Stairville SF-1500 Manual de usuario
www.thomann.de 1
Owner‘s Manual
FOG MACHINE
SF-1500
FOG MACHINE • SF-1500
2
www.thomann.de
Thank you for choosing one of our fog machines. Please read this user
manual carefully and follow the instructions to avoid danger or damage to the
unit due to mishandling. Keep this user guide for future reference. If you give
the unit to another user, be sure that he also receives this instruction booklet.
Safety instruction
You have to carefully read the instruction, which includes important
information about the installation, usage and maintenance, BEFORE
operating this device.
XThis device is exclusively meant to be used as a show effect device
within the limits given in this manual. Using it in any other way you risk
electric shock and warranty will become void.
XNever sever or manipulate the power cord or the plug. If a power cord is
provided with an earth lead, this is mandatory to ensure safe operation!
Otherwise a LIFE THREATENING situation exists!
XUnpack and check carefully there is no transportation damage before
using the unit. Never put a damaged device into operation.
XBefore operating, ensure that the voltage and frequency of power supply
match the power requirements of the unit as stated in this manual.
XThe unit is for indoor use only. Use it only in a dry location. Exposing the
device to rain or moisture would cause the risk of electrical shock or re.
XDO NOT let any liquids or objects enter the unit. Should any liquid
be spilled on the unit, DISCONNECT the power supply to the unit
immediately and contact the service company.
XThe unit must only be installed in a location with adequate ventilation.
Be sure that no ventilation slots are blocked. In order to guarantee
adequate ventilation, allow a free air space of at least 20 cm around the
sides and top of the unit.
XDisconnect the device from the mains power before any servicing or
maintenance like relling fog uid.
XNotice regarding power disconnection:
To disconnect the device from the power source the power plug must
be removed from the power socket. For this reason the device must
be placed in a position where a constant unobstructed access to the
power socket is assured, thus in an emergency situation you are able
to immediately pull out the power plug. To eliminate the risk of re you
must completely disconnect the power plug from the power socket after
the device has been used.
FOG MACHINE • SF-1500
www.thomann.de 3
XAlways grasp the power cord by the plug. Do not pull on the cord itself
and never touch the power cord with wet hands as this could result in
a short circuit or an electrical shock. Do not place the device, speaker
cabinets or anything else on the power cord and make sure that it does
not become clamped. Place the power cord in a position where it can
not be trod on. A damaged power cord can cause a re or an electrical
shock. Check the power cord from time to time. Should it become
damaged contact our customer service centre to have it replaced.
XYou have to ensure, that the power cord never becomes wet during
operation.
XBefore a storm and/or a thunderstorm with a risk of lightning, disconnect
the device from the mains power supply.
XUnder no circumstances may you open the device housing. Should you
do so your safety would not be assured and the warranty will become
void. There are no operational components whatsoever inside, only
dangerous voltages that can give you a deadly shock!
XNEVER use the unit under the following conditions:
> In places subject to vibrations or bumps.
> In places with a temperature of over 45 °C or less than 2 °C.
> In places subject to excessive dryness or humidity (ideal conditions
are between 35% and 80%).
XWhatever installation method you choose, do not allow the unit to have
more than a 15 degree angle of inclination.
XNever submerse the device in water or any other liquid. Only wipe it
with a slightly damp cloth.
XFog machine output is very hot, as well as the nozzle during operation.
Avoid coming within 60 cm of the output nozzle during operation - Risk
of burns! Never touch the unit when it‘s hot!
XNever operate the device near ames, ammable, explosive materials,
or hot surfaces. Otherwise you run the risk of causing a re. Never aim
the output nozzle at open ames, people of animals.
XNever leave this device running unattended.
XNever drink fog machine liquid. If it is ingested, call a doctor
immediately. If fog machine liquid comes in contact with skin or eyes,
rinse thoroughly with water.
XNever add ammable liquids of any kind (oil, gas, perfume) to the fog
liquid. Pay attention to all warning labels and instructions printed on the
exterior of your fog machine.
XAlways monitor tank uid level during operation. The fog machine can
suffer damage when run without uid. If the machine does not function
FOG MACHINE • SF-1500
4
www.thomann.de
after having been run without uid, please contact your fog machine
dealer for service.
XThis appliance must not be used by individuals (including children) with
restricted physical, physiological or intellectual abilities or deciencies in
experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how
the appliance is to be used.
XKeep children away from the device and power cord! Children
frequently underestimate the dangers of electrical devices. Also keep
the plastic packaging well away from small children. There is a risk of
suffocation!
XIn the event of serious operating problems, stop using the unit
immediately. Never try to dismantle, repair or modify the unit by
yourself. Otherwise warranty becomes void. Repairs carried out by
unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance centre.
Features
Fog machine for operation on large stages, re practice, etc.
Incl. multifunction cable remote control with LCD
Tank capacity: 6 l
Warm-up time: approx. 15 min.
Spraying distance: 8 - 10 m
Setup & operation
XRemove all packing materials from shipping box, check that all foam
and plastic padding is removed, especially in the nozzle area.
XBefore connecting this device to the mains power, you need to ll in fog
liquid.
XPlace the fog machine on a at surface and remove the liquid tank cap.
XPour high quality fog water-based liquid into the liquid tank, being
careful not to exceed the maximum uid level. DO NOT OVERFILL.
Use only our fog machine liquid or other dealer-recommended high-
quality fog uid. Any other types of uid can damage the unit. When the
container is full, place the cap back on the liquid tank and tighten.
XFirmly attach the remote control cable to the 3-pin XLR socket for DMX
signal input on the rear of the machine.
FOG MACHINE • SF-1500
www.thomann.de 5
XPlug the power cord into a properly wired and grounded electrical outlet.
Turn the power switch on rear panel of unit into position “ON”. Now the
machine starts to warm-up. Warm-up is complete when the LCD on the
remote unit shows “READY”.
XThe fog machine is controlled via the remote control. Please refer to the
section titled “Remote control operation” for detailed instruction on the
various functions available. To emit fog, press the MANUAL button on
the remote for the desired length of time.
XAfter extended fog output the unit will need some time to re-heat. During
that period the device can not output fog.
XThe remote unit’s LCD shows the readiness for use.
XBecause of the high operating temperature of fog machines it is
advisable to use this device in well vented areas only. Never block any
ventilation holes. After operation let the device cool down before you
touch or move it. This will increase safety and the unit‘s life span.
Remote control operation
The unit comes with a 10 meter wired multifunction remote controller
with 5-pin XLR connector. Its intuitive LCD-enhanced interface provides
manual and automatic control, as well as DMX address designation.
Set up DMX channels
Press the “FUNCTION” key until the LCD shows “DMX512 ADD***”. Then
set up the desired DMX channel by pressing “↑” key to increase the DMX
channel (512 = max.). Press “↓” key to decrease DMX channel (0 = min.).
For example, when setting up DMX channel as 111, the LCD will show
“DMX512 ADD111”.
Connect DMX signal source to the fog machine
Use a DMX 512 controller to control this unit, and connect the DMX signal
source to “DMX IN” connector on the rear panel of the fog machine. The
fog machine will enter DMX receiving status, the LCD shows “DMX512
ADD***”. At that time, the device receives DMX signal according to the
previously set up DMX channels. And you also can re-set the DMX
channel as follows:
FOG MACHINE • SF-1500
6
www.thomann.de
Functions of DMX channels
Each unit occupies 4 DMX channels as follows:
XChannel 1: for output on/off,
XChannel 2: for output 0% to 100%,
XChannel 3: for interval time (1s to 200s),
XChannel 4: for spraying time per output (1s to 200s).
The exact DMX functions are listed below:
A When the rst channel data is less than 5%, output is OFF and other
channels have no functions.
B When the rst channel data ranges from 5% to 50%, output is ON,
push channel 2 to adjust the output intensity from 0% to 100%.
Channels 3 & 4 have no functions.
C When the rst channel data ranges from 51% to 95%, push channel 2
to adjust the output intensity. And push channel 3 to control the interval
time between 2 sprayings (max: 200s, min: 1s), push channel 4 to
control the spraying time (max: 200s, min: 1s). The maximum spraying
time of 200s is available only when the output intensity is around 30%.
D When the rst channel data ranges from 95% to 100%, the output is
100%.
Cleaning
After every 40 hours of continuous operation, we recommended to run
our Stairville fog machine cleaning uid through the system to prevent the
accumulation of particulate matter in the heating element. Please follow
these guidelines:
1. While the unit is unplugged and cooled down, unscrew the nozzle at
the very front of the unit and clean out debris with vinegar and a pipe
cleaner, making sure that the hole is free of clogs.
2. Empty all fog uid from the machine. Add Stairville fog machine
cleaning uid to the tank. Plug the unit in and let it warm up.
3. Run the unit in a well-ventilated area, until the tank is empty.
4. Replace the nozzle.
5. Cleaning is now completed, rell with fog liquid.
All fog machines are prone to clogging due to the thick consistency of fog
uid and the high temperature at which it vaporizes. However, a properly
maintained fog machine should provide years of reliable use.
FOG MACHINE • SF-1500
www.thomann.de 7
Maintenance and service
XDo not allow the fog liquid to become contaminated. Always replace
the caps on the fog liquid container and the fog machine liquid tank
immediately after lling.
XAll maintenance and service operation inside the unit must be carried
out by a qualied technician only.
XEmpty all fog uid from the machine before transporting the device.
Troubleshooting
If you experience low output, pump noise or no output at all, unplug the unit
immediately. Check the uid level, the external fuse, remote connection,
and power from the power socket by connecting another suitable device
to that power socket. If all appears to be OK, plug the unit in again. If fog
does not come out after holding the remote button down for 30 seconds,
check the hose attached to the tank to make sure there is uid going
through the hose.
If our tips could not solve your problem, disconnect the device from
power supply and please contact our service department. Find contact
information on our website www.thomann.de.
Specification
Rating Voltage: 230 V~/50 Hz
Power: 1500 W
Fog output: 560 m³/min.
Fuse: 10 A/250 V
Tank capacity: 6 litre
Dimensions: 620 x 300 x 210 mm
Weight: approx. 15 kg
As we continuously strive to improve our products, all specications and
appearance are subject to change without prior notice.
Disposal
Do not dispose of the device at the end of his operating life in your
normal domestic waste. This device is subject to the European
Guidelines 2002/96/EC.
XHave the product disposed of by a professional disposal company of by
your communal disposal facility.
XObserve the currently applicable regulations. In case of doubt contact
your disposal facility.
XDispose of packaging materials in an environmentally responsible
manner.
© 2011 • Musikhaus Thomann e. K. • Treppendorf 30 • 96138 Burgebrach • Germany • www.thomann.de
Otros manuales para SF-1500
1
Tabla de contenidos
Otros manuales de Máquina de niebla de Stairville
Stairville
Stairville AF-150 DMX Manual de usuario
Stairville
Stairville SH-150 Manual de usuario
Stairville
Stairville SF-3000 Manual de usuario
Stairville
Stairville AF-150 DMX Manual de usuario
Stairville
Stairville SD-300 Manual de usuario
Stairville
Stairville SD-300 Manual de usuario
Stairville
Stairville SF-1000 MKII Manual de usuario
Stairville
Stairville AF-250 DMX Manual de usuario
Stairville
Stairville WGF-2000 Manual de usuario
Stairville
Stairville HF-900 Haze Fogger Manual de usuario
Manuales populares de Máquina de niebla de otras marcas
Antari
Antari ICE Manual de usuario
Boost
Boost BOOST-FOG400LED-BK Manual de usuario
Home Accents Holiday
Home Accents Holiday FM1000-ASH Manual de usuario
EuroLite
EuroLite ZEITGEIST FOG-1200 Manual de usuario
Dyna-Fog
Dyna-Fog CYCLONE ULTRA 2734 Manual de usuario
PROEL
PROEL DRAGO HEAVY PLFD150HY Manual de usuario
