-7-
Custom Wiring Setup
Use the diagram below to record the custom functions that you have programmed.
Please Note: The RED wire must be connected to
+12VDC for any of the functions to work.
ORANGE w/RED -___________________
WHITE w/BROWN - __________________
GREEN w/YELLOW - ________________
RED w/GREEN - Pattern or Phase Select
(See Pattern Programming)
BLACK - Ground
YELLOW - _________________________
RED - Power
PINK - ____________________________
Wiring unction Programming
Desired Function Stick Display
(Ad anced Programming CONT’D)
Custom Wire Programming and Priority Modification
Higher priority wires will override the patterns on any lower priority wires for the
heads that are enabled.
IG EST PRIORITY LOWEST PRIORITY
Pink > White w/Brown > Green w/Yellow > Orange w/Red > Yellow
If none of the 4 Wiring setups fits your needs (functions or priority of functions), you
can custom program each of the five input wires (Pink, White w/Brown, Green w/
Yellow, Orange w/Red, or Yellow) for any function (* Note: The Pink wire cannot be
reprogra ed for Flashing). Refer to the chart below and proceed as follows:
1. Connect the Red wire to power and the Black wire to Ground.
2. Connect the function wire that you want to reprogram to +12VDC.
3. Hold the Pattern Select wire to +12VDC until the unit flashes two times (it will flash
once, then twice - ~6 seconds), then release it, placing the light into Custo Wire
Progra ing Mode.
4. Reviewing the chart below, touch and release the Pattern Select wire to GROUND
(or Battery Neg) to scroll through the various options for each head. Use the
display of the heads of the lightstick to identify which function that function wire is
programmed for.
5. Repeat steps 2-4 for any other
function wires desired.
6. Save your programming by
holding the Pattern Select
wire to +12VDC until the
unit flashes once (~3
seconds), then releasing it.
