Sony Z90 Manual de usuario
SONY Z90
CCTV PRODUCER MANUAL - CAMERA BASICS
FULL AUTO SETTINGS
CCTV Media Training // Intro to Camera // January 2019!
!1
IN THIS MANUAL
2 - SD Requirements
3 - Camera Accessories in the case & the Tripod
Setting up the Camera
4 - Battery & Charging
5 - SD Card - Inserting & Formatting
6 - Microphone & Audio Settings
8 - Turning the Camera on
9 - LCD Screen Display
Recording with the Z90
10 - Record Settings
11 - Record & Zoom Controls
12 - Thumbnail Playback - watching what you recorded
Z90 Settings
13 - Default Settings
14 - Navigating the Menu & Making Changes
15 - Camera Buttons Map
MEMORY CARD REQUIREMENTS
SONY z90
SDXC
Class 10 - U3 (or higher)
64 GB minimum
!2
INSIDE THE CASE
When you get your camera from CCTV It will come with the following items. You are responsible for each of
these items.
1. Camera (with Handle mount & lens cap)
2. Battery - 2 large
3. Shotgun Microphone
4. Wired Remote
5. Headphones
6. AC Adapter
TRIPOD
Follow the instructions for how to set up and use the Tripod.
Be sure to unlock the pan/tilt options when using. You should never have to force the camera to move.
1. Tripod Plate
2. Safety Latch
3. Release Nob
4. Handle
5. Pan Lock
6. Pan Adjust (red)
7. Tilt Lock
8. Tilt Adjust (red)
9. Head Adjust
When Indoors - be sure to check that the rubber feet protectors are screwed out the whole way to cover the
spikes. Only use spikes outdoors or in approved places - they can damage floors.
!3
1
2
3
4
5
6
1
2
3
4
5
6
7
8
9
BATTERY & CHARGING
ATTACHING THE BATTERY
The battery goes into the back of the camera under the eye cup. Make sure the arrow is
pointing towards the eye cup - place it in the slot and push up to click it into place.
REMOVING THE BATTERY
The battery release is located on the bottom of the camera. Slide the release & pull
the battery down to remove it from the camera.
CHARGING THE BATTERY
The battery charges while attached to the camera. You will find a DC
IN port to the right of the batter near the bottom of the camera -
open this tab and plug in the power adapter.
You can also plug in the camera while recording video however, it will
not charge the battery while recording.
!4
SD CARD SETTINGS
INSERTING & REMOVING YOUR SD CARD
Open the LCD display and locate the SD card door. Open the door & insert your SD
card. Cards will push in and click into place. To remove the card - push the card in to
release and it will pop out.
CARD RECORD SETTINGS
By default, the camera will be set to relay record. On the LCD screen you
will see this icon next to the record settings. When one card gets full, the
camera will start recording on the second card - if available.
If you have two cards inserted - you can use the “Slot Select” button (located above the SD cards) to choose
which card the camera will record onto.
If you are only using one SD card you will see this icon flashing icon in the middle of your LCD screen,
alerting you that it cannot relay record because there is only one card.
FORMATTING YOUR SD CARD
If you are using a new SD card - you should always format it in the
camera before using.
If you use an SD card in a new camera (different make or model of
cameras) you should format the card to that camera so it can build the
correct file managements systems to properly save your media.
If you had any problems with the card, or have deleted files from the
card on a computer - it is smart to reformat the card before recording
new media as well.
!5
SETTING UP THE CAMERA AUDIO
When you set up your camera you will also need to set up the Audio. As a default setting, if the
microphone is not attached NO AUDIO will record.
ATTACHING THE MICROPHONE
Open the Mic latch & place the microphone into the holder. Make sure
the rubber holder is positioned in the camera latch correctly.
Clip the latch shut & plug the XLR cable into “INPUT 1”.
Make sure the XLR cable is fully connected, you should hear it click into
place.
To remove the cable, hold down the metal tab and pull the cable out.
SINGLE MICROPHONE SETTINGS
When using only the shotgun microphone with
automatic settings the audio panel should be set to
these settings.
CONTORL OPTIONS
ATT (Attinuation) - Will lower the max recording
volume by 10db or 20db.
INPUT - LINE: mix from sound board, MIC: powered
mic, MIC +48v: Phantom power for microphone
LOW CUT - cuts out the lowest frequency sounds (cuts wind noise & electric hum)
CH VOLUME - AUTO/MANUAL switch & volume level wheel
DOUBLE MICROPHONE SETTINGS
To have multiple audio sources plugged into the camera
you need to change the REC CH SELECT to CH1.
This will split the controls and record INPUT 1 and
INPUT 2 onto separate channels that you will mix
later.
You will hear the audio from INPUT 1 in your LEFT ear
and the audio from INPUT 2 in your right ear.
At this point you can adjust the input settings individually.
!6
INPUT 1
CONTROLS
INPUT 2
CONTROLS
CHECKING YOUR AUDIO
If your audio is set up correctly, you will see movement on
the audio indicators on the LCD screen. If only one channel
is moving, you may have the “REC CH SELECT” set to the
wrong setting for the microphones you are using.
USING THE HEADPHONES TO CHECK AUDIO
Always check your audio using headphones. Seeing the audio level indicator
move does not guarantee good audio.
The headphone input is found under the SD card slot. Open the door and
connect the Headphones.
If you’re using two microphones you should hear INPUT 1 in your left ear and INPUT 2 in your right ear.
If you’re using one microphone you should hear it in both ears. !
!7
TURNING THE CAMERA ON
You can turn the camera On opening either the LCD display or the Eye Cup. When the camera
is on - the Power Indicator will glow green.
If the camera is actively recording - you can close both the LCD display and eyecup
and the camera will continue to record.
If the LCD display AND eye cup are open - the eyecup will turn on/off via a
sensor located on the eye cup - when activated the LCD display will turn off.
TURNING THE CAMERA OFF
To turn the camera off simply shut the LCD display or eye cup. Make sure the camera is fully off before
removing the battery. If the camera is still on the Power Indicator light will be on.
Both the eye cup and the LCD door must be closed for the camera to power off.
!8
Pull Out
eyecup
Flip Open
LCD panel
Power
indicator
LCD SCREEN
1 - Battery life
2 - SD Card status
3 - SD card capacity
4 - Audio Indicators
5 - Exposure Settings (Iris, Gain,
Shutter)
6 - ND filter indicator
7 - Manual focus indicator
8 - Recording Settings
9 - SD Card Settings (Relay / Simul)
10 - NO card indicator
!9
1
2
3
4
5
6
7
8
9
10
RECORD SETTINGS
The camera should be set to the CCTV Default settings when you receive it (settings can be found in the back
of this manual). Double check that the video resolution & quality is correct - or change it to the settings you
want to use.
AUTOMATIC CAMERA SETTINGS
For basic shooting make sure the Auto/Manual switch is set to Auto.
FOCUS SETTINGS
On your screen (see location below) look and make sure your camera is
set to Auto Focus. If you see this icon on the screen you are in Manual
Focus.
Press the AF/MF button to change back to Auto Focus (the hand icon will
disappear if you are in Auto Focus).
ND Filters
The camera will let you know if you need to turn on or off the ND filters. Check
the LCD screen for an indicator. It will flash a number, to tell you which to turn
on, or say off to indicate that you need to turn them off.
Video Resolution
The video resolution settings are found on the top left of the LCD screen. It should look like the picture
below. If not - or if you need to change it from the CCTV default settings you can change the recording
quality in the menu under “Menu > REC/OUT SET > REC SET”
!10
Tabla de contenidos
Otros manuales de Videocámara de Sony
Sony
Sony Handycam DCR-HC48 Manual de usuario
Sony
Sony Handycam HDR-CX330E Guía de referencia
Sony
Sony DCR-SR65 - 40gb Hdd Handycam Camcorder Manual de usuario
Sony
Sony Handycam DCR-HC90 Manual de usuario
Sony
Sony Handycam DCR-PC350E Manual de usuario
Sony
Sony Handycam DCR-TRV230E Manual de usuario
Sony
Sony Handycam HDR-HC9 Manual de usuario
Sony
Sony ILCE-7 a7 Manual de usuario
Sony
Sony HDR-PJ230 Manual de usuario
Sony
Sony Handycam DCR-HC62 Manual de usuario
Sony
Sony BRCH900 Manual de usuario
Sony
Sony RM-LVR2V Instrucciones de funcionamiento
Sony
Sony Digital betacam DVW-707P Manual de usuario
Sony
Sony CCD TRV 10 Manual de usuario
Sony
Sony DVCAM DSR-PD150P Manual de usuario
Sony
Sony HDR-XR500V Manual de usuario
Sony
Sony BETAMOVIE BMC-220 Manual de usuario
Sony
Sony DCR-TRV240 Manual de usuario
Sony
Sony DCR-PJ5E/SR21E/SX21E Manual de usuario
Sony
Sony DCR VX2100 - Handycam Camcorder - 380 KP Manual de usuario
