StarTech.com S2510U33RUSM Manual de usuario

Manual Revision: 08/07/2013

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

S2510U33RUSM

SATA USM™ Bay with USB 3.0 SSD/HDD Enclosure

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Product Diagram ....................................................................................1

Front View .................................................................................................................................................... 1

Rear View...................................................................................................................................................... 1

Introduction............................................................................................2

Packaging Contents ................................................................................................................................. 2

System Requirements.............................................................................................................................. 2

Installation ..............................................................................................3

Hardware Installation .............................................................................................................................. 3

Hard Drive Installation............................................................................................................................. 4

How to Use .................................................................................................................................................. 6

Initializing the Hard Drive ...................................................................................................................... 7

Technical Support ..................................................................................8

Warranty Information............................................................................8

Instruction Manual

Product Diagram

Front View

Rear View

Drive Eject

Button

Drive

Slot

SATA Data

Port

SATA Power

Port

Optional LP4

Power Port

Instruction Manual

Introduction

Packaging Contents

• 1 x USM 5.25” Installation Bay

• 1 x 2.5” HDD Enclosure

• 1 x USM to USB 3.0 interface adapter

• 1 x USB Micro USB Cable

• 1 x Installation Screw Kit

• 1 x Instruction Manual

System Requirements

• 1 x Computer System with SATA connectivity and an available 5.25”bay

• 1 x SATA Data Cable

• 1 x Available SATA or LP4 Power Connection

• 1 x 2.5” SATA Hard Drive

WARNING! Hard drives and storage docks require careful handling, especially when

being transported. If you are not careful with your hard disk, lost data may result.

Always handle your hard drive and storage device with caution. Be sure that you

are properly grounded by wearing an anti-static strap when handling computer

components or discharge yourself of any static electricity build-up by touching a large

grounded metal surface (such as the computer case) for several seconds.

Instruction Manual

3. Hold the S2510U33RUSM into place, and x the included 8 screws (4 per side)

through the installation holes on the 5.25”slot, into the side installation holes on the

S2510U33RUSM.

4. Connect a SATA Data cable from your computer motherboard to the SATA DATA port

on the back of the S2510U33RUSM.

5. Connect either a SATA Power Cable or an LP4 Power Cable from your computer

power supply, to the SATA Power port or LP4 Power Port respectively, depending on

your power cable availability.

Installation

Tray Installation

1. Ensure your computer system is powered down, and the power cable has been

disconnected from the Power Supply.

2. Open your computer case (refer to the computer user manual for details), and

place the USM 5.25 Installation Bay into an available 5.25” slot, lining up the side

installation holes on the S2510U33RUSM (pictured below), with installation holes on

the 5.25” slot inside the computer.

Instruction Manual

4. Install the tray back into the housing and replace the back plate ensuring that the

plate is aligned to the SATA connector.

5. Fix the two screws on the SATA plate back into place.

Interfacing with S2510U33RUSM 5.25” Installation Bay

Mount Drive

With the USB 3.0 to USM adapter removed from the S2510U33USM USM Enclosure,

gently slide the USM Enclosure Drive into the slot provided by the 5.25” USM drive tray

(S2510U33RUSM), until you feel full resistance.

Remove Drive

Press the drive eject button on the 5.25” USM drive tray (S2510U33RUSM). The USM

Enclosure will slide away from the installation bay slightly. Grasp the Enclosure with

your ngers and slide the drive the rest of the way out.

NOTE: It is important to eject or unmount the hard drive from your computer system

before physically removing the drive. See How to Use - Disconnecting the Hard Drive

section for instructions.

2. Slide the inner tray forwards out of the housing.

3. To install the hard drive start by placing one side into the tray then lower the other

size into place until the drive snaps into place.

Drive Installation

1. With the USB 3.0 to USM adapter removed from the S2510U33USM USM Enclosure,

remove the two screws on either side of the USM port, to remove the SATA plate.

Instruction Manual

Interfacing with USB Controller

1. Connect the USM to USB 3.0 interface adapter to the enclosure through the USM

port.

2. Connect the USB 3.0 cable from the USB port on the adapter to an available USB 3.0

port on your computer system.

How to Use

Connecting the Hard Drive

Once the enclosure has been attached to a computer, the drivers will install

automatically, and the inserted drive will be accessible as though it were installed

within the system.

Prior to using the drive, it will need to be formatted according to your operating

system requirements. Refer to Initializing the Hard Drive

Disconnecting the Hard Drive

Windows

1. Select the “Safely remove Hardware and Eject Media” icon, located in the task bar.

2. Select the Mass Storage Device from the list that appears.

3. Wait for the message indicating that it is now safe to remove the device.

NOTE: Removing the connected drive prior to receiving notication that it is safe

to do so, could result in losing or corrupting data stored on the drive. Once the Safe

to Remove Hardware message appears, please disconnect the enclosure from the

computer by removing the USB connection.

Mac OS X

To safely disconnect the attached drive from the host computer, close any windows

listing the contents of the removable drive. Once all windows are closed, click on the

USB storage icon on the desktop, and drag it to the Trash Can icon on the desktop.

Allow 5 seconds before physically removing the enclosure/drive from the computer.

Instruction Manual

2. A dialog window should automatically appear, asking you to initialize the drive.

Depending on the version of Windows, it will give you the option of either creating

an “MBR” or“GPT” disk. GPT (GUID partition) is required for drives larger than 2TB but

is not compatible with some older operating systems, while MBR is supported by

newer and older operating systems.

3. Once initialized, locate the Disk that says it is “Unallocated” (check the listed hard

drive capacity to conrm it’s the correct hard drive) and then right-click in the

section that says “Unallocated” and select “New Partition”.

Initializing the Hard Drive

1. If the SATA Hard Drive is blank it may need to be initialized and formatted before

use. From the main Windows desktop, right-click on “My Computer” (“Computer” in

Vista/ 7 / 8), then select Manage. In the new Computer Management window, select

Disk Management from the left window panel.

4. Several on screen prompts will follow walking you through the steps to create the

partition. Follow these prompts to complete partition creation.

Instruction Manual

Technical Support

StarTech.com’s lifetime technical support is an integral part of our commitment to

provide industry-leading solutions. If you ever need help with your product, visit

www.startech.com/support and access our comprehensive selection of online tools,

documentation, and downloads.

For the latest drivers/software, please visit www.startech.com/downloads

Warranty Information

This product is backed by a two year warranty.

In addition, StarTech.com warrants its products against defects in materials

and workmanship for the periods noted, following the initial date of purchase.

During this period, the products may be returned for repair, or replacement with

equivalent products at our discretion. The warranty covers parts and labor costs only.

StarTech.com does not warrant its products from defects or damages arising from

misuse, abuse, alteration, or normal wear and tear.

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their

ocers, directors, employees or agents) for any damages (whether direct or indirect,

special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,

or any pecuniary loss, arising out of or related to the use of the product exceed the

actual price paid for the product. Some states do not allow the exclusion or limitation

of incidental or consequential damages. If such laws apply, the limitations or exclusions

contained in this statement may not apply to you.

Otros manuales para S2510U33RUSM

Tabla de contenidos

Otros manuales de Accesorios de computadora de StarTech.com

StarTech.com

StarTech.com CB1PECP Manual de usuario

StarTech.com

StarTech.com ATXSILENT Manual

StarTech.com

StarTech.com EC400USB Manual de usuario

StarTech.com

StarTech.com TB3DOCK2DPPD Manual de usuario

StarTech.com

StarTech.com ATX8400PRO2B Manual de usuario

StarTech.com

StarTech.com USB3VDOCK4DP Manual de usuario

StarTech.com

StarTech.com DK30A2DH Manual de usuario

StarTech.com

StarTech.com SECTBLTPOS Manual de usuario

StarTech.com

StarTech.com MST30C2DPPD Manual de usuario

StarTech.com

StarTech.com ATX5250PRO Manual

StarTech.com

StarTech.com PCI220USB Manual de usuario

StarTech.com

StarTech.com USB3SDOCKDD Manual de usuario

StarTech.com

StarTech.com KEYBOARD-TRAY-CLAMP1 Manual de usuario

StarTech.com

StarTech.com ST7300USB3B Manual de usuario

StarTech.com

StarTech.com S3510WMU33T Manual del sistema

StarTech.com

StarTech.com MST30C2HHPD Manual de usuario

StarTech.com

StarTech.com STNDTBLT1A5T Manual de usuario

StarTech.com

StarTech.com DK30CH2DPPDU Manual de usuario

StarTech.com

StarTech.com SATERASER4 Manual de usuario

StarTech.com

StarTech.com CMPNL2U Series Manual de usuario

StarTech.com

StarTech.com SAT3520U3SR Manual de usuario

StarTech.com

StarTech.com MST30C2DPPD Manual de usuario

StarTech.com

StarTech.com ECESAT32 Manual de usuario

StarTech.com

StarTech.com MST30C2HDPPD Manual de usuario

Manuales populares de Accesorios de computadora de otras marcas

Motorola

Motorola ATRIX Manual de usuario

HP USB Media Docking Station Manual de usuario

Cherry

Cherry B.UNLIMITED 3.0 Manual de usuario

Logitech

Logitech IO2 Manual de usuario

ARM

ARM DSTREAM-ST Manual de usuario

Bartec

Bartec TC 7 Series Manual de usuario

Philips

Philips SPC3540 Manual de usuario

Logitech

Logitech mk220 Manual de usuario

SilverStone

SilverStone LC02 Manual de usuario

Flexispot

Flexispot ML2B Manual de usuario

Hamlet

Hamlet UNIVERSAL COVER 101 KBT2 Manual de usuario

Adam Equipment

Adam Equipment RS-485 Manual de usuario

Vivo

Vivo MOUNT-KB05-4DW Manual de usuario

Kvaser

Kvaser Memorator Professional Manual de usuario

DRC

DRC D-Imaging Manual de usuario

Sven

Sven Base 305 сombo Manual de usuario

Hama

Hama 108310 Manual de usuario

SpeechWare

SpeechWare FlexyMike FMK03 Manual de usuario