FAQ (Deutsch)
Open the liquid control anti clockwise.
Do you have enough liquid in your tank?
You might have too much cotton placed in your deck.
The cotton shall be placed very fluffy into the liquid
channels and pockets (Deck Be).
I got some leakage – liquid is
draining out of the afc holes.
A leakage is often due to the wrong placement of
the cotton:
-
: Place cotton, mesh or silica deeper
into the liquid channel. Place the cotton fluffy
into the horizontal liquid channels. You should
feel a slightly resistance while you pulling the
cotton trough your coil.
-
: Put more cotton into the pockets. The
liquid hole must be covered with cotton (inside
the deck).
-
: the cotton must be cut flush at the
end of the channels and sit fully into the
channels.
If your SQuape E[motion] leaks right after filling,
that means you haven’t closed the liquid control
completely. You need to turn the locking cap 2/3
clockwise. Make sure you are on „closed“ mode.
Only fill the SQuape E[motion] in „closed“ mode!
I can’t turn the liquid control.
You close the liquid control clockwise. If you turn anti
clockwise you open the liquid control (2/3 rotation).
Disassemble the tank, especially the chimney and
locking cap. Please have a look at the manual. Clean
everything with water, let it dry and lubricate the o-
rings and threads with VG or liquid.
If this won’t work, please get in contact with
Slightly unscrew the centerpin. If this won’t work,
please get in contact with support@squape.ch.
to clean the SQuape E?
You might have to clean the centerpin from time to
time. Just wipe it off with a paper towel. We
recommend to clean the atomizer with water or
ultrasonic cleaner. Never use a dishwasher!
I can not remove the deck.
You got different possibilities:
- Remind, the deck can always be removed. Please
pull the deck straight – otherwise it can be tilled!
- Put the base into a freezer for about 30 min.
- Rubberband (supplied SQ Grip Band), paper towel
or something similar, which helps to protect the deck.
- Pull with pliers (be careful and protect the deck and
the pliers) – pull straight.
- Do not touch the unprotected deck with pliers.
- you can use a rubber grip of a pair of pliers
I can turn the afc ring too
easy or too hard
Replace the o-ring with an o-ring from the
replacement set. (o-rings have tolerances and
these change noticeably the resistance).
At all events, moisten the o-ring with some liquid.
