Thanks a lot for purchasing our LED robohead. Please read this user manual
carefully and follow the instructions to avoid danger or damage to the unit
due to mishandling. Keep this user guide for future reference. If you give the
unit to another user, be sure that he also receives this instruction booklet.
Safety instruction
You have to carefully read the instruction, which includes important
information about the installation, usage and maintenance.
• Unpack and check carefully there is no transportation damage before
using the unit.
• Before operating, ensure that the voltage and frequency of power supply
match the power requirements of the unit as stated in this manual.
• The unit is for indoor use only. Use it only in a dry location. Exposing the
devicetorainormoisturewouldcausetheriskofelectricalshockorre.
• The unit must be installed in a location with adequate ventilation, at least
50 cm from adjacent surfaces. Be sure that no ventilation slots are blocked.
• Disconnect the device from the mains power before any servicing or
maintenance.
• Never sever the power cord’s earth wire of any device. Otherwise a
LIFE THREATENING situation exists!
• Replace fuse/lamp only with the same type. Do not use any other type
of lamp.
• Keepanyammablematerialawayfromtheunitwhileitisoperating.
Otherwiseyouruntheriskofcausingare.
• Usesafetycableswhenxingthisunit.
• In the event of serious operating problem, stop using the unit
immediately. Never try to repair the unit by yourself. Repairs carried out
by unskilled people can lead to damage or malfunction. Please contact
the nearest authorized technical assistance centre. Always use the
same type spare parts.
• There are no user serviceable parts inside the unit. Do not open the
housingorattemptanyrepairsbyyourself.Ifthextureshowsanyvisible
damage or if your unit may require service, please contact your dealer.
• NEVER use the unit under the following conditions:
> In places subject to vibrations or bumps.
> In places with a temperature of over 40 °C or less than 2 °C.
> In places subject to excessive dryness or humidity (ideal conditions
are between 35% and 80%).
