( 3 / 8)
Operation
The CMCxx-DIGI is manufactured from 1 to 48 channels and it suits as directional remote for digital
controllers. The CMCxx-DIGI Motors/Hoists connected to the CMC-LVseries, GMDseries and
AHDseries controller can be activated individually or simultaneously using the GO button located on
the CMCxx-DIGI cable or wireless controller /WMC-DIGI/. The selection of the hoists to be controlled
should be done by the WMC or CMC switches. Units can be lin ed together to create bigger systems.
How to start
•Connect a 5-pin NC5MXX plug to the remote input of the CMCxx-D unit.
•Chec if the emergency STOP button on both MC and WMC devices is released. If not, this
state will be indicated by the status B LED blin ing in red color. Chec STOP buttons on all
connected controllers. Rotate them cloc wise to release.
•There is an additional emergency input for the connection of load cell input located on the
rear side of the controller. If the reason for an emergency STOP is other than the press of
the emergency STOP button, the status B LED is in orange color. To reset it, press and
release the emergency STOP button. In normal operation, the status B LED is in green color.
•Move the lever on CMCxx-DIGI or WMCxx-DIGI corresponding to each motor to the desired
position. According to the position of lever, hoists act as follows:
oUP - Lever in upper position
oSTAY – Lever in middle position
oDOWN - Lever in lower position
•Pushing the GO button will activate the motors and move them simultaneously.
•Releasing the GO button will stop the movement of the motors simultaneously.
•When the device is not in use, it is highly recommended to turn it OFF using the ey located
on the front panel.
To Move a Single Motor:
•Set the UP/DOWN toggle switch for desired motor to the desired direction. The associated
LED will illuminate green for UP and red for DOWN direction.
•Hold the GO button until the motor(s) is/are moved to the desired height, then release.
To Move Several Motors:
•Set the UP/DOWN toggle switches for each motor to the desired direction. The associated
LEDs will illuminate green for UP and red for DOWN direction.
•Hold the GO button until the motors are moved to the desired height, then release.
