Note: This manual refers to “AC” to represent electrical power. Your
location may use 120V, 220V, or other electrical power. Screen systems are
manufactured using the electrical power type specified for the location. Use
appropriate power sources for your location.
Unpacking
1. Remove the outer plastic covering and white wrapping paper
surrounding the screen case.
2. Do not remove the wrapping paper surrounding the screen roller.
You should remove it only after the unit is hung and all electrical
connections have been made.
3. Remove the batten lock-down screws located on the back side of
the case.
Luxus A Electriscreen: Owner’s Manual 3
Caution
During installation, do not place the unit on an unstable cart,
stand, table, or ladder. The unit may fall, causing injury to a
child or adult and damage to the unit.
Warning!
Failure to remove the batten lock-down screws can result in
permanent damage to the screen.
To avoid damage to the screen while unpacking, lifting, or
installing this electric projection screen, do not compact the
screen's batten bar against the screenroll assembly.
Installers should never use their hands or allow any
tools or equipment to come into contact with the
screen's batten or screenroll assembly.
Lifting should be performed only at the ends of the
housing. If manual support is required, use hands only,
and only on the exterior of the housing.
Projection screens should always be protected when installed
in unfinished rooms. Damage will result if left unprotected in
these situations. Make sure screen is retracted at all times
and electrical service to the unit is shut off. Cover the ceiling
opening with plastic sheeting to guard against foreign debris
(such as dry wall dust or paint) from entering screen housing.
Remember to remove protective plastic sheeting prior to
screen's first-time activation upon room's completion.
