USER’S MANUAL
EN
3
1.2.2 Noise load
The device itself emits a low level of noise. However, during the sharpening of tungsten elec-
trode, the level of noise increases. Excessive noise can cause permanent damage to hearing.
In order to prevent threats mentioned above, following rules must be followed:
• use appropriate hearing protectors,
• people in the vicinity should be informed about the dangers of exposure to excessive noise.
People in the work zone must wear appropriate hearing protection.
1.2.3 Risk of electric shock
The unit is powered from single-phase network 230V +/- 10%. Like all device supplied with
electricity network, the grinder may cause risk of electric shock to the operator. Electrical
shock from the electricity network can result in permanent damage to health or loss of life.
In order to prevent threats mentioned above, following rules must be followed:
• it is forbidden to use when the power cord, plug or cover is damaged,
• do not touch electrical components of the device under voltage,
• take special care when using the device in small rooms or in areas with increased air humidity,
• avoid contact with water.
1.3 ENVIRONMENTAL CONDITIONS
Conditions during the operation, storage and transport
Ambient temperature during operation -10°C ÷ +40°C
Relative air humidity 50% in +40°C
90% in +20°C
Ambient air free from excessive amounts of dust, acids,
corrosive gases
Ambient temperature
during transportation and storage -20°C ÷ +55°C
2. EC DECLARATION OF CONFORMITY
Hand grinder SPARTUS® D33 is in conformity with the relevant Union harmonization
legislation:
LVD 2014/35/UE Low Voltage Directive
EMC 2014/30/UE Electromagnetic Compatibility Directive
harmonized standards:
EN 60745-1:2006 Hand-held motor-operated electric tools – Safety – Part 1: General
requirements.
Product is marked with CE sign .
This declaration applies only to the machine in the state in which it was on the market and
does not include components added by the end-user or subsequent actions carried out by it.
