Stahls WEEDING TABLE Manual de servicio
Installation Instructions
& Manual
WEEDING TABLE
STAHLS‘ Europe GmbH • Dieselstraße 62 • D-66763 Dillingen • Tel. +49 (0)6831/9733-0 • www.stahls.eu
Stand 130418
Installation Instructions
Step 1
Carefully unbox your Weeding Table
and place it on a secure surface.
Step 2
Using the four (4) bolts and nuts provided,
attach the material hold down bracket to
the table.
Step 3
Secure the plug to the weeding table and
plug into a 240 V power outlet.
Step 4
Turn on the Weeding Table by the
power rocker switch located on the left
side of the table. Select the temperature.
Low - approx. 40°C
Medium - approx. 48°C
High - approx. 54 °C
The temperature light will turn GREEN
when proper temperature is reached.
Manual
Step 1
Adjust your Weeding Table to one of the
3 elevated heights, by lifting the outside
edge of the table and tilting. Be sure the
crossbar is secure before releasing.
Step 2
Secure medio to the Weeding Table
using the material hold down bracket or
simply place material on top of the table.
Step 3
The Weeding Table comes equipped
with a storage compartment on the front
of the unit
Step 4
The Weeding Table also has a ledge
for holding your STAHLS‘ EZ-Weeder®.
Otros manuales de Herramientas eléctricas de Stahls
Stahls
Stahls Hotronix MAXX CAP Manual de usuario
Stahls
Stahls Hotronix Air Fusion Manual de usuario
Stahls
Stahls Hotronix Manual de usuario
Stahls
Stahls Hotronix Air Fusion Manual de usuario
Stahls
Stahls A2Z HEAT PRESS Manual de usuario
Stahls
Stahls Hot Berry Manual de usuario
Stahls
Stahls Hotronix Air Fusion Manual de usuario
Stahls
Stahls A2Z HEAT PRESS Manual de usuario
Stahls
Stahls Hotronix Fusion XF Manual de lista de piezas
Stahls
Stahls HOTRONIX AIR FUSION IQ Manual de usuario
