Before checking the fan, make sure the
main power supply is switched o. The motor
housing must not be opened.
Suggested remedy
• Check main and branch circuit fuses or circuit
breakers.
• Check line wire connecons to fan and switch wire
connecons in switch housing.
IMPORTANT: For safety reasons, the fan must not be
operated if it produces unusual noises outside of its
inial installaon!
Suggested remedy
• Allow a “running-in” period of 24 hours. Most
noises, associated with a new fan, will disappear
aer this period.
• While tesng the motor without blades, a reso-
nance sound can happen, this is normal. When
blades are ed, this sound will cease.
• Check the screws which aach the fan blade to the
motor to make sure that they are ght.
• Check all nuts and bolts behind the two canopies
for perfect ghtness.
• Check the upper canopy has 10mm clearance to
the ceiling. The upper canopy should not touch the
ceiling or power cables.
• Check the lower canopy, coer pin and wires
under the lower canopy. These parts should not be
touching the motor.
• A slight humming sound if used with the oponal
speed controller (especially on lower speed) is
normal for all ceiling fans. Use our oponal speed
control avoid or minimize this sound.
- IMPORTAN For the reason of safety and the risk of
damage the fan must not be used when it is seriously
wobbling!
Suggested remedy
• A lile wobbling, especially aer start-up or aer
speed changes, is normal. Once end speed is
reached, the fan will be become stable.
• Main causes for wobbling are unequal blades. If
one blade is damaged or bent use a complete new
set of three blades.
• The fan blades are balanced by weight to prevent
wobbling. If you have to assemble a range of fans,
be sure not to exchange a blade from another set
of three blades.
• Check to make sure the fan blade screws which
aach the fan blade to the motor are ght.
• Check all nuts and bolts under the two canopies
for perfect ghtness.
Suggested remedy
• The capacitor could be damaged, this may be due
to overload or a power spike. A qualied electrician
should check the capacitor and replace if nessecary.
Maintenance is essenal to ensure the correct operaon
of the fan. This should only be carried out by a suitable
qualied professional.
Before commencing with any maintenance and/or clean-
ing of the fan, ensure the power is isolated.
Over me some connecons/xing may start to work
loose, therefore all connecons must be checked at least
twice a year for perfect ghtness. Especially the blade
screws, all nuts, bolts and coer pins inside the two
canopies, the pin and strength of the ceiling J-hook and
the safety wire.
In case of intensive use the above checks should be more
frequent.
If a damp cloth is needed for cleaning, do not use liquid
soap or aerosol cleaners.
Never dip the fan into water or other liquids.
IMPORTANT!
IMPORTANT!
IMPORTANT!
