Sony SDX-700 Series Manual de usuario

4-658-155-04(1)

2001 Sony Corporation

AIT Drive

SDX-700 Series

SDX-710 Series

User’s Guide

This document contains proprietary

information which is protected by

document may be photocopied,

reproduced or translated to another

language without prior written consent

of Sony.

The information contained in this

document is subject to change without

notice.

SONY MAKES NO WARRANTY

OF ANY KIND WITH REGARD TO

THIS DOCUMENT.

Sony shall not be liable for error

contained herein, indirect, special,

incidental or consequential damages in

connection with the furnishing,

performance or use of this document.

VORSICHT

Diese Ausrüstung erfüllt die

Europäischen EMC-Bestimmungen für

die Verwendung in folgender /

folgenden Umgebung(en):

• Wohngegenden

• Gewerbegebiete

• Leichtindustriegebiete

(Diese Ausrüstung erfüllt die

Bestimmungen der Norm EN55022,

Klasse B.)

Contents

Introduction .......................................4

Product Features........................4

Precautions ................................5

Installation .........................................7

SCSI Connection/Setting the

SCSI ID (SDX-700C)............7

SCSI Connection/Setting the

SCSI ID (SDX-710C)............8

Option Switches (DIP Switch) ..9

Mounting Holes......................10

Remodeling from 5.25" Model

to 3.5" Model .......................13

Orientation...............................14

Operation .........................................15

Location of 3 LEDs .................15

LED Indication for

Drive Status .........................15

Drive Operation.......................16

Emergency Cassette Removal

Procedure .............................17

Interface Implementation.................20

Supported SCSI Messages ......20

Supported SCSI Commands....20

Specification ....................................21

Product Specifications.............21

Third Party Support Contacts

(In the USA) ...............................23

Sony Contacts ..................................25

SDX-700 Tape Drive

The Sony SDX-700 series drive is a high capacity data storage device using

Advanced Intelligent tape (AIT) technology. The SDX-700 series drive

achieves high data reliability through Read-After-Write, an additional level

of Error Correction Code, and other features.

The Sony SDX-700 series drive stores data on tape using a standard format

called AIT (Advanced Intelligent Tape) and ALDC formats.

Introduction

Product Features

* Assuming a 2.6 : 1 compression ratio.

(The compression ratio varies according to the type of data.)

• Supported Format : AIT-1, AIT-2, AIT-3

• Burst Transfer Rate

– 12 MB/s Asynchronous

– 160 MB/s Synchronous (SDX-700C)

– 40 MB/s Synchronous (SDX-710C)

• 18 MB Buffer Memory

• 3.5” Standard Height, 5.25” Half Height

• Embedded SCSI Interface

– Ultra 160 Wide LVD/SE SCSI (SDX-700C)

– Ultra Wide HVD SCSI (SDX-710C)

• Supports Variable or Fixed Record Length

• Supports SCSI Disconnection/Arbitration

• Frame Rewrite Function

• Three levels of Error Correction Code (ECC)

• High Speed search (120 times normal Read/Write speed of AIT-3 mode)

• Random Read, Append Write

Data Capacity

Transfer Rate (sustained)

SDX-700 series

100 GB uncompressed (with AIT-3 230 m tape)

260 GB compressed*(with AIT-3 230 m tape)

12 MB/s uncompressed

Precautions

Installation

Avoid placing the drive in a location subject to:

– high humidity

– high temperature

– mechanical shock and vibration

– direct sunlight

Operation

• Do not move the drive while it is operating. It may cause malfunction.

• Avoid exposing the drive to sudden changes from a low to high in

temperature. This may cause water condensation to collect inside the

drive. If the ambient temperature should suddenly rise while the drive is

turned on , wait at least one hour before turning on the drive. If you

attempt to operate the drive immediately after a sudden increase in

temperature, a malfunction may occur.

• Turning off the power to the drive while it is writing to tape may cause

the tape to become unreadable. All previously negotiated parameters will

be lost, whenever power to the drive is cycled.

• Upon execution of the hardware reset hole, the driver will be reset and

there is a risk of lost and unreadable data. Thus, please do not use the

hole other than repair purposes. (See page 15)

Transportation

• Keep the original packing materials to facilitate transportation of the

drive.

• Always remove the tape before moving the drive. After removing the

drive from the computer, repack the drive into its original packing.

Notice of SCSI Termination

The SDX-700C and SDX-710C conform to the Microsoft PC97 standard

which requires the internal (naked) drive to be terminated with an external

terminator.

Microsoft PC97 SCSI requirements

SCSI peripherals must not terminate the bus. Both internal and external cable ends are

instead terminated by plug-in connectors.

Terminato

68p cable

Host Computer Wide SCSI

This drive

Example of SCSI set-up

Installation

SCSI Connection/Setting the SCSI ID (SDX-700C)

SCSI 68pin Connector

5 V

Power Connector

1234

GND GND 12 V

Disable

Enable

Parity

Note :

= CLOSED/Jumper

Don’t care

OPEN/Jumper not

installed

Parity Disable

No Connection

SCSI ID 3

SCSI ID 2

SCSI ID 1

SCSI ID 0

Jumpers

SCSI ID

P.D.

N.C.

Parity Disable Jumper

Parity check function can be disabled by Jumper. Parity check is disabled

while left end jumper is installed. Parity generate function is always

enabled.

SCSI Connection/Setting the SCSI ID (SDX-710C)

SCSI 68pin Connector

5 V

Power Connector

1234

GND GND 12 V

Disable

Enable

Parity

Note :

= CLOSED/Jumper

Don’t care

OPEN/Jumper not

installed

Parity Disable

No Connection

SCSI ID 3

SCSI ID 2

SCSI ID 1

SCSI ID 0

Jumpers

SCSI ID

P.D.

N.C.

Parity Disable Jumper

Parity check function can be disabled by Jumper. Parity check is disabled

while left end jumper is installed. Parity generate function is always

enabled.

Option Switches (DIP Switch)

DIP Switch Positions

12345678

DIP Switch

1 Reserved (OFF)

2 Reserved (OFF)

3 Reserved (OFF)

4 Reserved (OFF)

5 Terminator Power (ON)

6 Reserved (OFF)

7 DC Control (1) (ON)

8 DC Control (2) (OFF)

Data Compression Control DIP switch

Data compression can be selected by DIP switches. Data compression is

enabled while position 7 [DC Control (1)] is ON. Control by host can be

disabled when position 8 [DC Control (2)] is ON.

Mounting Holes

For 3.5" Standard Height (SDX-700C)

155.0±0.5 mm

(6.10 in)

7.0±0.5 mm

(0.28 in)

92.71 mm (3.65 in)

94.0±0.3 mm (3.70±0.01 in)

101.6±0.5 mm (4.00±0.02 in)

70.0±0.3 mm

(2.76 in)

42.0±0.3 mm

(1.65 in)

31.0±0.3 mm

(1.22 in)

3-M3 (depth

2.5mm (0.10 in) max.)

6-M3 (depth

2.5mm (0.10 in) max.)

4.7±0.5 mm

(0.185 in)

8 mm (0.315 in)

5.0±0.3 mm

(0.20 in)

7.4±0.3 mm

(0.29 In±0.01 in)

41.2±0.5 mm

(1.62 in)

90.0±0.3 mm (3.54 in)

60.0±0.3 mm (2.36 in)

21.0±0.3 mm

(0.83 in)

7.6±0.5 mm

(0.30 in)

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Almacenamiento de Sony

Sony

Sony SxS-1 Manual de usuario

Sony

Sony IJ1001M Manual de usuario

Sony

Sony CompactFlash NCFB1G Manual de usuario

Sony

Sony MSG-64A Manual de usuario

Sony

Sony SF-M64T Manual de usuario

Sony

Sony GY-8240FC Manual de usuario

Sony

Sony HD-EG5U Manual de usuario

Sony

Sony AITe90-UL Manual de usuario

Sony

Sony PWS-4500 Manual de usuario

Sony

Sony HD-E1 Manual de usuario

Sony

Sony StorStation AITi100 Manual de usuario

Sony

Sony Pro Duo MSX-M512S Manual de usuario

Sony

Sony M2 MS-A Series Manual de usuario

Sony

Sony SL-BG1 Manual de usuario

Sony

Sony IJ1001SNBT Manual de usuario

Sony

Sony SDT-S11000 Manual de usuario

Sony

Sony DSR-DU1 Manual de usuario

Sony

Sony HDPS-M10 - Data Storage Wallet Manual de usuario

Sony

Sony PHU-220R Manual de usuario

Sony

Sony CDL1100 Manual de usuario

Sony

Sony HDPS-M1 Manual

Sony

Sony HD-E Series Manual de usuario

Sony

Sony XQD QD Series Manual de usuario

Sony

Sony SDT-S9000/BM Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario