STILLA S3021 Manual de usuario

STILLA

ASSEMBLY INSTRUCTIONS

‘Oxford’ 6x9

S3021

Every part needed to construct your shed is included inside the pack; cedar

panels, doors, windows, hardware kits & roof sheeting. Please ensure you fully

unpack all the parts & check against the parts checklist before contacting

customer service about anything you believe may be missing. Thank-you!

20/10/2023

1 | P a g e

Caution

Please be careful when handling all components, some parts have sharp metal edges.

Always wear work gloves, eye protection and long sleeves when assembling or maintaining

your shed.

Tools required for assembly

•Level

•Drill (capable of driving 100mm

Batten Screw)

•Hammer

•Ladder

•10mm Drill bit

•6mm Drill bit

•Tape measure

•Phillips head drive

•Hex Head Drive (5/16’)

•Safety glasses

•Gloves

•Circular/power saw (if heavy duty

floor was chosen)

•4mm Alan key

Batten screw drive

Before assembly

•Before proceeding with installation, we recommend viewing the Cedar Shed video at

www.stilla.com.au/installation/ or search Stilla Classic Cedar Sheds on Youtube. This doesn’t

show the installation in detail however it could give you some handy tips. Please note we

haven’t videoed the assembly of each shed however the video online is the Maple 12x6 and

will give you an overall idea on how the installation process is completed.

•Remove all parts from packages and place in a safe place close to assembly area.

•Check all parts on assembly parts list are included, prior to commencing assembly.

•Review all instructions; continue to refer to instructions throughout assembly –step

by step.

Preparing your site

•If you are installing your shed on the Stilla heavy duty floor, this can be placed on

unlevelled surfaces and levelled up by using the 100x100 stumps provided.

20/10/2023

2 | P a g e

OXFORD 6x9 PARTS CHECKLIST

Part Code

Checked

Part Description

Qty

Cedar Clad Panel 900x1895mm

Cedar Clad Window Panel 900x1895mm

Cedar Shed Window Assembly (add per additional WP option)

Cedar Clad Panel 480x1895mm (Remove if DD)

SCD

Single Colonial Door 830x1840mm (remove if DD)

6ft Gable

Cedar Clad Front Panel 180x1895mm (DD option)

DCD

Double Colonial Door 714x1840mm (DD option)

Corner Post 1890x60x18mm

Cover Strip 1890x40x7mm

6ft Fascia Pack (4)

Collar Tie

Roof Rafter 870x70x45mm

SDH

Single Door Head 840x70x45mm (remove if DD)

SDS

Single Door Step 840x42x19mm (remove if DD)

DDH

Double Door Head 1440x70x45mm (DD option)

DDS

Double Door Step 1440x42x19mm (DD option)

Double Door Packer 100x100x20mm (DD option)

IWS

Internal Window Strip Set –2@ 770mm, 2@ 735mm (add per

additional WP Option)

Roof End Piece 203x70x30mm

1120mm Roof Sheeting

Sky

1120mm Skylight (option- swap with 1120 RS)

1800mm Ridge Cap

1520mm Channel

6x9 Hardware Kit

6x9 Instruction Manual

REP

Roof End Plate 1304x70x45mm

Joining Plate 812x70x45mm

RI (option)

Roof Insulation 2700x1300mm

Floor Kit –Option

Floor Frame - 140x38

Part Code

Checked

Part Description

Qty

End Plate 1884x140x35mm

Double Joist 1280x140x35mm

Single Joist 1280x140x35mm

Logs 750mm

1798x800mm

1798x211mm

20/10/2023

3 | P a g e

If no floor option was purchased, go to step 2.0 (Wall Assembly)

SKIP TO BACK FOR IMAGES TO HELP WITH FLOOR INSTALL

STEP 1.0

FLOOR KIT

1.0 –FLOOR KIT (1 of 2 floor frames)

PART CODE

QTY

DESCRIPTION

End Plate 1884mm

Single Joist 1280mm

Double Joist 1280mm

100BS

100mm Batten Screw

1.0 –FLOOR FRAME (1 of 2 floor frames)

Fasten floor frame together as indicated in diagram below, using lines and predrilled holes.

Screw through EP into DJ using 3x 100BS.

Screw through EP into SJ using 2 x 100BS per join.

Ensure frame is square by measuring from corner to corner diagonally, frame will be square

when both diagonal measurements equal the same.

REPEAT THIS PROCESS FOR FASTENING 1 MORE FLOOR FRAME.

ENSURE 42x35 side of the DJ sits at top.

FRONT

20/10/2023

4 | P a g e

STEP 1.1

FLOOR FRAME INSTALLATION

The 9x6 floor frame comes in two parts. Install first floor frame in desired position at

desired height and fasten to logs once level and square, then join and fasten next frame

and repeat.

1.1 –FLOOR FRAME INSTALLATION

PART CODE

QTY

DESCRIPTION

Logs 750x100x100mm

100BS

100mm batten screws

65BS

65mm Batten Screws

200PB

200mm M12 Post Bolt

M12 Washers

1.1 –FLOOR FRAME INSTALLATION

Repeat the steps below for each floor frame, joining the floor frames together as you go in

order displayed in diagram below.

1. Lay out frame in desired position and mark holes to dig, as indicated on diagram

below (use shovel or marking paint).

2. Dig and place logs in holes (using concrete if you wish).

3. Fasten floor frame to logs at desired height, using 4x 100BS per log, ensuring frame is

level*.

4. Butt next floor frame into installed frame and join using 8x 65BS evenly spaced along

the EP.

5. Repeat process until all frames are joined.

* Fasten frame to logs when roughly level and then critique by hammering in or adding dirt

(or concrete) to corners until perfectly level at every post.

Once all frames are joined, predrill holes (using a 13mm drill bit) and bolt each log to the

floor frame in spots indicated with 200PB, using washers on both sides.

FRONT

20/10/2023

5 | P a g e

STEP 1.2

FLOOR INSTALLATION

1.2 –FLOORING INSTALLATION

PART CODE

QTY

DESCRIPTION

Floor Board 1798x800mm

Floor Board 1798x211mm

50PS

50mm Philips Screw

1.2–FLOORING INSTALLATION

Fasten floor sheets to floor frame as shown in diagram below using 50PS.

Bring Floor sheets in 43mm on all 4 sides from the outside of the floor frame.

Note- The x marked on the floor sheets do not line up with out joists.

20/10/2023

6 | P a g e

STEP 2.0

WALL ASSEMBLY

WALL PANEL WP (900MM WINDOW PANEL) CAN BE POSITIONED ANYWHERE ON THE SHED

WHERE WE HAVE USED A P (900MM WALL PANEL).

2.0 - ASSEMBLY PARTS –WALL ASSEMBLY

PART CODE

QTY

DESCRIPTION

Front Wall panel

900mm Wall panel

65HHS

65mm Hex head screw

2.0 - ASSEMBLY –WALL ASSEMBLY

Screw through FP into P (top, centre & bottom) using 3 x 65HHS. (Holding studs flush on the

outside)

Screw 3 x 65HHS (Top,

centre & bottom)

Cedar Strip

When screwing the four corners together please

make sure the studs are flush on the outside (not

the inside) as per image below.

20/10/2023

7 | P a g e

STEP 2.1

WALL ASSEMBLY

2.1 - ASSEMBLY PARTS –WALL ASSEMBLY

PART CODE

QTY

DESCRIPTION

900mm Wall panel

65HHS

65mm Hex head screw

2.1 - ASSEMBLY PARTS –WALL ASSEMBLY

Screw through P into P (Top, centre & bottom) using 3 x 65HHS, holding studs flush on the

inside.

Screw 3 x 65HHS (Top,

centre & bottom)

20/10/2023

8 | P a g e

STEP 2.2

WALL ASSEMBLY

2.2 - ASSEMBLY PARTS –WALL ASSEMBLY

PART CODE

QTY

DESCRIPTION

900mm Wall panel

65HHS

65mm Hex head screw

2.2 - ASSEMBLY PARTS –WALL ASSEMBLY

Screw through P into P (Top, centre & bottom) using 3 x 65HHS, holding studs flush on the

inside.

Screw 3 x 65HHS (Top,

centre & bottom)

20/10/2023

9 | P a g e

STEP 2.3

WALL ASSEMBLY

2.3 - ASSEMBLY PARTS –WALL ASSEMBLY

PART CODE

QTY

DESCRIPTION

900mm Wall panel

65HHS

65mm Hex head screw

2.3 - ASSEMBLY PARTS –WALL ASSEMBLY

Screw through P into P (Top, centre & bottom) using 3 x 65HHS, holding studs flush on the

outside.

Screw 3 x 65HHS (Top,

centre & bottom)

Tabla de contenidos

Otros manuales de Casa de jardín de STILLA

STILLA

STILLA Hollydean S3094 Manual de usuario

STILLA

STILLA S3031 Manual de usuario

STILLA

STILLA S3011 Manual de usuario

STILLA

STILLA S3081 Manual de usuario

STILLA

STILLA Willow 12x8 Manual de usuario

STILLA

STILLA Hollydean 16x8 Manual de usuario

STILLA

STILLA Willow 12x8 Manual de usuario

STILLA

STILLA Wattle 8x4 Manual de usuario

STILLA

STILLA EASTWOOD 8x12 Manual de usuario

STILLA

STILLA S3071 Manual de usuario

STILLA

STILLA Hampton Manual de usuario

STILLA

STILLA Sycamore S3097 Manual de usuario

STILLA

STILLA Chatswood Manual de usuario

STILLA

STILLA S3110 Manual de usuario

STILLA

STILLA ASHGROVE 8x4 Manual de usuario

STILLA

STILLA S3110 Manual de usuario

STILLA

STILLA Hazel 9x6 Manual de usuario

STILLA

STILLA Glendale Manual de usuario

STILLA

STILLA Master Manual de usuario

STILLA

STILLA Bromley Manual de usuario

STILLA

STILLA Oxford Manual de usuario

STILLA

STILLA Hazel 9x6 Manual de usuario

STILLA

STILLA S3071 Manual de usuario

STILLA

STILLA S3005 Manual de usuario

Manuales populares de Casa de jardín de otras marcas

Mercia Garden Products

Mercia Garden Products 0628LOG181-V4 Manual de usuario

Lemeks

Lemeks Palmako PA120-5930-6 Manual del instalador

Gartenhaus-King

Gartenhaus-King Valery Manual de usuario

Rion

Rion Hobby Gardener Manual de usuario

POD

POD Camping 480 Manual de usuario

Select

Select ISAAC E9682 Manual de usuario

Mercia Garden Products

Mercia Garden Products 01DTSHPWOR1010DDOW-V4 Manual de instrucciones

Palmako

Palmako Saale Manual de usuario

Lemeks

Lemeks Palmako Kira EL16-3623 Manual del instalador

Mercia Garden Products

Mercia Garden Products 0644LOG186-V4 Manual de instrucciones

Palmako

Palmako Roger FR44-5953-2 Manual de usuario

Mercia Garden Products

Mercia Garden Products 03DTSHHP1206HGD4MW-V1 Manual de instrucciones

WAR-LOCK

WAR-LOCK GARDENSHED Skillion Series Manual de usuario

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Manual de usuario

G21

G21 Boston 882 Manual de usuario

Lemeks

Lemeks Palmako Grace PM56-4529 Manual del instalador

Mercia Garden Products

Mercia Garden Products 03WES0808-V1 Manual de instrucciones

Shire

Shire Salcey Manual de usuario