5
Charge the Battery Pack
Before using the gas detector for the first time, you will need to charge the
battery pack in order for the unit to function correctly.
CAUTION: To prevent equipment damage,
• Chargethebatterypackonlyintemperaturesbetween32°Fand104°F
(0°Cand40°C).Chargingoutsidethistemperaturerangemaycause
permanent damage to the battery pack.
• UseonlytheACadapterthatisincludedwiththeTIF8800Xtochargethe
battery pack. If a replacement adapter is needed, refer
to the Replacement Parts section of this manual.
Setup
1.PlacethepowerswitchintheOFF/CHARGE
position. See Figure 2.
2. Plug the AC adapter (included with the TIF8800X) into
an appropriate wall outlet, and connect the charger
jacktothechargeinputonthetool.
See Figure 3.
Duringthechargecycle,theyellowLED(CHARGE) is
illuminated. Once charging is complete, the green
LED(READY)willalsoilluminate.
Notes:
charging will not damage the tool. However, the tool
disconnected.
parasitic drainage that occurs during storage and
approximately 15 hours.
Repeat this procedure a minimum of 3 to 5 times.
Charger
Input Jack
Figure 3
Side
View
Figure 2
Power
Switch
View
