3
Warnings
• Read the safety and operating instructions before using any Spartan Tool product. Drain and sewer cleaning can be dangerous if
proper procedures are not followed and appropriate safety gear is not utilized.
• Before starting unit, be sure to wear personal protective equipment such as safety goggles or face shield and protective clothing
such as gloves, coveralls or raincoat, rubber boots with metatarsal guards, and hearing protection.
• Drains and sewer can carry bacteria and other infectious micro-organisms or materials which can cause death or severe illness. Avoid
exposing eyes, nose, mouth, ears, hands, and cuts and abrasions to waste water or other potentially infectious materials during drain
and sewer cleaning operations. To further help protect against exposure to infectious materials, wash hands, arms and other areas
of the body, as needed, with hot, soapy water and, if necessary, flush mucous membranes with water. Also, disinfect potentially
contaminated equipment by washing such surfaces with appropriate chemicals or soaps.
• For any questions, contact Spartan Tool at the address shown below.
CALIFORNIA PROP. 65
This product may contain an
extremely small amount of lead in the
coating. Lead is a material known to
the State of California to cause cancer
or reproductive toxicity.
CONTACT US
Spartan Tool LLC
1618 Terminal Road
Niles, MI 49120
800.435.3866
SpartanTool.com
USE OF ANY ELECTRIC EQUIPMENT IN A WET OR DAMP ENVIRONMENT CAN CAUSE FATAL SHOCK IF NOT PROPERLY
GUARDED AGAINST BY THE OPERATOR.
1. Before using your Spartan equipment, make sure that a properly grounded, 3-hole electrical outlet is available. If not, as in older
homes, use a 3-prong adapter and connect the green pigtail or grounding lug to a known ground such as a cold water pipe.
2. Don't assume all 3-hole outlets are properly installed. Check the outlet and also the adapter, if used, with an outlet testing device
which quickly indicates if a ground is connected. Correct a faulty test indication before proceeding.
3. Plug the three-wire cord furnished with your machine into the inspected outlet. If an extension cord must be used, it must be of an
approved three-wire type in good condition, equipped with a three-prong plug. Never cut off the grounding prong for use in a two-
hole outlet receptacle. By doing so, you have cut off your protection from shock.
4. Use rubber boots and rubber gloves inside your Spartan riveted gloves to further insulate yourself. Respect electricity: you may not
get a second chance.
5. Read this manual carefully for further safety precautions and operating instructions.
Your Spartan equipment has been built with the utmost safety in mind and thoroughly inspected for electrical and mechanical defects.
However, through abuse and misuse on the job, a breakdown in the electrical insulation could conceivably develop and if this happens,
you need a ground circuit to protect you.
