SD60 Quick start guide V1.0
第5页，共 10 页
code is successfully scanned when the scan button is pressed, the
scanning laser will automatically turn off.
(2) Single Scan: In this mode, press the scan button to turn on the
scanning laser. If the bar code is successfully scanned, the scanning
laser will automatically turn off. If the bar code is not scanned within
10 seconds of releasing the scan button, the scanning laser will
automatically turn off.
(3) In this mode, press the scan button to turn on the scanning laser. After
successfully scanning the bar code, the scanning light will not turn off,
trigger continuous scanning, and press the scan button again to turn
off the scanning laser.
Charging & attention
1 Please use the supplied charger and USB (Type-C) cable. Otherwise, the
fast charging mode cannot be enabled. Using a non-original charger and a
USB charging cable may result in long charging time and repeated restarts,
and affect the battery life.
2It is recommended not to operate the devices while charging, and not to
cover objects on the device and charger.
3When the device is in low power, there will be an indicator light and a
desktop pop-up reminder. Please charge as soon as possible to avoid
affecting normal use.
4Please ensure that the power is about 50% when store the equipment for a
long time. Please place the equipment in a suitable environment with dry
temperature to avoid equipment failure caused by long-term storage.
5 In case of damage to the battery, charging head and charging cable, please
contact us in time to purchase, do not repair it yourself, so as to avoid danger
and cause extra loss.
