Sony CDX-F5500M Manual de usuario
1
Ver 1.0 2004. 05
Model Name Using Similar Mechanism CDX-F5500
CD Drive Mechanism Type MG-611MA-186//Q
Optical Pick-up Name KSS1000E
SERVICE MANUAL
E Model
CDX-F5500M
CD player section
Signal-to-noise ratio 120 dB
Frequency response 10 – 20,000 Hz
Wow and flutter Below measurable limit
Tuner section
FM
Tuning range FM tuning interval:
50 kHz/200 kHz switchable
87.5 – 108.0 MHz (at 50 kHz step)
87.5 – 107.9 MHz (at 200 kHz step)
Antenna terminal External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Usable sensitivity 9 dBf
Selectivity 75 dB at 400 kHz
Signal-to-noise ratio 67 dB (stereo),
69 dB (mono)
Harmonic distortion at 1 kHz
0.5% (stereo),
0.3% (mono)
Separation 35 dB at 1 kHz
Frequency response 30 – 15,000 Hz
AM
Tuning range AM tuning interval:
9 kHz/10 kHz switchable
531 – 1,602 kHz (at 9 kHz step)
530 – 1,710 kHz (at 10 kHz step)
Antenna terminal External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity AM: 30 µV
SPECIFICATIONS
Power amplifier section
Outputs Speaker outputs
(sure seal connectors)
Speaker impedance 4 – 8 ohms
Maximum power output 52 W ×4 (at 4 ohms)
General
Outputs Audio outputs terminal
(front, rear/sub switchable)
Power antenna/aerial relay control terminal
Power amplifier control terminal
Inputs TelephoneATT control terminal
Remote controller input terminal
BUS control input terminal
BUS audio input terminal
Antenna/aerial input terminal
Tone controls Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements 12V DC car battery
(negative ground)
Dimensions Approx. 178 ×50 ×181 mm
(w/h/d)
Mounting dimensions Approx. 182 ×53 ×161 mm
(w/h/d)
Mass Approx. 1.2 kg
Supplied accessories Card remote commander RM-X115
Parts for installation and connections (1 set)
Front panel case (1)
Design and specifications are subject to change without
notice.
• The tuner and CD sections have no adjustments.
Sony Corporation
e Vehicle Company
Published by Sony Engineering Corporation
9-877-870-01
2004E04-1
© 2004. 05
FM/AM COMPACT DISC PLAYER
2
CDX-F5500M
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
TEST DISCS
This set can playback CD-R and CD-ROM discs. The following
test discs should be used to check the capability:
CD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
CD-RW test disc TCD-W082L (Part No. J-2502-063-2)
optical pick-up
semi-fixed resistor
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
•Never reuse a disconnected chip component.
•Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
SERVICE NOTES
This label is located on the bottom of the chassis.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0OR DOTTED LINE
WITH MARK 0ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
3
CDX-F5500M
Notes on CD-Rs (recordable CDs)/CD-RWs (rewritable
CDs)
This unit can play the following discs:
Type of discs Label on the disc
Audio CD
MP3 files
•Some CD-Rs/CD-RWs (depending on the equipment used for
its recording or the condition of the disc) may not play on this
unit.
•You cannot play a CD-R/CD-RW that is not finalized∗.
•You can play MP3 files recorded on CD-ROMs, CD-Rs, and
CD-RWs.
•A CD-R/CD-RW to which a session can be added can be played.
∗A process necessary for a recorded CD-R/CD-RW disc to be
played on the audio CD player.
EXTENSION CABLE AND SERVICE POSITION
Whenrepairingorservicingthisset,connectthejig(extensioncable)
as shown below.
•Connect the MAIN board (CN350) and the SERVO board (CN2)
with the extension cable (Part No. J-2502-076-1).
zUNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40°C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350°C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
•Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
SERVO BOAR
D
CN2
J-2502-076-1
MAIN BOARD
CN350
4
CDX-F5500M
TABLE OF CONTENTS
1. GENERAL
Location of controls................................................................. 5
Card remote commander RM-X115........................................ 5
Connections ............................................................................. 6
2. DISASSEMBLY
2-1. Sub Panel Assy .................................................................... 7
2-2. CD Mechanism Block ......................................................... 8
2-3. Main Board ......................................................................... 8
2-4. Chassis (T) Sub Assy .......................................................... 9
2-5. Roller Arm Assy .................................................................. 9
2-6. Chassis (OP) Assy ............................................................. 10
2-7. Optical Pick-up ................................................................. 10
2-8. SL Motor Assy (M902) ..................................................... 11
2-9. LE Motor Assy (M903) ..................................................... 11
2-10. Servo Board....................................................................... 12
3. DIAGRAMS
3-1. IC Pin Descriptions ...........................................................13
3-2. Block Diagram –CD Section–........................................... 19
3-3. Block Diagram –Main Section–........................................ 20
3-4. Block Diagram –Display Section–.................................... 21
3-5. Circuit Boards Location .................................................... 21
3-6. Printed Wiring Boards –CD Mechanism Section–............ 22
3-7. Schematic Diagram –CD Mechanism Section (1/2)– ....... 23
3-8. Schematic Diagram –CD Mechanism Section (2/2)– ....... 24
3-9. Printed Wiring Board –Main Section– .............................. 25
3-10. Schematic Diagram –Main Section (1/2)– ........................ 26
3-11. Schematic Diagram –Main Section (2/2)– ........................ 27
3-12. Printed Wiring Board –Sub Section– ................................ 28
3-13. Schematic Diagram –Sub Section– ................................... 28
3-14. Printed Wiring Board –Key Section– ................................ 29
3-15. Schematic Diagram –Key Section–................................... 30
3-16. IC Block Diagrams............................................................ 31
4. EXPLODED VIEWS
4-1. Main Section ..................................................................... 34
4-2. Front Panel Section ........................................................... 35
4-3. CD Mechanism Section (1) ............................................... 36
4-4. CD Mechanism Section (2) ............................................... 37
4-5. CD Mechanism Section (3) ............................................... 38
4-6. CD Mechanism Section (4) ............................................... 39
5. ELECTRICAL PARTS LIST ........................................ 40
5
CDX-F5500M
SECTION 1
GENERAL This section is extracted
from instruction manual.
6
CDX-F5500M
Connections
7
CDX-F5500M
SECTION 2
DISASSEMBLY
Note : This set can be disassemble according to the following sequence.
Note : Follow the disassembly procedure in the numerical order given.
2-1. SUB PANEL ASSY
2
two claw
s
3
two claws
5
sub panel assy
1
two
screws
(+PTT 2.6
x
6)
CN101
4
2-1. SUB PANEL ASSY
(Page 7)
2-2. CD MECHANISM BLOCK
(Page 8)
SET
2-3. MAIN BOARD
(Page 8) 2-4. CHASSIS (T) SUB ASSY
(Page 9)
2-5. ROLLER ARM ASSY
(Page 9)
2-6. CHASSIS (OP) ASSY
(Page 10)
2-8. SL MOTOR ASSY (M902)
(Page 11)
2-10. SERVO BOARD
(Page 12)
2-7. OPTICAL PICK-UP
(Page 10) 2-9. LE MOTOR ASSY (M903)
(Page 11)
8
CDX-F5500M
2-2. CD MECHANISM BLOCK
2-3. MAIN BOARD
7
bracket (CD)
5
CD mechanism block
4
CN350
3
1
screw
(+PTT 2.6
x
6
)
2
screw
(+PTT 2.6
x
6)
6
two
screws
(+PTT 2.6
x
4)
1
three ground point screws
(+PTT 2.6
x
6)
insulating sheet
3
MAIN board
2
two
screws
(+PTT 2.6
x
8
)
9
CDX-F5500M
2-4. CHASSIS (T) SUB ASSY
2-5. ROLLER ARM ASSY
5
SENSOR board
6
chassis (T) sub assy
4
claw
3
claw
1
two
screws
(+P 1.7
x
2.2)
2
two
screws
(+P 1.7
x
2.2)
3
washer
4
worm wheel (RA)
5
roller arm assy
1
spring (RAL)
2
spring (RAR)
10
CDX-F5500M
2-6. CHASSIS (OP) ASSY
2-7. OPTICAL PICK-UP
4
washer
0
coil spring (damper)
9
two coil springs (damper)
qa
chassis (OP) assy
5
gear (LE1)
1
CN1
lever (D)
slider (R)
6
7
8
2
Remove the six solderings.
3
tension coil spring (KF)
1
tension coil spring (CHKG
)
2
chucking arm sub assy
3
screw
(+B 1.4
x
5)
4
rack (SL)
5
claw
6
main shaft
7
optical pick-up
Tabla de contenidos
Otros manuales de Reproductor de CD de Sony
Sony
Sony HCD-GPX555 Manual de usuario
Sony
Sony CDP-CE415 Manual de usuario
Sony
Sony D-EJ109 Operating Instructions (primary... Manual de usuario
Sony
Sony D-NE20 - Atrac Cd Walkman Manual de usuario
Sony
Sony CDX-HR70MS Manual de usuario
Sony
Sony CDP-CX53 - CD Changer Manual de usuario
Sony
Sony DVP-CX995V Operating Instructions (DVP-CX995V CD/DVD... Manual de usuario
Sony
Sony Cd Walkman D-F200 Manual de usuario
Sony
Sony D-NE700 Manual de usuario
Sony
Sony Walkman D-SJ303 Manual de usuario
Sony
Sony CDP-CX88ES - Es 200 Disc Cd Changer Manual de usuario
Sony
Sony SCD-CE595 Manual de usuario
Sony
Sony D-FJ75TR - Fm/am Portable Cd Player Manual de usuario
Sony
Sony Pressman TCM-16 Manual de usuario
Sony
Sony CFD-S23 Manual de usuario
Sony
Sony CDX-GT09 Manual de usuario
Sony
Sony XES-C1 Manual de usuario
Sony
Sony CDX-L600X - Fm/am Compact Disc Player Guía del producto
Sony
Sony CDX-GT570 Manual de usuario
Sony
Sony D-EG5 Manual de usuario
