Pub 300 rev A
01/2011
Advanced Settings
Connected Devices and System Reset...
• Turn on the control by pressing power button the press the TOOLS button.
The TSC-450 Digital Control is shipped programmed with Default System Settings and Control Settings.
When the control is turned on, these Default Settings will be in eect, and should be the correct settings
for almost any user. These Advanced Settings should rarely be necessary.
• Press the DEVICES button.
This screen is for troubleshooting purposes only. In order to see all connected
devices you may need to press the NEXT button.
- Connected Devices are generators and accessories that are communicating
with the Touch Control.
• To restore factory defaults press and hold the SYS RESET button for 5 seconds.
The button will ash gray twice indicating defaults have been restored.
• Press the power button to exit or the return button to go back to the
prior screen.
Audio Input Level Adjustments...
• Turn on the control by pressing power button the press the TOOLS button.
• Press the INPUT button.
To adjust AudioSense
™
Input (if the Total Sense
™
system is equipped with
AudioSense
™
).
• Select AUDIO A, AUDIO B, or IPOD and use left and right arrows to
adjust input levels. The default setting, which is three bars up for each input, is a
good starting point and should not be adjusted unless a weak input needs to be
boosted. This allows you to adjust volume based on the input level of the audio
source connected to the AudioSense
™
Control Module. Adjusting this setting too
high will distort the sound quality.
• Depending on the audio source connected to AUDIO A and AUDIO B, you may
need to increase the input boost to get a more acceptable volume level. This is a
global setting for all users.
• After changing these settings, you will need to re-adjust the volume for each
user.
• Press the power button to exit or the return button to go back to the
prior screen.
Page 6
