Seite 6 / 15
Instructions for control
PRO ITG 3 axes Benezan
www.sorotec.de V 1.0.0
Preparation of the housing
For this construction phase you will need: #
1 Sheet steel housing 1
4 Adhesive feet 3
1 Mounting rail TS
3 Cylinderhead screw M5 x 6 S3
1 Power switch 16
1 Fan 19
1 Fan damper 20
1Dust lter for fans 21
4 Countersunk screw M4 x 40 S7
4 Nut M4 M4
3 Fuse holder 13
2Microfuse 6.3 A 14
1Microfuse 5 A 15
1 IEC built-in connector 12
2 Countersunk screw M3 x 12 S5
2 Nut M3 M3
1 LED board with cable 10
2 Flat headed screw M3 x 6 S8
3 Wiring duct 5
2 Built-in socket 18
8 Countersunk screw M4 x 16 S6
Prepare the housing 1for the installation and the
wiring of the modules as follows:
• Open (if not already done) the pre-cut
installation openings for the power switch 16 ,
the IEC built-in plug 12 and the three fuse
holders 13 .
• Cut the threads for the mounting screws:
8 x M4 for the sockets
3 x M5 for the mounting rail (see Figure 12)
• Remove all burrs and sharp edges from the
installation openings.
• Stick the rubber feet 3into the four corners
on the bottom of the case. Lateral distance
approx. 8 mm each.
• Mount the DIN rail TS cut to 16 cm with the
screws S3 in its place in the front part of the
housing (see Figure 12).
• Slide the power switch 16 with the „0“
upwards into the rectangular opening on the front
of the housing until the edge of the switch is
ush. The switch is self-locking, screwing is not
necessary.
• Mount the fan 19 and the fan damper 20 with
screws S7 and nuts M4 with the connection
cable pointing downwards behind the grille
opening on the front. Place the damper on the
inside between the fan and the housing and the
grille cover on the outside. Pay attention to the
direction of ow: The cool air should be blown
into the housing!
• Slide the cover frame 21 with the inserted
dust lter onto the grille cover of the fan.
• Mount the IEC built-in connector 12 with
screws S5 and nuts M3 in the opening provided
on the rear.
• Mount the LED board 10 in its place in the
front of the device with screws S8 .
• Lay the self-adhesive wiring duct 5. Use the
course shown in Figure 12 as a guide.
• Mount the two built-in sockets 18 with screws
S6 .
• Now build the three fuse holders 13 into the
holes below the sockets and next to the built-in
plug.
• Equip the fuse holders next to the sockets (F1
and F2) with a 6.3 A ne fuse 14 each.
• Equip the fuse holder next to the built-in
connector (F3) with the 5 A microfuse 14 .
