Stiga SILENT 40 EI Manual de usuario

DEUTSCH D

Silent 40 El

8211-3427-04

All manuals and user guides at all-guides.com

all-guides.com

SVENSKA S

2 x (Ø 165 mm) 2 x (Ø 190 mm)

2x 2x

2x (Ø 165 mm) 2x (Ø 190 mm)

G4x

2x 2x

1. 2.

4.3.

III

All manuals and user guides at all-guides.com

SVENSKA

∅165 mm ∅190 mm

Ø 165 mm Ø 190 mm

All manuals and user guides at all-guides.com

SVENSKA S

2 2

10.

3 = 48 mm

4 = 58 mm

2 = 38 mm

1 = 28 mm

54321

3 = 47 mm

4 = 57 mm

5 = 70 mm

2 = 37 mm

1 = 27 mm

II I

III

All manuals and user guides at all-guides.com

SVENSKA

11.

13.

12.

All manuals and user guides at all-guides.com

SVENSKA S

14.

15.

All manuals and user guides at all-guides.com

all-guides.com

ENGLISH

SYMBOLS

The following symbols are displayed on the ma-

chine in order to remind you about the safety pre-

cautions and attention necessary when using the

machine.

The symbols mean:

Warning! Read the Instruction Book and

Safety Manual before using the machine.

Warning! Keep spectators away. Beware of

objects being flung out.

Warning! Before starting any repair work,

disconnect the plug from the wall socket.

Warning! Keep the extension cord away

from the cutting deck.

Warning! Do not put hands or feet under the

cover of the machine when it is running.

Warning! The blades continue to rotate

even after the machine has been switched

off.

ASSEMBLING

PARTS TO ASSEMBLE

Wheel type I (fig. 1)

Wheel type II (fig. 2)

Steering type I (fig. 3)

Steering type II (fig. 4)

TOOLS FOR ASSEMBLEY

WHEELS type I (fig. 5)

1. Fit the bearings F in the wheel.

2. Apply the parts B, (F) and A on the wheel bolt.

3. Snap-on the centre cup C.

4. Fasten the wheel on the mower.

5. Tighten securely by hand using the finger-grip

holes in the hub cap.

WHEELS type II (fig. 6)

1. Fit the bearings F in the wheel.

2. Apply the parts B, G, E, (F) and A on the wheel

bolt.

3. Snap-on the centre cup C.

4. Fasten the wheel on the mower.

5. Tighten securely by hand using the finger-grip

holes in the hub cap.

STEERING type I (fig. 7)

1 .Insert the tubes into the ends of the handlebar.

2. Fit the screws. Tighten securely.

3. Inserttheends of the U tubeintotheholes inthe

chassis.

4. Fit the screws. Tighten securely.

5. Attach the handle to the U tube using the bolts,

washers and locking knobs provided. The han-

dlebar can be folded forwards by undoing the

locking knobs slightly. This reduces the space

the mower takes up during transport, etc.

6. Secure the electrical cable into the cable holder.

7. Fix the electrical cable using a cable tie.

STEERING type II (fig. 8)

1. Press the plugs intothesteering sockets. Ensure

that the plugs are inserted in the correct end.

2. Press the steering sockets into the holes in the

chassis.

3. Fit the screws. Tighten securely.

4. Attach the handlebar to the steering sockets us-

ing screws, washers and locking knobs. The

handlebar can be tilted forward by loosening

the locking knobs slightly. The mower will then

take up less space during transportation.

5. Fix the electrical cable using a cable tie.

STOP

All manuals and user guides at all-guides.com

ENGLISH GB

GRASS COLLECTOR (fig. 9)

Fabric collector bin: Pull the fabric collector bag

over the steel frame and snap the bag on the plastic

cover.

Plastic collector bin:Snap the two halves together

and then the upper part.

Open the cover on the machine and hook the grass

collector onto the chassis.

Note! The lawn mower can be used without the

grass collector. The grass will then collect in a

bead behind the machine.

USING THE MOWER

CUTTING HEIGHT (fig. 10)

Depending on the model, the cutting height is ad-

justed as follows:

I. Fasten the wheels in one of the four possible po-

sitions.

II. Set the height adjustment lever to the desired

position.

Note! The same cutting height should be set on all

four wheels.

CONNECTION (fig. 11)

Only use an extension cable approved for outdoor

use. If uncertain please contact your dealer.

To increase safety the lawn mower should be con-

nected to an earth-fault breaker.

Supportthe extensioncable inthecable supporton

the steering.

START/STOP (fig. 12)

Start the mower on flat, solid ground. Do not start

in long grass. Press on the steering so that the front

wheels liftslightlyfrom the ground toreduce grass

resistance.

Starting the motor:

1. Press the button

2. Pull the handle towards the steering.

Stopping the motor: Release the handle.

CUTTING (fig. 13)

Always cut away from the cable.

Empty the grass collector in good time so that the

grass deflector does not get blocked and reduce

grass collection capacity.

To avoid overloading the motor, do not push the

mower too quickly in long grass.

MAINTENANCE

CHANGING BLADES (fig. 14)

Alwayspullouttheplugbeforecarrying

out maintenance, cleaning or other ac-

tions on the machine.

Wear protective gloves. Loosen the blade bolts us-

ing a 26 mm spanner. Fit a new blade. Tightening

torque 22 Nm.

Always use genuine spare parts.

CLEANING AND STORAGE (fig. 15)

Always wipe or brush off the mower after use.

The cold air intake around the motor casing should

always be kept free from grass and dirt so that the

motor does not overheat.

The underside of the chassis can be scraped clean.

Never rinse with water.

The mower should be stored in the dry.

All manuals and user guides at all-guides.com

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cortacésped de Stiga

Stiga

Stiga 125 COMBI PRO 8211-0543-01 Manual de usuario

Stiga

Stiga Park Comfort Manual de usuario

Stiga

Stiga CP1 430 Li 48 series Manual de usuario

Stiga

Stiga Villa Prestige Manual de usuario

Stiga

Stiga P 901 PH Pro 740 IOX Manual de usuario

Stiga

Stiga MULTICLIP 51S Manual de usuario

Stiga

Stiga MP1 500 Li D48 Series Manual de usuario

Stiga

Stiga Park series Manual de usuario

Stiga

Stiga Park series Manual de usuario

Stiga

Stiga 110 Combi Pro Manual de usuario

Stiga

Stiga XK 140 HD Manual de usuario

Stiga

Stiga SILEX 87 G Manual de usuario

Stiga

Stiga MPST 84 Li 48 V1 Manual de usuario

Stiga

Stiga Autoclip 720S Manual de usuario

Stiga

Stiga ESTATE ROYAL Manual de usuario

Stiga

Stiga VILLA 2000 Manual de instrucciones

Stiga

Stiga 320 MW Manual de usuario

Stiga

Stiga STIGA PARK 100 B Manual de usuario

Stiga

Stiga NEW ESTATE PRO 20 13-2535-12 Manual de usuario

Stiga

Stiga EL 340 Manual de usuario

Stiga

Stiga stig Manual de usuario

Stiga

Stiga ESTATE PRO 13-2561-11 Manual de usuario

Stiga

Stiga PARK ROYAL 13-6183-14 Manual de usuario

Stiga

Stiga MP 84 Series Manual de usuario

Manuales populares de Cortacésped de otras marcas

RHINO

RHINO 1958 Manual de usuario

Wolf Garten

Wolf Garten Compact plus 40 B Manual de usuario

Cub Cadet

Cub Cadet LTX 1045 Manual de usuario

Craftsman

Craftsman 917.378461 Manual de usuario

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manual de usuario

Challenge

Challenge CH18V2 Instrucciones de operación

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manual de usuario

DEWEZE

DEWEZE ATM-725 Manual de operación

Weed Eater

Weed Eater 180083 Manual de usuario

Husqvarna

Husqvarna Poulan Pro PP185A42 Manual de usuario

Better Outdoor Products

Better Outdoor Products Quick Series Manual de usuario

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manual de funcionamiento

MTD

MTD 795, 792, 791, 790 Manual de usuario

Toro

Toro Groundsmaster 3505-D Manual de usuario

Dennis

Dennis FT 610 Manual de usuario

AIRFORCE

AIRFORCE F-15 Gen 3 Manual de usuario

MTD

MTD 126-220-000 Manual de usuario

Toro

Toro 74806 Manual de usuario