 5
2.1 Connecting to Terrestrial Antenna 5
2.2 Connecting to TV with SCART cable 5
2.3 Connecting to Video/DVD Recorder with SCART cable 5
2.4 Connecting to TV with S-VIDEO cable 5
2.5 Connecting to a Digital Audio Amplifier 5
2.6 Connecting to PC 5
3.0 YOUR RECEIVER 6
3.1 Front Panel 6
3.2 Rear Panel 6
3.3 Remote Control 7
4.0 FIRST TIME INSTALLATION 8
5.0 MAIN MENU 9
5.1 Channel Organiser 9
5.2 Channel Search 10
5.3 Installation 10
5.4 Timer 13
5.5 Game 13
6.0 OTHER OPERATIONS 14
6.1 Mosaic 14
6.2 EPG 14
6.3 Teletext 14
6.4 Subtitles 14
6.5 Information 14
A.1 TROUBLESHOOTING 15
A.2 SPECIFICATIONS 16
A.3 GLOSSARY OF TERMS 17
PART 1 • English
2
1.0 INSTRUCTION
1.1 Safety Instructions
DO NOT INSTALL YOUR RECEIVER:
n In a closed or poorly ventilated cabinet; directly on top of or under any another equipment; on a
surface which might obstruct the ventilation slots
DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES:
n To direct sunlight or near any other equipment that generates heat; to rain or intense moisture;
to intense vibration and to any shock which may cause permanent damage to your receiver or to
any magnetic objects, such as loudspeakers, transformers, etc.
n Do not use a damaged power cord. It may cause a fire or an electrical shock. Do not touch a
power cord with wet hands. It may cause an electric shock
n Never open the cover. It is dangerous to touch the inside of the receiver due to high voltage
currents and possible electrical hazards. Your warranty will be void if the receiver has
been opened
n When the receiver is not used for a long period of time, you should unplug the power cord from
the wall socket
n Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you may clean
your receiver with a soft lint-free cloth slightly made damp with a mild soap solution, only after
disconnecting from the mains voltage supply. Make sure no foreign objects fall through the
ventilation slots because this could cause fire or an electric shock
n Do not place any objects on top of the receiver because this might prevent proper cooling of the
components inside
SAFETY PRECAUTIONS
n Do not open the receiver cover, as you will be exposed to a shock hazard. It will also void your
warranty. Refer all maintenance or servicing to suitably qualified personnel
n When you are connecting the cables, be sure that the receiver is disconnected from the mains
supply voltage. Wait a few seconds after switching off the receiver before you move the receiver
or disconnect any equipment.
n It is a necessity that you only use an approved extension and compatible wiring that is suitable
for the electrical power consumption of the installed equipment. Please ensure that the electrical
power supply corresponds with the voltage on the electrical identification plate at the back of
the receiver
If the receiver does not operate normal even after strictly following the instructions of this user manual, it
is recommended to consult your dealer.
PART 1 • English
3
English
1.2 Storage
Your receiver and its accessories are stored and delivered in a packaging, protected against electric
damage and moisture. When unpacking, make sure all parts are included. Keep packaging away from
children. For transportation from one place to another or if you are returning the receiver under warranty
make sure it is repacked in its original packaging with all accessories. Failing to comply with such
packaging procedures could void your warranty.
1.3 Equipment Set-up
We recommend you consult a professional installer to set up your equipment. Otherwise, please follow
these instructions carefully:
n Refer to the user manual of your TV and your antenna.
n Make sure that the SCART cable and outdoor components of the antenna are in a good
condition and the SCART connections are well shielded.
This manual provides complete instructions for installing and using this receiver.
The following symbols will serve as follow.
Warning Indicates warning information.
Tips Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver
Move to Represents a menu item within a window
PART 1 • English
4
1.4 Features & Accessories
n For all digital Free-To-Air TV and Radio programmes (with outdoor- or indoor* antenna)
n Twin Tuner Technology: Watch one programme while simultaneously recording another one on
your Video or DVD Recorder
n 1 000 channels memory capacity
n Display showing channel number or time
n Favourite list for TV and Radio programmes
n Quick and easy installation & user-friendly menu
n Mosaic function: 9 TV Channels in overview
n Excellent Audio- and Video quality
n Digital Sound through coaxial output (S/PDIF)
n Set-up support for first time installation
n Electronic Programme Guide (EPG) for present / following event information and up to 7 days
for on screen programme information
n Advanced timer function – easy recording of your favourite TV or Radio programme once, daily
or weekly
n Support Teletext via OSD and VBI
n Multi-lingual subtitling and audio track support
n Multilingual OSD on-screen menu
n Parental lock function for menu and selectable per channel
n High speed channel zapping
n Automatic and manual channel scan options
n User-friendly Remote Control
n Low power consumption
n Separate power switch
n RS-232 port for updating control software
n Games (Mine, Tetris, Gomoku)
n DVB-T compliant, UHF/ VHF Tuner with Loop-through function
n Support of active antenna by 5 V output
n Connections: ANT IN, LOOP IN, LOOP OUT, TO TV, 2 SCARTs (TV/ VCR), S/PDIF, S-VIDEO,
Serial Port RS-232, Power switch
n Accessories: User Manual, Remote control, 2x Batteries (AAA), Short RF (coax lead) cable
* Subject of local broadcast condition
NOTE: The batteries should not be recharged, disassembled, electrically short-circuited or be mixed or
used with other types of batteries.
PART 1 • English
5
English
2.0 CONNECTION
2.1 Connecting to Terrestrial Antenna
Fig. 1
To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN connector at
the back of the receiver. Connect the LOOP OUT to the LOOP IN with the short RF-Coax cable.
2.2 Connecting to TV with SCART cable
Fig. 1
Connect the TV set to the TV SCART connector of the receiver through a SCART cable.
2.3 Connecting to Video/DVD Recorder with SCART cable
Fig. 1
This terrestrial receiver may also be operated together with a Video or DVD recorder..
Connect your Video/DVD Recorder through a SCART cable on VCR SCART.
The signals from Video/DVD Recorder will pass to your TV-set if this terrestrial receiver is powered off or
the AV button on remote control is pressed.
Optional: using coaxial cable, connect TO TV output of the receiver to aerial input of your VCR and aerial
output of VCR to aerial input of your TV set. This will allow you to watch and record analogue
aerial programs to your VCR.
2.4 Connecting to TV with S-VIDEO cable
Fig. 3
On the back of your receiver you will find the S-VIDEO connector. Install an S- VIDEO cable between
connector of the receiver and the one of your TV set. This S-VIDEO output is connected to the same
tuner as TV SCART.
NOTE: This output supports only video. Please set to S-VIDEO in menu System settings > Video
Output. If RGB mode is selected this output is not active.
2.5 Connecting to a Digital Audio Amplifier
Fig. 4
Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the receiver.
2.6 Connecting to PC
Fig. 5
onnect the RS-232 connector of the receiver to the PC by using a serial cable. This allows you to
download new versions of software to your receiver.
PART 1 • English
6
3.0 YOUR RECEIVER
3.1 Front Panel
Fig. 6
1. Power ON/STAND-BY button
2. MENU
By pressing this button you’ll open the OSD menu
3. OK
By pressing this button, you’ll confirm a selection
4. Mode indicator
The RED light indicates that the receiver is in STAND-BY mode. The GREEN light indicates
that the receiver is in AWAKE mode.
5. 4 digits display
In STAND-BY mode indicates current time
In AWAKE mode indicates current channel number
In Extern/TV mode it shows AV
6. Channel Up/Down buttons
In TV mode: channel up/down
In OSD: menu up/down
7. Volume buttons left/right
In TV mode: volume up/down
In OSD: page up/down or depending on option
3.2 Rear Panel
Fig. 7
1. ANT IN
To connect a digital aerial antenna for receiving broadcasting signal.
2. LOOP OUT
To connect a short RF cable to LOOP IN
3. LOOP IN
To connect a short RF cable to LOOP OUT
4. TO TV
To connect an extra receiver or TV set (see chapter 2.3)
5. TV SCART Connector
To connect your receiver with your TV set using a SCART cable.
6. VCR SCART Connector
Option 1: To connect your receiver with your VCR using a SCART cable.
Option 2: To connect your receiver with your DVD recorder using a SCART cable.
Option 3: To connect your second TV set using a SCART cable.
7. Coax S/PDIF (BLACK RCA)
To connect your receiver to digital audio amplifier
PART 1 • English
7
English
8. RS-232 Serial Port
Connect a PC to your receiver to download new software versions.
9. S-VIDEO
To connect to your TV set
10. Main power switch
11. Power Cord
Your receiver requires a voltage of 90 ~ 240 V AC (Auto-selectable), 50 ~ 60 Hz +/-5 %. Make
sure to check the power specification before connecting your receiver to the wall outlet.
3.3 Remote Control
Turns the receiver On/Standby
Mutes audio output of the receiver
PAUSE Freeze/Resume picture
AUDIO Shows list of available audio languages for the channel you
are watching. In addition it sets the current channel audio to
stereo, left-double mono or right-double mono
MENU Opens the main menu
A->B To transfer selected TV program from 1st to 2nd tuner (e.g. for
recording and watching another programme on the 1st tuner)
A/B To switch between tuner 1 and tuner 2. Show running
program on TV SCART output from VCR SCART / 2nd tuner.
(disables all other buttons when this mode is active)
INFO Shows information of the current channel
P+ / P- Page up and down in menu list
EXIT Exits from the menu or sub-menu and cancels the progressing
function if applicable
CHANNEL pq
Menu Off: Change the current program to the previous/next
program.
Menu On: Moves the cursor up/down.
tu Menu Off: Increases/decreases the volume level.
Menu On: Change the setting values in specific Menu item
V+ / V- Use to increase or decrease the receiver volume level.
OK Activates the highlighted menu item. Displays a channel list
according to TV /Radio Mode
TEXT Shows current service’s Teletext on OSD (On Screen Display)
SUB Show list of subtitled languages current channel is supporting
RCL Switches back to previous channel
FAV Toggle Favourite mode ON / OFF
TV/R Toggle between TV or RADIO mode
Tabla de contenidos
Otros manuales de Sintonizador de TV de Strong
