STONEWATER DX 1000 Manual de usuario
USER GUIDE
INDEX
IntroductIon
p.6
GettInG Started
p.8
operatInG the dX1000
p.10
operatIonal eXampleS
p.12
Gain Input p.12
Xover All p.13
Gain Output p.15
Low Cut p.17
Low Delay p.18
Phase All p.19
Limiter p.20
CD Horn p.22
deScrIptIon of featureS
Input Gain & Output Gain p.24
2/3/4 Way Crossover p.24
Phase Inverse p.24
Low Cut p.24
Limiter p.25
CD Horn p.25
Delay p.25
Stereo On/Off p.25
LF Sum p.26
Control Lock p.26
audIo connectIonS
2 Way Mode p.27
3 Way Mode p.28
4 Way Mode p.28
SpecIfIcatIonS
p.29
Crossover frequencies p.29
Input p.29
Output p.29
A/D Performance p.30
D/A Performance p.30
System Perfomance p.30
Function Switches p.30
6
INTRODUCTION
Congratulations on the purchase of your STONEWATER DX1000
digital audio crossover. We are con dent that this product will meet
the high standards you have come to expect out of Stonewater
products. The DX1000 offers you the following features.
• 2/3/4 way crossover mode operation selectable with back panel
switches
• Output gain for each output
• Phase inverse option on all outputs
• Low Cut lter for each channel
• Limiter for each output
• CD horn equalization on high output channels
• Delay option for low output channels
• Distribute your mono input signal to two outputs
• Low summed output for mono sub woofer applications
• Level meters for input channel with clip indicator
• Control Lock for prevention of accidental parameter change
during operation
7
• LED’s on front panel to indicate the operational mode
• LCD display showing accurate parameter and information display
• Full digital front panel user interface with glow buttons
8
GETTING STARTED
Make sure the rear panel switches are set according to the desired
MODE of operation and control lock button is not engaged.
Plug the AC power cord (provide with the unit) to the AC power input
socket on the rear panel as shown above and turn ON the unit. The
glow buttons on front panel will light up for few seconds fl ashing
the unit’s model number and brand name on LCD screen. Once the
DX1000 is ready the LCD screen shows the input level of both the
input channels.
The bars indicate the level of input signal to DX1000. If there is no
input to the DX1000 then there will no bars to display.
NOTE: The LCD screen will display the brand name and model
number of the unit if there’s no input signal present for more than 5
seconds.
1:
2:
9
10
OPERATING THE DX1000
Below shown is the front panel of DX1000
1 2 3 4 5 6
1&6 – Both channels have their individual set of buttons to control
parameters
(Note when in 4 way mode operation Channel 2 button won’t
allow to select parameters)
2 – LEDs to indicate the operational mode.
3 – 16x2 LCD screen for parameter and information display
purpose.
4 – Data wheel to change selected parameter.
5 – Limiter button to change the threshold setting for each output
and CD horn equalizer to engage the horn EQ for high output
channels.
When changing any parameter for any particular channel press the
respective button. The LCD will display the parameter name and the
value. In order to change the value rotate the ‘Data Wheel’, press the
button again and look for more options or press ‘Data Wheel’ to exit.
When no other options are available under that button then LCD will
change back to input level display.
Tabla de contenidos
