Stanley OmniLock Manual de instrucciones
CREDITS/COPYRIGHT
Copyright © 2009 Stanley Security Solutions, Inc. and Stanley Logistics, Inc. All rights
reserved. Printed in the United States of America.
Information in this document is subject to change without notice and does not
represent a commitment on the part of Stanley Security Solutions, Inc. The software
described in this document are furnished under a license agreement or nondisclosure
agreement.
This publication is intended to be an accurate description and set of instructions
pertaining to its subject matter. However, as with any publication of this complexity,
errors or omissions are possible. Please call your BEST®distributor or Stanley Security
Solutions, Inc., Best Access Systems at (317) 849-2250 if you see any errors or have any
questions. No part of this manual and/or databases may be reproduced or transmitted
in any form or by any means, electronic or mechanical, including photocopying,
recording, or information storage and retrieval systems, for any purpose, without the
express written permission of Stanley Security Solutions, Inc.
This document is distributed as is, without warranty of any kind, either express or
implied, respecting the contents of this book, including but not limited to implied
warranties for the publication’s quality, performance, merchantability, or fitness for any
particular purpose. Neither Stanley Security Solutions, Inc., nor its dealers or
distributors shall be liable to the user or any other person or entity with respect to any
liability, loss, or damage caused or alleged to be caused directly or indirectly by this
publication.
Sargent is a registered trademark of Sargent Manufacturing Co.
TORX is a registered trademark of the Camcar Division of Textron.
Von Duprin is a registered trademark of Von Duprin, Inc.
Written and designed by Stanley Security Solutions, Inc. and Avalon Group, Inc.,
Indianapolis, Indiana.
T83313 Rev – ER7991-6 November 2009
Stanley OMNILOCK Illustrated Parts Catalog iii
CONTENTS
FIGURES 1–VII
GETTING STARTED 1–1
Introduction 1–1
Product overview 1–3
Mortise lock overview 1–3
Cylindrical lock overview 1–4
Wall mount system overview 1–5
Exit hardware trim overview 1–6
Related service manuals 1–7
Technical support 1–7
Support services 1–7
Telephone technical support 1–7
STANDARD ESCUTCHEON ASSEMBLIES 2–1
Keypad reader escutcheon assembly 2–2
Magnetic stripe reader 2–5
Proximity reader 2–8
Dual validation reader (keypad and magnetic stripe) 2–11
Dual validation reader (keypad and proximity) 2–14
Weatherized escutcheon components 2–17
Extreme weatherized escutcheon components 2–18
Contents
iv Stanley OMNILOCK Illustrated Parts Catalog
MORTISE COMPONENTS 3–1
Outside trim components 3–2
Inside trim components 3–3
Spindles 3–4
Mortise cases by function and option 3–5
Mortise case faceplates 3–6
Strike boxes and strike plates 3–7
Cylinder components 3–8
CYLINDRICAL COMPONENTS 4–1
Standard trim components 4–2
Standard levers 4–3
Cylindrical chassis 4–4
Latches 4–5
Strike boxes and strike plates 4–6
EXIT DEVICE TRIM COMPONENTS 5–1
Keypad reader escutcheon assembly 5–2
Magnetic stripe reader 5–4
Proximity reader 5–6
Dual validation reader (keypad and magnetic stripe) 5–8
Dual validation reader (keypad and proximity) 5–10
Weatherized escutcheon components 5–12
Adapter plate kits 5–13
Tailpiece kits 5–14
Outside levers 5–15
Other components 5–16
WALL MOUNT SYSTEM COMPONENTS 6–1
Keypad reader escutcheon assembly 6–2
Dual validation reader (keypad and magnetic stripe) 6–4
Dual validation reader (keypad and proximity) 6–6
Weatherized components 6–8
Extreme weatherized escutcheon components 6–9
5E cylinder components 6–11
Contents
Stanley OMNILOCK Illustrated Parts Catalog v
OTHER COMPONENTS 7–1
Programming devices, readers, and access cards 7–2
2000 Series management software 7–2
WAMS management software 7–2
Card readers and encoders 7–2
Wireless components 7–3
Single door controller 7–3
Portal gateway 7–3
Power-over-ethernet devices 7–4
Transformer 7–4
Modem 7–5
Antenna kits 7–6
Wireless conversion kit 7–7
Battery packs 7–7
Tools 7–7
Site survey kit and beacons 7–8
GLOSSARY A–1
Contents
vi Stanley OMNILOCK Illustrated Parts Catalog
Stanley OMNILOCK Illustrated Parts Catalog vii
FIGURES
GETTING STARTED
Mortise lock overview diagram 1–3
Cylindrical lock overview diagram 1–4
Wall mount system overview diagram 1–5
Exit hardware trim overview diagram 1–6
STANDARD ESCUTCHEON ASSEMBLIES
Keypad reader escutcheon assembly (WAMS mortise shown) 2–2
Magnetic stripe reader escutcheon assembly (WAMS mortise shown) 2–5
Proximity reader escutcheon assembly (WAMS mortise shown) 2–8
Dual validation reader (keypad and magnetic stripe) escutcheon
assembly (WAMS mortise shown) 2–11
Dual validation reader-keypad and proximity escutcheon assembly
(WAMS mortise shown) 2–14
Weatherized escutcheon components 2–17
Extreme weatherized escutcheon components 2–18
MORTISE COMPONENTS
Outside mortise trim 3–2
Inside mortise trim 3–3
Spindles 3–4
Mortise case assembly 3–5
Mortise case faceplates 3–6
Mortise strike boxes and strike plates 3–7
Mortise cylinder components 3–8
Figures
viii Stanley OMNILOCK Illustrated Parts Catalog
CYLINDRICAL COMPONENTS
Standard trim exploded view 4–2
Standard cylindrical levers 4–3
Cylindrical chassis 4–4
Cylindrical latches 4–5
Cylindrical strike boxes and strike plates 4–6
EXIT DEVICE TRIM COMPONENTS
Keypad reader escutcheon assembly (WAMS shown) 5–2
Magnetic stripe reader escutcheon assembly (WAMS shown) 5–4
Proximity reader escutcheon assembly (WAMS shown) 5–6
Dual validation reader (keypad and magnetic stripe) escutcheon
assembly (WAMS shown) 5–8
Dual validation reader (keypad and proximity) escutcheon assembly
(WAMS shown) 5–10
Weatherized escutcheon components 5–12
Adapter plates for exit device hardware trim 5–13
Tailpiece kit for exit device hardware trim 5–14
Outside levers for exit device hardware trim 5–15
Other components for exit device hardware trim 5–16
WALL MOUNT SYSTEM COMPONENTS
Keypad reader escutcheon assembly (500 series shown) 6–2
Dual validation reader (keypad and magnetic stripe) escutcheon
assembly (WAMS shown) 6–4
Dual validation reader (keypad and proximity) escutcheon assembly
(WAMS shown) 6–6
Weatherized components 6–8
Extreme weatherized escutcheon components 6–9
5E cylinder components for wall mount systems 6–11
Figures
Stanley OMNILOCK Illustrated Parts Catalog ix
OTHER COMPONENTS
Card encoders 7–2
Single door controller 7–3
Portal gateway 7–3
Power-over-ethernet devices 7–4
Transformer 7–4
Modem 7–5
Antenna kits 7–6
Battery pack 7–7
Tools 7–7
Site survey kit and beacons components 7–8
GLOSSARY
Figures
xStanley OMNILOCK Illustrated Parts Catalog
Tabla de contenidos
Otros manuales de Cerrar de Stanley
Stanley
Stanley Omnilock 9KOM Manual de usuario
Stanley
Stanley Omnilock 45HOM Manual de usuario
Stanley
Stanley Shelter 9KX Manual de usuario
Stanley
Stanley QEL 200 Manual de usuario
Stanley
Stanley 83KM-93KM Manual de usuario
Stanley
Stanley Omnilock QAXOM Manual de usuario
Stanley
Stanley QCI 200 Manual de usuario
Stanley
Stanley BEST ACCESS SYSTEMS 45HM Series Manual de usuario
Stanley
Stanley Omnilock OM500 Manual de usuario
Stanley
Stanley 9K Series Manual de usuario
Stanley
Stanley BEST 45HG Manual de usuario
Stanley
Stanley QEL 200 Manual de usuario
Stanley
Stanley Omnilock 45HOM Manual de usuario
Stanley
Stanley QET320 Manual de usuario
Stanley
Stanley 3 Series Manual de usuario
Stanley
Stanley 203820 Manual de usuario
Stanley
Stanley GS3-MT PIN Manual de usuario
Stanley
Stanley QEL 200 Manual de usuario
Stanley
Stanley Sargent and Greenleaf 6730 Manual de usuario
