SoundMax SM-CCR3184FB Manual de usuario
SM-CCR3184FB
USB/SD media player
Instruction manual
USB/SD-медиаплеер
Руководство по эксплуатации
MOD
CLK
MIC
VOL/SEL
RST
BND/AMS MUTE
SD
1/ 2/INT
3/RPT 4/RDM
5/-10 6/+10
AUX
SM-CCR3184FB 2 x 45W
2
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully
before connecting, operating and/or adjusting the product and keep the manual for reference in the future.
Table of contents
TABLE OF CONTENTS ......................................................................................................................................................2
IMPORTANT SAFEGUARDS ............................................................................................................................................3
ACCESSORIES....................................................................................................................................................................4
INSTALLATION/CONNECTION......................................................................................................................................5
CONTROL ELEMENTS.......................................................................................................................................................9
GENERAL OPERATIONS ..................................................................................................................................................10
RADIO OPERATIONS........................................................................................................................................................12
USB/SD OPERATIONS .....................................................................................................................................................13
TROUBLESHOOTING GUIDE..........................................................................................................................................15
SPECIFICATION .................................................................................................................................................................16
3
Important safeguards
Read carefully through this manual to familiarize yourself with this high-quality sound system.
The beginning of operation is the moment of the unit installation. Before use the device in winter it is
recommended to heat up the passenger compartment during 20 seconds or to the operation temperature.
Use the unit with the temperature that goes beyond the operation temperature greatly decreases the
operation resource of the screen and other components of device and can result an outage.
Disconnect the vehicle's negative battery terminal while mounting and connecting the unit.
When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher
amperage rating may cause serious damage to the unit.
Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or
create safety hazards such as electrical shock.
Do not use the unit in places where it can be exposed to water, moisture and dust.
Do not open covers and do not repair yourself. Consult the dealer or an experienced technician for help.
Make sure you disconnect the power supply and aerial if you will not be using the system for a long period
or during a thunderstorm.
Make sure you disconnect the power supply if the system appears to be working incorrectly, is making an
unusual sound, has a strange smell, has smoke emitting from it or liquids have got inside it. Have a
qualified technician check the system.
The unit is designed for negative terminal of the battery, which is connected to the vehicle metal. Please
confirm it before installation.
Do not allow the speaker wires to be shorted together when the unit is switched on. Otherwise it may
overload or burn out the power amplifier.
4
Accessories
1 pc
1 pc
2 pcs
2 pcs
1 pc
1. Receiver
2. Mounting parts:
Mounting sleeve
Release keys
3. ISO connector
4. Instruction manual
5
Installation/Connection
General notes
Choose the mounting location where the unit will not interfere with the normal driving function of the
driver.
Before finally installing the unit, connect the wiring and make sure that the unit works properly.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the
vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or
from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.
DIN FRONT-MOUNT
1. Car dashboard
2. Sleeve
1. Install the sleeve into the dashboard; ensure it is installed with the correct side and there are no
obstacles (wires, dashboard elements, etc) for the unit installation.
2. After installing the sleeve into the dashboard, bend tabs fitting to the size of the dashboard to fix the
sleeve in place.
2
1
182
53
6
3. Make the necessary wire connections. Ensure the connections are correct.
4. Install the unit into the sleeve until the side locks are fixed.
Dismantling the unit
1. Make sure the ignition is turned off, then disconnect the cable from the
vehicle battery’s negative (-) terminal.
2. Insert both of the supplied keys into the slots at the middle left and right
sides of the unit, then pull the unit out of the dashboard.
Using the ISO Connector
1. If your car is equipped with the ISO connector, then connect the ISO connectors as
illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle carefully
before connecting, incorrect connection may cause serious damage to this unit.
Cut the connector, connect the colored leads of the power cord to the car battery as
shown in the connection diagram below for speaker and power cable connections.
7
Connection diagram
Notes:
In spite of having any kinds of speaker systems, they must use 4 ohms speaker impedance to reduce
the distortion at high volume levels.
Do not let the auto antenna and ground wires touch each other.
+24V DC NEGATIVE GROUND
8
Control elements
1. ⏻ (Power)/MOD button
2. VOL/SEL knob
3. 3/RPT button
4. 1/⏯ (Play/Pause) button
5. 2/INT button
6. 4/RDM button
7. Display
8. USB port
9. AUX IN jack
10. SD card slot
11. MUTE button
12. BND/AMS button
13. ⏭/ (Next/Answer)
button
14. Reset button (hole)
15. ⏮/ (Previous/Hang
Up) button
16. 6/+10 button
17. 5/-10 button
18. Microphone
19. CLK button
MOD
CLK
MIC
VOL/SEL
RST
BND/AMS MUTE
SD
1/ 2/INT
3/RPT 4/RDM
5/-10 6/+10
SM-CCR3184FB 2 x 45W
1 2 3 4 5 6 7 8
9
10111213
15161718
19
14
9
General operations
Turning the unit on/off
Press the Power button to turn the unit on. Press and hold the button again to turn the unit off.
Reset the unit
When first using the device or after replacing the car battery, you must reset the unit. Press the RESET
button (hole) with a pointed object (such as a ballpoint pen) to set the unit to its initial state.
When some errors occur, you can also press the RST button to return to factory settings, but note that it
will erase clock setting and some memorized functions.
Mode selection
Press the MODE button repeatedly to select between Radio => SD/MMC => USB => AUX IN => BT
modes. Operation modes are indicated on the display. SD/MMC and USB modes are not available unless a
memory card or a USB device is connected.
Volume control
Adjust the volume by rotating the VOLUME knob. Mute the sound by pressing the MUTE button.
Audio parameter setting
Press the SEL/VOL knob repeatedly to select a parameter: Volume => BASS => TREBLE =>
BAL (balance) => LOUD OFF/ON (Loudness) => EQ (equalizer) => LOC/DX (LOCAL: only stations
with strong signal, DX: all stations of the current band) => STEREO (stereo mode) => 12/24 (12-
и 24h modes). Rotate the SEL/VOL knob to adjust each mode.
10
Loudness
Activating this feature will enhance bass and treble frequencies when listening to music at low volumes.
AUX input
AUX-in jack is intended for connecting an external audio equipment to amplify the sound. If connection is
made correctly, the audio signal from the external source will be transmitted through the acoustics of the
head unit. This enables to adjust the volume and quality of the sounding. For example, you can connect an
MP3-player to listen to tracks using the car acoustic system.
Time display
Press the CLK button to show the current time on the display.
In this mode press and hold the CLK button again. The clock indicator will blink.
Rotate the VOL/SEL knob to set the current hour, then press the knob to enter the minute setting mode
and repeat the above steps to set the minutes. Press the VOL/SEL knob to confirm.
• Bass/Treble: from -7 to +7;
•Balance: -7 (left) to +7 (right);
• Loudness: see “Loudness” paragraph below
• EQ: select POP/ROCK/CLASS/FLAT or OFF equalizer mode.
When equalizer is in any mode except OFF, bass and treble are not adjustable.
Tabla de contenidos
Idiomas:
Otros manuales de Reproductor multimedia de SoundMax
SoundMax
SoundMax SM-CCR3182FB Manual de usuario
SoundMax
SoundMax SM-CCR3186FB Manual de usuario
SoundMax
SoundMax SM-DVBT270 Manual de usuario
SoundMax
SoundMax SM-CCR3048F Manual de usuario
SoundMax
SoundMax SM-CCR3189FB Manual de usuario
SoundMax
SoundMax SM-CCR3041 Manual de usuario
SoundMax
SoundMax SM-CCR3073F Manual de usuario
SoundMax
SoundMax SM-CCR3053F Manual de usuario
SoundMax
SoundMax SM-CCR3072F Manual de usuario
SoundMax
SoundMax SM-CCR3037 Manual de usuario
