REAR PANEL
RE-VOLT 12 & 15:
1- MIC VOLUME: Controls the volume of inputs 2 & 3.
2- Dual XLR /Phone jack input: The XLR connects to a low impedance microphone,
the phone jack connects to a low impedance microphone or low signal high impedance source
such as a guitar.
3- Phone jack input: connects to a low impedance microphone or low signal high impedance
source such as a guitar
4- REVERB: Controls the amount of REVERB that is added on the signals of inputs 2 & 3
5- AUX VOLUME: Controls the volume of line inputs 6, 7 and the Bluetooth®wireless technology
6- AUX INPUT: 3,5mm mini stereo jack , line level
7- PHONO STEREO INPUT: Can be used to connect an external audio device such as
a CD player.
8- Bluetooth®wireless technology on/off switch: When this switch is on, the speaker can be
connected to a smartphone. To do so, access the Bluetooth®wireless technology in your phone
settings, search the speaker among the available devices and connect both units.
9- Bluetooth®wireless technology LED: This LED is off when the Bluetooth® wireless technology
is switched off. It blinks when the speaker is searching for a connection. It is on when the
connection is established.
10- VCV SWITCH: VCV means voice controlled volume. So when you use any of the microphone
inputs and talk, automatically the signals of the aux channel ( inputs 6, 7 and Bluetooth®
wireless technology ) will be lowered. When you stop talking the original aux level is restored.
11- BASS: Controls the amount of low frequencies in the output signal. (-12dB to + 12dB)
12- TREBLE: Controls the amount of high frequencies in the output signal. (-12dB to + 12dB)
13- MIX OUT: Line out XLR that can be used to connect an amplier or another powered speaker in
series. Wiring of the 3-pin connector: Pin 1 = Shield / Pin 2 = Positive (hot) / Pin 3 = Negative (cold)
14- POWER switch: This switch turns on/off the power.
15- POWER indicator LED: This LED turns on when unit is receiving mains power.
16- CHARGE indicator LED: This LED turns on when the battery is charging.
17- DC FUSE: This FUSE protects DC12V input 26. Fuse type (F6,3A 250V)
18- DC 12V: 12V DC input . Pay attention while inserting the wires not to make a short circuit and
make sure the polarity is right. DO NOT USE IT unless you are qualied.
19- AC CONNECTOR and voltage switch: Warning! The fuse cover plate acts as switch between
110-120V 60Hz and 220-250V 50Hz. The orientation is important. Make sure that your local
voltage matches the voltage indication written above the arrow. If it is not the case, turn the
plate and use the appropriate fuse. Always unplug the power cable before turning the plate or
changing the fuse.
