BEFORE USE
1. Verify that the product and the application are compatible; if in doubt call your
authorised Steerman Distributor for further advice.
2. Before using this product, read the operating instructions thoroughly and familiarize
yourself with the product and the hazards associated with its improper use.
3. Open the release valve (counter clockwise no more than 2 full turns).
4. Check to ensure that the jack pump operates smoothly prior to putting into service.
5. Inspect the unit before each use. Do not use if leaks, cracked, bent or damaged
components are evident.
OPERATION
Lifting
1. Assemble the 3-piece handle, ensuring that the spring clips are correctly
engaged in the respective slots.
2. Secure the load to prevent inadvertent shifting and movement.
3. Ensure that the base on which the jack will be placed is suitable to take the
loading being imposed. The base must be level and firm.
4. Position the jack near the desired lifting point and always ensure that you follow
any manufacturer’s instructions regarding the correct lift points and methods
applied to machinery.
5. Close the release valve by turning clockwise until it is positively closed.
6. Raise the load to the desired height and immediately transfer the load to
appropriately rated support devices such as jack stands.
USE THE HANDLE PROVIDED WITH THIS PRODUCT OR A GENUINE STEERMAN
REPLACEMENT HANDLE TO ENSURE PROPER RELEASE VALVE OPERATION. DO
NOT USE EXTENSION BARS/TUBING ON THE HANDLE.
WHEN USING THE JACK TO LIFT A VEHICLE, LIFT ONLY ON THE RECOMMENDED
LIFT POINTS AND IN ACCORDANCE WITH THE MANUFACTURER’S PUBLISHED
GUIDELINES.ALWAYS USE JACK STANDS TO IMMEDIATELY SUPPORT ANY
LOAD AFTER LIFTING.
STUDY, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING
THIS DEVICE.
DO NOT EXCEED THE RATED CAPACITY.
USE ONLY ON FIRM LEVEL SURFACES.
IMMEDIATELY AFTER LIFTING, SUPPORT THE OBJECT WITH APPROPRIATELY
RATED SUPPORTS.
ALWAYS WEAR THE APPROPRIATE SAFETY CLOTHING AND EQUIPMENT WHEN
OPERATING THIS EQUIPMENT.
FAILURE TO READ AND HEED THESE WARNINGS COULD RESULT IN PERSONAL
INJURY AND/OR EQUIPMENT DAMAGE
Lowering
1. Raise load just enough to remove the support device/s.
2. Place the handle onto the release valve and slowly turn handle counter
clockwise, but no more than a ½turn. If the load fails to lower, carefully
transfer the load to another lifting device and jack stands. Carefully remove
the affected jack and the jack stands, lower the load, again by slowly turning
the release valve no more than a ½turn.
3. After removing the jack from under the load, fully open the release valve
returning the cylinder to the fully closed position, this prevents ingress of
debris to the cylinder and pump.
