Programming the Remote,( Continued )
7
C. Standard Set-Up:
Step 1:
Turn on the device ( TV, VCR, Cable Box, Satellite Receiver, etc. ) that you
wish to operate.
Step 2:
On the Star Light universal remote control, press the corresponding
DEVICE button (TV, VCR,CATV, SAT,Audio,or Aux) and the MUTE
button simultaneously.
Note: SET will appear in the LCD.
Step 3: Locate the three digit code number for your brand of equipment from the
code lists found on pp. (15 31). Example: TV codes-Sony 001,003,etc.
Note: If the brand list contains more than one code number,
select the first code listed.
Step 4: Point the remote control at the devise turned on in Step1and press in the
three digit code number selected in Step 3.
Note: SET # # # will appear in the LCD.
Your device will turn off when the correct code has been selected. If the
device fails to turn off, go back to Step 3 and select the next three digit
code for your equipment, and press in the code number.
Note: Repeat the above step until the device turns off. When
the device turns off proceed to Step 5.
Step 5: Press the DEVICE button (TV, VCR, CATV, SAT, Audio, Aux) on the
remote control to store the three digit code that turned off your equipment.
Note: PASS will flash in the LCD indicating that the code has
been stored.
Step 6: Test the remote control functions with the code just stored.
Example: Power, Channel Up, Volume Up, etc. If any of the buttons do not
perform as they should, please repeat from Step 2using the next three digit
code until the right code is found.
Step 7: To program other devices into the corresponding Device button of the
remote control, repeat the above steps with the respective devices and Device buttons.
