StarTech.com USB2TVTUNER Manual de usuario
USB TV Tuner
USB2TVTUNER Instruction Manual
Actual product may vary from photo
External USB 2.0 TV Tuner with Remote Control
FFCCCCCCoommpplliiaanncceeSSttaatteemmeenntt
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
UUsseeooffTTrraaddeemmaarrkkss,,RReeggiisstteerreeddTTrraaddeemmaarrkkss,,aannddootthheerrPPrrootteecctteeddNNaammeessaannddSSyymmbboollss
This manual may make reference to trademarks, registered trademarks, and other protected names
and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur
these references are for illustrative purposes only and do not represent an endorsement of a
product or service by StarTech.com, or an endorsement of the product(s) to which this manual
applies by the third-party company in question. Regardless of any direct acknowledgement
elsewhere in the body of this document, StarTech.com hereby acknowledges that all trademarks,
registered trademarks, service marks, and other protected names and/or symbols contained in this
manual and related documents are the property of their respective holders.
TTaabblleeooffCCoonntteennttss
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
System Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Windows 2000/XP users . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Application Software Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Windows Vista users . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Application Software Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Connecting the TV Tuner to Your Computer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Using the TV Tuner Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
General Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Encoder Properties . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Color . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
TV Tuner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Using the Infrared Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Accessory Products from StarTech.com . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Warranty Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Instruction Manual
i
IInnttrroodduuccttiioonn
Thank you for purchasing a StarTech.com External USB 2.0 TV Tuner. This product allows you to
watch a satellite or cable TV signal on your computer monitor, and offers timeshifting and video
capture/recording capabilities, as well as a host of other features that can help you turn your PC into
the ultimate multimedia environment. Plus, USB2TVTUNER includes an infrared remote control and
an innovative on-screen remote, providing complete, convenient control of options and features that
will change the way you watch TV.
Features
• Includes an external infrared remote control for easy channel switching
• Intuitive, on-screen menu system for previewing and programming channels, screen captures,
parental channel lockout, and more
• Supports inputs from auxiliary A/V devices such as DVD players, VCRs, and game consoles
• Supports multiple video file output formats and resolutions, and includes VideoWorks video
authoring software
BBeeffoorreeYYoouuBBeeggiinn
System Requirements
• A PC with an available USB 2.0 port
• OS Requirements: Microsoft Windows 2000, XP (32-bit and 64-bit editions), XP Media
Center Edition, Vista (32-bit and 64-bit editions)
• Windows 2000 computers must have a sound card with a “line in” connector
• Optional: CD/DVD-ROM, or other compatible optical drive (for software installation) or
an active Internet connection (software download)
Package Contents
• 1x USB 2.0 TV Tuner
• 1x USB (A-B Male) Cable
• 1x 3.5 mm male-to-male headphone audio cable
• 2x Installation CDs (TV Tuner and VideoWorks)
• 1 x Instruction Manual
Instruction Manual
1
IInnssttaallllaattiioonn
Instruction Manual
2
Warning! Do not connect the USB 2.0 TV Tuner to the computer, prior to installing the
accompanying software package. Please note that the software must be present, in
order for the operating system to properly detect and make use of the USB2TVTUNER.
Application Software Installation
1. With the host computer in a powered state, ensure that the Multimedia Installation Kit CD
(included with USB2TVTUNER) is in your CD/DVD-ROM drive.
2.a) Double-click on My Computer
b) Open the contents of the CD by double-clicking on the icon that represents your CD/DVD-
ROM drive.
c) Open the NetXTV20 folder.
d) Open the AP Software folder.
e) Open the XTV20 folder.
f) Double-click on the Setup.exe file, to launch the installation program.
3. When you are prompted, please choose the appropriate language for installation, and click Next.
4. You will then be notified that XTV2.0 is preparing
to install the necessary software:
Windows 2000/XP users
Please note: Installation of the USB2TVTUNER External USB 2.0 TV Tuner requires that
two separate components be installed - the XTV2.0 Multimedia Application software and
the device driver files. To ensure successful installation and operation, please follow the
necessary steps in sequence, as indicated below.
5. On the screen that follows, you will be asked to
Select the setup type that best suits your needs.
Please select the appropriate location from the list
provided, and click on the Set button.
6. To install the application in the default folder, click on
Next to continue. (
Optional
:
If you wish to install the
application in a location other than that specified by
default, click on the Browse button, select the
desired location for the files to be copied, then click
on the Next button
.)
7. Windows Media Format 9 Series Runtime
Setup will begin. Click on Yes to continue.
8. The Windows Media Format 9 Series Runtime Setup End User License Agreement will
appear. If you agree to the terms of the agreement, click on Yes to continue.
9. You will be notified that Windows Media Format 9 Series Runtime Setup has completed.
Click on OK to continue.
Instruction Manual
3
10. When the Windows Media Tools Setup window appears, click on Yes to continue, if you agree
to the terms of the license agreement.
11. The Windows Media Tools welcome page will
appear. Click Next to continue.
12. At the Installation Options window, select Complete
Installation and click on Next to continue.
13. To install the application in the default folder, click on
Finish.(
Optional
:
If you wish to install the
application in a location other than that specified by
default, click on the Browse button, select the
desired location for the files to be copied, then click
on the Finish button
.)
14. You may be asked if you wish to create a folder
for Windows Media Components. Please
select Yes.
Instruction Manual
4
15. Please wait while Windows Media Tools Setup copies
the necessary files...
16. Once Windows Media Tools Setup has completed,
click on OK to continue.
17. The InstallShield Wizard is now finished installing
the XTV2.0 application on your computer. Please
click on Finish.
18. You will be prompted to restart the computer, for the changes to
take effect. Please select Yes, I want to restart my computer
now and click OK.
Once the computer has rebooted, you can proceed to install
the necessary drivers as detailed in the following section.
Instruction Manual
5
Instruction Manual
6
Driver Installation
1. Ensure the Multimedia Installation Kit CD is present in your CD/DVD-ROM drive.
2.a) Double-click on My Computer
b) Open the contents of the CD by double-clicking on the icon that represents your CD/DVD-
ROM drive.
c) Open the NetXTV20 folder.
d) Open the Driver folder.
e) Double-click on the Setup.exe file, to launch the
installation program. When the Welcome
screen appears, click on Next to continue.
3. Allow the installation program to complete.
Once the InstallShield Wizard is complete,
please click on Finish.
Following this, you will be asked if you wish to
restart your computer. Please select Yes, I
want to restart my computer now, and click
on OK. Once the computer has fully rebooted,
please advance to the steps outlined in the
section entitled Connecting the TV Tuner to
Your Computer.
Instruction Manual
7
Application Software Installation
1. With the host computer in a powered state, ensure that the Multimedia Installation Kit CD
(included with USB2TVTUNER) is in your CD/DVD-ROM drive.
2.a) Double-click on Computer (on the desktop)
b) Open the contents of the CD by double-clicking on the icon that represents your CD/DVD-
ROM drive.
c) Open the NetXTV20 folder.
d) Open the AP Software folder.
e) Open the XTV20 folder.
f) Double-click on the Setup.exe file, to launch the installation program.
3. You will be asked to select the language under which the software will operate. Please make the
appropriate selection, and click OK.
Windows Vista users
4. Windows Vista will then prepare to install
the necessary software, following which you
will be able to select your geographic location.
Please make the appropriate selection, and click
on Next.
5. You will then be given the option to specify the
location into which the software will be installed.
To install in the default location, please click on
Next.
Optional
: If you wish to install the software in an
alternate location, please click on Browse and specify
the location of your choice, and click Next to continue.
Otros manuales para USB2TVTUNER
1
Tabla de contenidos
Otros manuales de Sintonizador de TV de StarTech.com
