SOYO G1681 Manual de usuario
Table of Content
SAFETY INFORMATION...................................................................... 1
INTRODUCTION................................................................................... 2
Front Panel.....................................................................................................3
Rear Side .......................................................................................................3
Function Key and LED...................................................................................4
Specifications.................................................................................................5
Package of Contents......................................................................................5
INSTALLATION..................................................................................... 6
Installation with Router, Switch, or Hub.........................................................6
CONFIGURATION VIA TELEPHONE KEYPAD................................... 7
CONFIGURATION VIA WEB BROWSER ............................................ 8
Network Settings..........................................................................................11
Audio Settings..............................................................................................12
Dial Plan Settings.........................................................................................13
Protocol Settings..........................................................................................15
Other Settings..............................................................................................20
Update..........................................................................................................20
Upgrade Firmware .......................................................................................20
Limited Settings............................................................................................21
USING SOYO G1681 ATA.................................................................. 22
Answering Calls ...........................................................................................22
Making Calls When Dual Mode is Disabled.................................................22
Making Calls When Dual Mode is Set to “ip first”.........................................22
Making Calls When Dual Mode is Set to “pstn first” ....................................22
Making Peer to Peer Calls by Dialing IP Address........................................22
APPENDIX: PORT FORWARDING.................................................... 24
SOYO G1681 Analog Telephone Adapter User Guide
-1-
Safety Information
The SOYO G1681 ATA has been tested and approved by the highest
standards of safety regulations. However safety is your responsibility too.
Use only the power adapter provided
Do not disassemble this product without guidance
Never spill liquid of any kind on the product
Do not cut power off in the process of configuration and upgrading
SOYO G1681 Analog Telephone Adapter User Guide
-2-
Introduction
SOYO G1681 ATA (Analog Telephone Adapter) is an advanced Internet
Protocol (IP) device, allowing its users to experience superb voice
communications over the Internet. Simply plug in your telephone set (regular
phone or cordless phone) to the ATA, and then you will be able to use the
Internet to make phone calls. G1681 ATA works as a standalone device (no PC
is needed) with any broadband Internet connection. This Internet connection
can be either:
A Digital Subscriber Line (DSL) Internet service from a telephone company
A cable modem Internet service from a cable television company
Other high-speed Internet connection such as ISDN and T1
With SOYO G1681 ATA, you can use the same telephone set for your existing
PSTN service and VoIP service. This function is called “dual mode”. If you
choose to use “ip first”, all the calls will be send through VoIP, unless you press
a prefix number to select the PSTN. If you choose to use “pstn first”, all the
calls will be sent through PSTN, unless you press the “flash” button (or hit the
hook switch of the phone once) to select the VoIP. Or you can select to
“disable” the “dual mode” to use the ATA with VoIP only.
Note: PSTN stands for Public Switched Telephone Network, which refers
to the international telephone system based on copper wires carrying
analog voice data. It is the standard telephone service that most homes
use.
Note: VoIP stands for Voice over Internet Protocol, a category of hardware
and software that enables people to use the Internet as the transmission
medium for telephone calls by sending voice data in packets using IP
rather than by traditional circuit transmissions of the PSTN.
SOYO G1681 Analog Telephone Adapter User Guide
-3-
Front Panel
Rear Side
SOYO G1681 Analog Telephone Adapter User Guide
-4-
Function Key and LED
LED Function
ON Power on
POWER OFF Power off
ON Phone off hook
STATUS OFF Idle
Flash Talking
SERVER OFF Idle
Buttons Function
Voice prompt “Local IP” that G1681 is getting
IP Set different internet connection type (static IP, PPPoE, DHCP)
SOYO G1681 Analog Telephone Adapter User Guide
-5-
Specifications
Hardware Network interface:1 RJ-45 Ethernet connectors (WAN)
Tel interface: 1 PSTN pass through port (LINE), 1 FXS port (TEL)
‘Local IP’ function button (IP)
Software Configure adapter via HTTP web browser (IE6.0) or Telnet
Upgradeable via FTP, HTTP, or setting program
Auto-provisioning and auto-upgrade via FTP
E.164 dial plan and customized dial rules
Programmable PSTN/VOIP priority and selection
Audio
Codec G.711 a/u
G.723.1 5.3/6.3
G.729A/B/AB
GSM 610
iLBC
QoS: Dynamic voice test
CNG(Comfort noise generation)
G.168/165 compliant 16ms echo cancellation
Tone generation and local DTMF re-generation according with
ITU-T
VOIP
Protocols H323 V4 ,MGCP,SIP ,IAX2
Internet
connection DHCP
PPPoE
Static IP
Size (L × W × H) 150 × 110 × 28 mm (5.9 x 4.4 x 1.1 inch)
Weight 193 g (6.8 oz)
Power Adapter
Input – AC 110-240V
Output - DC 12V/450mA
Certifications FCC, CE
Package of Contents
G1681 Analog Telephone Adapter (ATA)
One Ethernet RJ-45 Cable
AC power adapter
User Manual CD
SOYO G1681 Analog Telephone Adapter User Guide
-6-
Installation
The SOYO G1681 ATA supports static IP, PPPoE, and DHCP Internet
connections. However some ISPs provide only one public IP address per
household connection. In order to share the Internet connection with your PC
and configure the ATA from the PC, using a router is strongly recommended.
Installation with Router, Switch, or Hub
1. Connect a RJ-45 cable from the LAN port of the router/switch/hub to
the WAN port of the G1681 ATA.
2. Connect one end of a RJ11 cable to the TEL port of G1681 ATA, the
other end to any telephone set.
3. Connect one end of a RJ11 cable to the LINE port of G1681 ATA, the
other end to the PSTN line port in the wall. (Optional).
4. Connect the power adapter to the AC outlet and the power jack at the
rear of G1681 ATA.
5. Once the ATA is powered up, you will see the LED lit up on the front
panel.
SOYO G1681 Analog Telephone Adapter User Guide
-7-
Configuration via Telephone Keypad
Using the keypad of the normal phone connected to G1681 TEL port and the
“IP” button of the ATA, you can get and set the IP address of the ATA.
Operation Function
Press and hold IP button Press and hold the IP button and lift the handset of the phone
connected to the ATA, a voice prompt “local ip” will be heard
from the handset.
Press 12340 IP button Lift the handset and on the telephone keypad, press 12340, then
press IP button located at the rear of the ATA. The ATA will
reboot into static IP mode.
Press 12341 IP button Lift the handset and on the telephone keypad, press 12341, then
press IP button located at the rear of the ATA. The ATA will
reboot into DHCP mode.
Press 12342 IP button Lift the handset and on the telephone keypad, press 12342, then
press IP button located at the rear of the ATA. The ATA will
reboot into PPPoE mode.
Note: If the G1681 has been set to be “dual mode” and “pstn first”, press
the hook or the flash key of the phone set to turn back to ip state, then
perform the above operation.
SOYO G1681 Analog Telephone Adapter User Guide
-8-
Configuration via Web Browser
First find out the IP address of the ATA by holding the IP button and lifting the
handset of the phone connected to the ATA, a voice prompt “local ip” will be
heard from the handset. Then on a PC on the same local area network, open
an IE browser. Input the IP address of the phone, and press “go” button. The
following page will show up:
The default super password is 12345678 or 1234. Enter the password and
press “Login”, the full setting page will show up.
Note: Use regular password to log in for the limited setting page. Refer to
section “Limited Settings” for detail.
Note: Recommend to use Microsoft Internet Explorer for the web page
configuration. Other browsers may fail to login or cause display error.
Warning
Please check with VoIP service provider for the service settings. Changing the
settings without proper guidance may result the ATA not functioning.
Tabla de contenidos
