Chapter 1. Introducing the Display System STACK ST8130 Road Car Display System
2Users Guide
6. Fuel level.
The fuel level alarm is indicated by a separate warning light; the unit
does not display any message for the fuel level alarm.
7. Battery voltage
When the warning condition alarm light is switched on, a warning
message is shown on the digital display to identify the condition. You can
enable or disable the warning system for each parameter individually.
You can cancel the warning message by pressing a switch. Doing this
does not turn off the warning condition alarm light, which stays on until
the condition no longer applies.
You can redefine the preset alarm values for each parameter to those
which are more suitable for your vehicle.
The system provides outputs for two external warning lights:
•a gear shift warning light that is based on an RPM value that you
define for your vehicle
•an additional alarm warning light for the alarms described above
Either model can also be fitted with an optional lap timing sensor.
An optional air temperature sensor may be installed on the ST8130
variant.
ST8130 Models
ST492 Option pulse amplifier. This system obtains the vehicle’s speed
from pulses generated by the rotation of a drive shaft or from the
gearbox.
ST670 Option wheel speed sensor. This system obtains the vehicle speed
from the rotations of one of the wheels on the vehicle.
How to use this Manual
Stack recommends that you unpack and connect the components in the
system before you install it in your vehicle. This will enable you to
familiarise yourself with operating the display and configuring it for the
vehicle in which you intend to install it.
