7CLEANING, CARE & MAINTENANCE
•
Make sure that you continuously check and keep the
glass washer and the surrounding area clean, even when
it is being used. The cleanliness of the unit, brushes and
surrounding area should be checked at least once an hour.
•
Clean the glass washer thoroughly at least once a day when
used regularly. It should also be cleaned before starting up
the unit for the rst time, after a prolonged period out of use
or after repairs.
•
To do this, remove the overow pipe and drain the water.
Remove the middle brush and brush strip from the unit and
clean with the Original NU®sanitizer powder. Take the NU®
out of the sink and clean thoroughly with a suitable cloth and
Spülboy®detergent.
•
Place the brushes in a container, sprinkle 2 tablespoons of
Spülboy®sanitizer powder over the brushes and add hot
water so that the brushes are completely covered.
Note! The cleaning results may vary and the unit may be
damaged if third-party substances are used.
•Allow the sanitizer powder to take eect for approx.
8-12 hours.
•
Rinse the brushes thoroughly with fresh water and reinsert
into the pre-wash canister before using the unit again.
4
6WASHING
6.1Pre-washing
•Check each receptacle / glass to be cleaned for any drink
residues or other foreign bodies (e.g. lemon slices, straws)
before starting the washing cycle and place them in a separate
container.
•Hold the glass centrally in the pre-wash canister over the middle
brush and clean with at least 4 full upward and downward move-
ments (do not rotate).
•Light foaming of the rinsing water shows that the NU®glass
washing tablet is working. If no foam appears, simply place another
(1) glass washing tablet in the pre-wash canister.
•1 NU®tablet ensures satisfactory cleaning performance for approx.
4-6 hours.
Please note: The washing results may vary when third-party
detergent is used.
6.2Rinsing&Post-rinsing
•Place the glass on the telescopic rinsing unit and carefully rinse
it from the inside and outside.
Rinse with tap water for 3 seconds for the best results.
•The rinsing function also activates the fresh water supply
in the pre-wash canister at the same time.
•NU®water+: You have the option to top up the
prewash canister with additional fresh water
manually and/or as required by pressing the
soft point.
•The average water consumption per
glass cleaning cycle is approx. 8 cl.
7CLEANING, CARE & MAINTENANCE
•Make sure that you continuously check and keep the
glass washer and the surrounding area clean, even when
it is being used. The cleanliness of the unit, brushes and
surrounding area should be checked at least once an hour.
•Clean the glass washer thoroughly at least once a day when
used regularly. It should also be cleaned before starting up
theunitforthersttime,afteraprolongedperiodoutofuse
or after repairs.
•Todothis,removetheoverowpipeanddrainthewater.
Remove the middle brush and brush strip from the unit and
clean with the Original NU®sanitizer powder. Take the NU®
out of the sink and clean thoroughly with a suitable cloth
and Spülboy®detergent.
•Place the brushes in a container, sprinkle 2 tablespoons of
Spülboy®sanitizer powder over the brushes and add hot
water so that the brushes are completely covered.
Note! The cleaning results may vary and the unit may
be damaged if third-party substances are used.
•Allowthesanitizerpowdertotakeeectforapprox.
8-12 hours.
•Rinse the brushes thoroughly with fresh water and reinsert
into the pre-wash canister before using the unit again.
4
6WASHING
6.1 Pre-washing
•
Check each receptacle / glass to be cleaned for any drink
residues or other foreign bodies (e.g. lemon slices, straws)
before starting the washing cycle and place them in a separate
container.
•Hold the glass centrally in the pre-wash canister over the middle
brush and clean with at least 4 full upward and downward move-
ments (do not rotate).
•Light foaming of the rinsing water shows that the NU®glass
washing tablet is working. If no foam appears, simply place another (1)
glass washing tablet in the pre-wash canister.
•1 NU®tablet ensures satisfactory cleaning performance for approx.
4-6 hours.
Please note: The washing results may vary when third-party
manufacturer‘ detergent is used.
6.2 Rinsing & Post-rinsing
•Place the glass on the telescopic rinsing unit and carefully rinse
it from the inside and outside.
Rinse with tap water for 3 seconds for the best results.
•The rinsing function also activates the fresh water supply in
the pre-wash canister at the same time.
•NU®water+: You have the option to top up the pre-
wash canister with additional fresh water manually
and/or as required by pressing the soft point.
•The average water consumption per glass
cleaning cycle is approx. 8 cl.
