Port Description:
FXS(Foreign Exchange
Station)
FXS port can be connected to analog
telephone sets
Connect to CO line with RJ-11(Gray) analog
line.
Connect to the network with an Ethernet
cable. This port allows your ATA to be
connected to an Internet Access device, e.g.
router, cable modem, ADSL modem, through a
networking cable with RJ-45 connectors used
on 10BaseT and 100BaseTX networks.
Connect to PC with Ethernet cable. 1 port
allows your PC or Switch/Hub to be connected
to the ATA through a networking cable with
RJ-45 connectors used on 10BaseT and
100BaseTX networks.
Push this button until 5 seconds and ATA will
be set to factory default configuration.
A power supply cable is inserted
Installation:
1 Connect the 12V DC IN to the power outlet with power adaptor.
2 Connect FXO to PSTN.
3 Connect FXS to a telephone jack with the RJ-11 analog cable.
Connecting to a PC:
1 Connect the Ethernet cable (with RJ-45 connector) to any LAN port.
2 Connect the other end of the Ethernet cable to your PC’s installed network interface
card (NIC).
Connecting to an External Ethernet Hub or Switch:
1 Connect the Ethernet cable (with RJ-45 connector) to WAN port.
2. Connect the other end of the Ethernet cable to DSL/Cable modem or the external
