2Form No. 1001292
Rev. 0 Dec. 21, 2022
© SPX FLOW, Inc.
SAFETY SYMBOLS AND DEFINITIONS
SAFETY PRECAUTIONS
It is impossible to predict the exact force needed for every pulling situation. The amount of press-t and
force of removal can vary greatly between jobs. The set-up requirements along with the size, shape and
condition of the parts being pulled are all variables which must be considered. Remember that a signicant
amount of force can be exerted with a puller. Respect this force and always observe safety precautions.
Failure to comply with the following cautions and warnings could cause equipment damage or personal
injury.
IMPORTANT
: Visually inspect all components for shipping damage. Shipping damage is not covered
by warranty. If shipping damage is found, notify the carrier at once. The carrier is
responsible for all repair and replacement costs resulting from damage in shipment.
Safety symbols are used to identify any action or lack of action that can cause personal injury.
Your reading and understanding of these safety symbols is very important.
: Danger is used only when your action or lack of action will cause serious human injury
or death
: Warning is used to describe any action or lack of action where a serious injury can
occur.
: Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
IMPORTANT
: Important is used when action or lack of action can cause equipment failure, either
immediate or over a long period of time.
CAUTION : Used without the safety alert symbol indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
• The following procedures must be performed by qualied, trained personnel who are
familiar with this equipment. Operators must read and understand all safety precautions
and operating instructions included with the device. If the operator cannot read these
instructions, operating instructions and safety precautions must be read and discussed in
the operator's native language.
• Make sure all system components are protected from external sources of damage, such as
excessive heat, ame, moving machine parts, sharp edges and corrosive chemicals.
• Safety glasses must be worn at all time by the operator and anyone within sight of the unit.
Additional personal protection equipment may include: face shield, goggles, gloves, apron,
hard hat, safety shoes, and hearing protection.
• The owner of this tool must verify that safety-related decals are installed, maintained, and
replaced if they become hard to read.
• Keep hands away from possible pinching points.
• Use only genuine POWER TEAM replacement parts and endorsed hydraulic components.
General:
:To prevent personal injury,
