7 8
Like any G-series arm, Lift is only
adjustable with the arm slightly above
horizontal. You’ll need to raise or lower
the sled to nd that sweet spot.
A normal lift setting will allow all THREE
arm sections to move together with a
slight tendency to remain horizontal.
The side-to-side adjustment rotates
the socket block similar to the fore-aft
adjustment on a traditional mount.
However, we must adjust the side-to-side
threads without the rig on board.
Wear the rig and observe which direction
it tends to pull, then dock.
With the X3 held just above horizontal,
you’ll feel the knob unlock. Adjust the X3
lift to support your rig and 2-section arm.
Lift and threads Lift and threads
To make a side-to-side adjustment,
loosen the top knob, make your
adjustment with the lower knob and re-
snug the top.
Test and repeat until the rig is centered.
Remember, these screws lock the
2-section arm socket to the X3 socket
block, so make sure they’re snug.
The fore-aft adjustment uses the pair of
knobs facing forward to rotate the entire
socket block around the pivot screws.
Similar to the side-to-side adjustment,
we’ll have to turn the knobs without the
rig on board.
Wear the rig and decide which direction
you need to adjust the fore-aft knobs,
then dock.
To make a fore-aft adjustment, loosen the
top knob, make your adjustment with the
lower knob and re-snug the top.
Test with the rig on board and repeat if
necessary.
If you run out of adjustment range on X3
fore-aft, reach for your 1/4” Allen wrench
and make adjustments to your 2-section
arm rod-ends.
X
