4
8. Cancel alarm: During standby mode, when “Clock” icon is on, press TIMER button (7), “Clock” icon will be off.
Snooze function
Press “SNOOZE” button on the remote control when alarm in active, alarm will be silent for 10 minutes. After
10-minutue snooze interval, alarm will be active again. Snooze can be used for repeatedly within the 1-hour alarm
active interval.
Timer function
1. Push the POWER KNOB (18) till the STANDBY INDICATOR (15) light off. Unit is turning from standby mode to
operation mode.
2. When the unit is turned on, press SLEEP button (7) repeatedly to choose the sleep time minutes from
90>80>70…..>10 off.
3. Sleep time setting is stored when the “SLEEP” icon lights up on the display.
4. When the Sleep Time Minutes is over, unit will be switched to standby mode automatically.
Listening to Radio
Radio tuning
1. Press FUNCTION button (8) to select “TUNE” mode.
2. Select the desired band by RADIO BAND button (3) (AM or FM).
3. Search for a station by pressing SKIP UP (13) or SKIP DOWN (2) button for 1-2 seconds, and then release.
4. The unit will start seeking automatically and stop when a radio station is found.
Manual preset radio stations
1. When the desired radio station is found, press MODE button (5), program number will be flashing.
2. Press PRESET UP (13) or PRESET DOWN (2) button to choose the program number for storing the desired radio
station.
3. Press MODE button (5) again to confirm, program number will stop to flash.
4. Perform as step 2 & 3 to preset more radio stations.
5. Press PRESET UP (13) or PRESET DOWN (2) to choose the preset radio stations.
6. The number of stations can be found and stored depends on the reception of different area and countries.
Auto preset radio stations
1. During radio mode, press the PLAY/PAUSE button (4), the unit will automatically scan the radio frequency. When
the clear signal isfound, it will automatically store the radio station, starting from program 1.
2. The number of stations can be found and stored depends on the reception of different area and countries.
FM & FM-stereo reception
Press “FM ST.” button on the remote control to select FM mono or FM stereo mode. When stereo signal are weak,
it is preferable to receive the program in mono.
“ST” icon light up on the display to showFM stereo mode is receiving.
Hints for better reception
1. AM: there is a built-in AM bar antenna. If AM reception is weak, slightly rotating or re-positioning of the unit will
usually improve the AM reception.
2. FM : the receiver has a built-in FM wire antenna hanging at the rear cabinet. This wire should be totally unraveled
and extendedfor best reception.
FM & FM-stereo radio encoding
1. Press FUNCTION button (8) to select “TUNE” mode and select the desired band by RADIO BAND button (3) (AM
or FM).
2. Insert memory device (USB drive, SD or MMC card).
3. Press the REC button (6), it will take 3-5 seconds to read memory device. Then USB or SD icon will be flashing.
4. Press SKIP UP (13) or SKIP DOWN button (2) to select desired mode (USB or SD) for encoding. Then
press the REC button (6) again to confirm. And the system is starting the encoding mode after few seconds.
5. If only USB drive, SD or MMC card is inserted, step 4 can be skipped.
6. The USB or SD icon will be flashing on the display during encoding.
7. To finish encoding, press STOP button (3) and display will show “END” and return to “TUNE” mode.
