Steamfast SP-350 Series Manual de usuario

Built for years of

care-free use,

Read These Instructions

completely

before use.

MODEL

SP-350

Series

Please read this manual before

using

and keep for future reference.

Professional Style Steamer

Dear Consumer

Thank you for purchasing the SteamFast

Professional Style steamer.

In order

prolong the life of your steamer we

recommend that the water tank be drained between

each use if tap water is being used. This will reduce

liming as a result of hard water.

Your SteamFast

steamer is equipped with a

thermostat control that will shut the steamer

off

when

the temperature reaches

248°F.

The steamer will automatically begin heating again

when the temperature drops below

248°F.

Should the water tank run dry while the unit is in

operation, we recommended that it be turned

off

immediately. If the steamer is not turned

off

immediately,

the thermostat will cause the unit

shut

off.

owever, damage may occur to the unit.

In the event that the steamer is left in operation

without water or the thermostat should fail

operate

properly, the unit's fuse will burn out at

302°F

causing

the steamer

shut

off.

-SteamFast

Top Innovations, Inc.

400

Platte Valley Dr.,

Riverside,

641

web site:

www.topinnovations.com

INTRODUCTION

Congratulations on your purchase

the Steam Fast®

professional Steamer.

You

will find that the Steam Fast®is

easy

use

and extremely versatile.

Your new steamer provides professional results every time!

1. Holds over one half gallon of water

enough for approximately

Water container is removable and easy

fill.

Automatic shut

off safety feature.

Easy

use drain port.

Eliminates ironing by removing wrinkles.

Easy roll casters make unit highly portable.

Convenient hanger for hose.

Stores upright minimizing storage space requirements.

minutes of continuous operation.

IMPORTANT

SAFETY INSTRUCTIONS

When using electrical appliances, always follow basic safety

precautions, including the following:

Read

all

instructions.

protect against risk

electrical shock, do not put appliance

water or other liquid.

Close supervision

necessary when any appliance is used by or

near children.

Unplug from electrical outlet when not in use, before putting on or

taking off parts and before cleaning.

Avoid contact with hot parts. Keep hands, hair, and clothing away from

these parts to prevent risk of injury to persons and

burns that

could occur.

Use this product for its intended use only.

not operate any appliance with a damaged cord or plug or after

the appliance malfunctions or is dropped or damaged in any manner.

damaged cord, plug or unit may result in fire, electrical shock

or injury.

not leave the steamer unattended.

Please allow the unit

cool before storage. The use of attachments

not recommended or sold for this appliance may cause fire, electric

shock or injury.

10.

Always turn the switch to

off

position before plugging

unplugging the

unit.

11.

not let cord touch hot surfaces.

12.

not operate steamer without properly filling the water container.

13.

Always keep the hose nozzle elevated above the water container.

14.

Burns can occur by

touching

hot parts, hot water or steam.

not lay the hose on the floor.

SAVE THESE INSTRUCTIONS

LEARNING ABOUT YOUR STEAMER

Please refer to the picture for each

point

(1) The control HANDLE on the end of the hose sits

just

before the nozzle. The HANDLE is designed to be

heat free and is safe to grasp. Use the HANDLE to

aim the direction of the steam released from the

nozzle.

(2) The NOZZLE on the end of the handle is located on

the end

the steamer hose. Always sit the NOZZLE

end of the hose on the hanger rod when not in use.

Keep the NOZZLE pointed upward and steam will

rise. If you point the NOZZLE downward, water

may condense and drip.

(3) The ROD

designed to conveniently hang the hose

handle and

also

can support garments for steaming.

(4) The HOSE extends from the base of the unit. Do not

pull on the HOSE with extreme pressure

you may

cause damage and leakage of steam.

(5) The

ON/OFF

switch

located on the front of the base.

(6) The WATER CONTAINER is filled through a hole in

the bottom and should be placed in the reservoir on the

base. Avoid spilling excess water into the reservoir

this could cause the steamer to expel water from the

nozzle. Do not try to substitute another water container

for the one designed for this

unit.

(7)

The WATER LEVEL can be seen visually in the water

container.

not operate the steamer without water

the WATER CONTAINER.

(8)

The steamer BASE houses the reservoir and water

container.

also

supports the hanger rod and hose.

(9)

The CASTERS allow the unit to

roll

freely.

(10) The ELECTRICAL CORD plugs into a standard three-

prong plug. Use only three prong UL approved extension

cords with

minimum 20-ampere rating.

(11) The DRAIN PLUG is located on the side

for

convenient drainage of the water reservoir.

(

12)

The dual hook hanger allows

for

convenient simultaneous hanging

the nozzle and clothing.

STEAMER

ASSEMBLY

STEP

ATTACHING

THE

ROD

Set the appliance on

steady surface.

B. The Rod is shipped in a collapsed position and

must be extended for use. Take the Rod and

loosen the Top Knurled Knob slightly by

rotating it counter

clockwise. Grab the

Rod

the

Hook

Mount and extend fully (about

inches). Tighten the

Top

Knurled Knob.

Similarly loosen the Bottom Knurled Knob and

extend the middle section of the Rod and

retighten.

Loosen the Rod Base by turning it counter

clockwise several turns. Insert the bottom

the

Rod and press down firmly. Hand-tighten the

Rod Base

turning clockwise.

Place the

Dual

Hook Hanger over the

Hook

Mount and hand-tighten with clockwise turns.

STEP

-ATTACHING

THE

STEAMER

HOSE

Screw the end of the steamer hose with the

knurled

knob

onto the threaded pipe on the

top

the steamer unit. (Caution:

not use

excessive force in tightening the knob

)

Tighten by hand until it no longer turns.

Hang the nozzle from the large hook on the

Dual Hook Hanger.

STEAMER OPERATION

Set the unit on the floor and remove the water

container.

Check the inside of the container the sediment.If

present rinsethe container and following the

Removing Mineral Buildup procedure

found

later in

this manual.

Turn the container upside down and push the plunger

valve open and allow to close two or three times to

insure it is functioning smoothly.

CAUTION: DO NOT PULL ON THE PLUNGER

VALVE OR YOU MAY ACCIDENTALLY REMOVE

IT AND THE WATER TANK WILL NOT FUNCTION

PROPERLY.

If the plunger is removed or falls out of the from the

valve cap assemblyplease refer to the Reassembling

The Water Tank Valve Cap procedure later in this

manual.

STEP

FILLING

THE

WATER

CONTAINER

NOTE: USE OF DEMATERIALIZED OR DISTILLED

WATER IS HIGHLY RECOMMENDED.

Insure the unit is unplugged.

Removethe water container with the handle

and

turn

upside

dow

Turn the water facet in

you

sink

mild stream

While depressing the valve in the center of the base,

fill the tank with cool water through the opening.

NOTE: DO NOT FILL THE CONTAINER WITH HOT

WATER.

Release the valve and install water tank

the base.

STEP

OPERATING THE STEAMER

Ensurethe ON/OFF switch is in the OFF position.

Plug thesteamer cord into

normal

electrical

outlet or approved extension cord.

Turn the ON/OFFswitch to the

position.

The switch will light when electricity is

connected.

Steam will be produced from the nozzle in a few

seconds.

CAUTION: DO NOT ALLOW THE CONTAINER TO

BECOME DRY DURING OPERATION, AS THIS WILL

SHORTEN THE LIFE OF THE STEAMER.

STEP 1 - PREPARATION FOR USE

P.6

PRESSING

WITH

STEAM

Grasp the control handle with the

nozzle facing upward. Beginning at

the bottom

the fabric will allow the

steam to rise inside and outside

removing wrinkles. Slowly move the

nozzle from the bottom to the top of

the fabric.

Remove the nozzle from the garment

and smooth the fabric with

your

free

hand.

NOTE:

a. Pressing

will

be easier

there are fewer

creases in the object to be steamed.

b. Shaking out the article prior

steaming

will avoid excess creasing.

c. For towels, handkerchiefs and napkins

peg drape them over a rod or steam

press them

place over towel racks.

Heavier fabrics may require repeated

steaming. Repeat steps

AND

necessary.

With practice you will gain speed and

efficiency. You will soon learn which

fabrics will require multiple steam

applications.

IMPORTANCE

NOTICE

Remove and drain the water container

depressing

the valve at the bottom

the container. (See drawing)

Drain the unit by removing thedrain plug

(located at theside of the main unit

see

P.4

1).

This will allow contents of the

reservoir (main unit) to drain. Tipping the

unit in the direction of the drain plug to

remove any remaining water. Replace the

drain plug.

Using distilled water will eliminate a

residue build up usually found in tap water.

CLEANING

AND

STORING

Turn the

ON/OFF

switch to the

OFF

position and unplug from the power

source.

Wait for the steamer to cool

completely

for at least

minutes.

Remove and drain the water container.

Drain the unit

removing the drain

plug and allowing the contents

the

reservoir to drain.Tip the unit in the direction

of the drain

plug

remove remaining

water. Replace

the

plug.

Remove the steamerhose

and

hanger

rod.

Remove the Water

Tank.

Remove excess water from the reservoir

lifting the unit and pouring. Flush the

reservoir area with fresh water to clean

any residue

from

the water source.

valve

Reattach the hose,hanger rod and water

container and store the unit.

OTHER

IMPORTANT

NOTES

During

operation the steamer hose

may

gurgle

This is a normal result

condensation

collecting inside the hose. Simply lift the

control handle upward until the hose is

extended to its

full

height.

The gurgling will disappear when the

excess moisture inside the hose has had a

chance to drain back into the base.

the steamer stops producing steam

then starts again.

You

may wish to examine the inside of

the reservoir. The

most

common reason

for this effect is the accumulation of

sediment from mineral laden water.

b. Clean the offending sediment from

inside the unit. first following the steps

for cooling and cleaning the unit as

presented previously.

Tabla de contenidos

Otros manuales de Electrodoméstico de cocina de Steamfast

Steamfast

Steamfast MODEL SF-407 Manual de usuario

Steamfast

Steamfast SF-292 Manual de usuario

Steamfast

Steamfast SF-420 Manual de usuario

Steamfast

Steamfast MODEL SF-407 Manual de usuario

Steamfast

Steamfast SF-562 Manual de usuario

Steamfast

Steamfast SF-410 Manual de usuario

Steamfast

Steamfast SF-540 Manual de usuario

Steamfast

Steamfast QuickSteam SF-465 Manual de usuario

Steamfast

Steamfast SF-452 Manual de usuario

Steamfast

Steamfast SF-565 Manual de usuario

Steamfast

Steamfast SF-435W Manual de usuario

Steamfast

Steamfast SF-540 Manual de usuario

Steamfast

Steamfast SF-562 Manual de usuario

Steamfast

Steamfast SF-562 Manual de usuario

Steamfast

Steamfast Salton SF-450 Manual de usuario

Steamfast

Steamfast SF-450 Manual de usuario

Steamfast

Steamfast SF-510 Manual de usuario

Manuales populares de Electrodoméstico de cocina de otras marcas

Tayama

Tayama TYG-35AF Manual de usuario

AEG

AEG 43172V-MN Manual de usuario

REBER

REBER Professional 40 Guía del usuario

North American

North American BB12482G / TR-F-04-B-NCT-1 Manual de usuario

Presto

Presto fountain popper Manual de usuario

Westmark

Westmark 1035 2260 Manual de usuario

Zanussi

Zanussi ZCG64396XA Manual de usuario

HOFFEN

HOFFEN SM-9302M Manual de usuario

Philips

Philips HD3133 Manual de usuario

Ronco

Ronco Beef Jerky Manual de usuario

Hendi

Hendi 470411 Manual de usuario

Livoo

Livoo MEN386 Manual de usuario

Vogue

Vogue D446 Manual de usuario

croydon

croydon WR-10313-700 Manual de usuario

ADE

ADE AUTOMATIC-L Manual de usuario

Chefman

Chefman RJ43-SQ Series Manual de usuario

Vacmaster

Vacmaster VP680 Manual de usuario

Jetmaster

Jetmaster 900HG Manual de usuario