Sony SPP-A947 Manual de usuario

3-043-640-21 (1)

Operating Instructions

Mode d’emploi

SPP-A947

Cordless

Telephone

with Answering System

2US

WARNING

To prevent fire or shock hazard, do

not expose the unit to rain or

moisture.

To avoid electrical shock, do not open

the cabinet. Refer servicing to

qualified personnel only.

INDUSTRY CANADA NOTICE

NOTICE: The Industry Canada label

identifies certified equipment. This

certification means that the equipment

meets certain telecommunications

network protective, operational and

safety requirements as prescribed in the

appropriate Terminal Equipment

Technical Requirements document(s).

The Department does not guarantee the

equipment will operate to the user’s

satisfaction.

Before installing this equipment, users

should ensure that it is permissible to be

connected to the facilities of the local

telecommunications company. The

equipment must also be installed using

an acceptable method of connection.

The customer should be aware that

compliance with the above conditions

may not prevent degradation of service

in some situations.

Repairs to certified equipment should be

coordinated by a representative

designated by the supplier. Any repairs

or alterations made by the user to this

equipment, or equipment malfunctions

may give the telecommunications

company cause to request the user to

disconnect the equipment.

Users should ensure for their own

protection that the electrical ground

connections of the power utility,

telephone lines and internal metallic

water pipe system, if present, are

connected together. This precaution may

be particularly important in rural areas.

Caution: Users should not attempt to

make such connections themselves, but

should contact the appropriate electric

inspection authority, or electrician, as

appropriate.

NOTICE: The Ringer Equivalence

Number (REN) assigned to each

terminal device provides an indication

of the maximum number of terminal

allowed to be connected to a telephone

interface. The termination on an

interface may consist of any

combination of devices subject only to

the requirement that the sum of the

Ringer Equivalence Number of all the

devices does not exceed 5.

IMPORTANT INSTRUCTION TO

USERS

Your model (SPP-A947) has been

approved by the Industry Canada.

Note

Operation is subject to the following two

conditions: (1) this device may not cause

interference, and (2) this device must

accept any interference, including

interference that may cause undesired

operation of the device.

Privacy of communications may not be

ensured when using this telephone.

DIGITAL SECURITY CODE

Your SPP-A947 has a random digital

security code which automatically

selects one of over 65,000 digital security

codes.

3US

Table of contents

Getting Started

4 Read this first

5Step 1: Checking the package

contents

6Step 2: Setting up the base phone

9 Step 3: Preparing the battery

pack

11 Identifying the parts

Basics

14 Making calls

16 Redialing

17 Receiving calls

Telephone Features

18 Speed dialing

18 Storing phone numbers on the

handset

19 Storing phone numbers on the

base phone

20 Making calls with speed

dialing on the handset

20 Making calls with speed

dialing on the base phone

21 Setting the ringer type

21 Turning off the ringer

22 Checking the ringer type

22 Adjusting the ringer volume

level of the base phone

23 Switching the phones during a

call

23 To switch from the base

phone to the handset

24 To switch from the handset

to the base phone

25 Talking between the handset and

the base phone (Intercom)

25 To talk from the handset to

the base phone

26 To talk from the base phone to

the handset

27 Transferring a call

27 To transfer from the base

phone to the handset

28 To transfer from the handset

to the base phone

29 Having a three-way conference

29 To join the phone

conversation

Answering Machine

Features

Setting up the answering machine

30 Setting the time and day of

the week

31 Recording the greeting

33 Setting the number of rings

34 Setting the audible message

alert

35 Turning on the answering

function

37 Playing back messages

38 Adjusting the speaker volume

38 Erasing messages

40 Selecting the Announcement

Only Mode

41 Screening calls

42 Recording a memo message

43 Operating from an outside phone

43 Setting the remote ID code

(security code)

44 Picking up new messages

Additional Information

Mounting the base phone on a wall

46 Notes on power sources

47 Maintenance

48 Troubleshooting

51 Specifications

52 Index

Getting Started

4US

Getting Started

Base phone

Read this first

Before you use your phone, you must first set it up. Here’s a quick way

to set up your phone: Steps 1, 2 and 3.

Step 2 (pages 6 to 8)

Next, you need to do three things to set

up the base phone, including finding the

best location for the base phone.

Step 3 (pages 9 to 10)

Then, insert the battery pack into the

handset and charge it for more than 12

hours.

First, unpack the phone and the supplied

accessories.

Step 1 (page 5)

That’s it!

Handset

About the digital security code

The cordless telephone uses a digital security code to provide protection against unwanted

access to your base phone.

The security code blocks other cordless handsets to make calls through your base phone.

A random security code will be assigned automatically between your base phone and

handset when you charge the battery pack for the first time.

Getting Started

5US

Getting Started

HandsetAC power adaptor (AC-T129) Base phone

Rechargeable battery

pack (BP-T18)

Step 1

Checking the package contents

Make sure you have received the following items in the package.

If anything is missing, contact your local Sony dealer.

Directories (2)

Telephone line cords (2) Wall bracket/stand

for base phone

SPEED DIALING

Getting Started

6US

Step 2

Away from television

sets and other

electronic equipment

Away from a microwave

oven

Away from excessive

moisture, extremely low

temperatures, dust,

mechanical vibration, or

shock

Away from a personal

computer

Away from another

cordless telephone

Near a central location

and on a level surface

Away from heat sources, such as radiators,

airducts, and sunlight

Away from noise sources such as a window

by a street with heavy traffic

CAUTION: • Should you experience intermittent loss of audio during a conversation, try

moving closer to the base or move base phone away from other noise sources.

• The cordless telephone operates at a frequency that may cause interference to

nearby TVs and VCRs; the base phone should not be placed near or on the top

of a TV or VCR; and, if interference is experienced, moving the cordless

telephone farther away from the TV or VCR will often reduce or eliminate the

interference.

Setting up the base phone

Do the following steps:

• Choose the best location

• Connect the base phone

• Choose the dialing mode

Choose the best location

Where you place the base phone affects the reception quality of the

handset.

Getting Started

7US

Getting Started

continued

If you want to use the wall bracket as the stand, attach it on the bottom

of the base phone before step 1 as illustrated above.

1Connect the telephone line cord

to the LINE jack and to a

telephone outlet.

2Connect the AC power adaptor

to the DC IN 9V jack and to an

AC outlet.

3Raise the antenna. Make sure it

points towards the ceiling.

Connect the base phone

If you want to hang the base phone on the wall, see page 45.

To LINE

To DC IN 9V

To an AC outlet

To the

telephone outlet

Telephone line cord

(supplied)

AC power adaptor

(supplied AC-T129)

Align the

fmarks.

Route the code

Getting Started

8US

Notes

• Use only the supplied AC-T129 AC power adaptor.

Do not use any other AC power adaptor.

• Connect the AC power adaptor to a continuous power

supply.

• Place the base phone close to the AC outlet so that

you can unplug the AC power adaptor easily.

Tip

If your telephone outlet is not modular, contact your

telephone service company for assistance.

Choose the dialing mode

For the telephone to work properly, select an appropriate dialing mode

(tone or pulse).

Depending on your dialing system, set the DIAL MODE switch as

follows:

If your dialing system is Set the switch to

Tone TONE

Pulse PULSE

If you aren't sure of your dialing system

Make a trial call with the DIAL MODE switch set to TONE.

If the call connects, leave the switch as is; otherwise, set to PULSE.

Step 2: Setting up the base phone (continued)

DIAL MODE switch

Polarity of the plug

–

Modular

Getting Started

9US

Getting Started

Preparing the battery pack

Charge the battery pack for more than 12 hours before you start using

your phone.

1Slide open the battery

compartment lid of the handset.

2Connect the battery connector

with correct polarity (black wire

goes on left side and red wire

goes on right).

3Close the battery compartment

lid.

4Place the handset on the base

phone.

The CHARGE lamp lights up

when the handset is properly

seated on the charge terminals

of the base phone. Charge the

battery pack for more than 12

hours so that the battery is fully

charged. The CHARGE lamp

remains lit even after charging

is completed.

BP-T18

Black

Red

CHARGE lamp

continued

Step 3

Getting Started

10US

Battery duration

A fully charged battery pack lasts for about:

• approx. 7 hours when you use the handset continuously.

• approx. 7 days when the handset is in standby mode.

Notes

• The battery pack will gradually discharge over a long period of time, even if

not in use.

• If you leave the battery pack in the handset without charging it, the battery

pack will be completely discharged.

It may require several times of charging to recover its full capacity.

To obtain the best performance from the battery

Do not place the handset on the base phone after each call. The battery

works best if the handset is returned to the base phone after two or

three calls. However, do not leave the handset off the base phone for a

long period of time as this will completely discharge the battery pack.

When to purchase a new battery pack

If the battery lasts only a few minutes even after 12 hours of charging,

the usable life of the battery has expired and needs replacement.

Contact your local Sony authorized dealer or service center, and ask

for a Sony BP-T18 rechargeable battery pack.

Note

Battery life may vary depending on usage condition and ambient temperature.

Step 3: Preparing the battery pack (continued)

Tabla de contenidos

Idiomas:

Otros manuales de Teléfono inalámbrico de Sony

Sony

Sony SPP-A9171 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-A400 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-M920 Primary Manual de usuario

Sony

Sony SPP-AQ500 - Cordless Telephone Manual de usuario

Sony

Sony SPP-A400 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-874 Manual de usuario

Sony

Sony SSP-SS964 Manual de usuario

Sony

Sony SPP-S2720 Manual de usuario

Sony

Sony SPP-ID975 - Cordless Telephone Manual de usuario

Sony

Sony SPP-ID975 - Cordless Telephone Manual de usuario

Sony

Sony SPP-A2480 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-A974 Manual de usuario

Sony

Sony SPP-SS961 - Cordless Telephone Manual de usuario

Sony

Sony SPP-A9171 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-ID970 - Cordless Telephone Manual de usuario

Sony

Sony SPP-A2780 - 2.4ghz Cordless Telephone Manual de usuario

Sony

Sony SPP-A940 - 900 Mhz Cordless Telephone Manual de usuario

Sony

Sony SPP-SS960 - Cordless 900 Mhz Telephone Manual de usuario

Sony

Sony SPP-S9001 - Cordless Telephone Manual de usuario

Sony

Sony SPP-A973 - Cordless Telephone With Answering... Manual de usuario

Sony

Sony SPP-S9101 - Cordless Telephone Manual de usuario

Sony

Sony SPP-SS960 - Cordless 900 Mhz Telephone Manual de usuario

Sony

Sony SPP-111 - Cordless Phone Page Manual de usuario

Sony

Sony SPP-71 Primary Manual de usuario

Manuales populares de Teléfono inalámbrico de otras marcas

3Com

3Com NBX Manual de usuario

Panasonic

Panasonic KX-TGK210HK Manual de usuario

Panasonic

Panasonic KX-TCA181EX Manual de usuario

BT FREESTYLE 3200 Manual de usuario

AT&T

AT&T CL84102 Manual de usuario

BREZZICNI

BREZZICNI CL-3622 Manual de usuario

Panasonic

Panasonic KX-TG1831NZ Manual de usuario

Panasonic

Panasonic KX-TG7301E Manual de usuario

Furuno

Furuno FM-4721 Manual de usuario

Sanyo

Sanyo CLT-J70 Manual de usuario

Amplicomms

Amplicomms BigTel 201 Manual de usuario

GE 26992 Manual de usuario

AT&T

AT&T E1812B Manual de usuario

Sanyo

Sanyo CLT-670 Manual de usuario

GE 15432970 Manual de usuario

Curtis

Curtis TC595 Manual de usuario

Gigaset

Gigaset Gigaset 3000 Micro Manual de usuario

Poly

Poly VVX D230 Guía de configuración