4 Wave User Manual
Version 2
5.7.5 SETTING A GATE ON A SCAN PLAN VIEW 27
5.7.6 SETTING UP AN ADAPTIVE GATE IN GATE MODE 27
5.8 ALARMS 28
5.8.1 ALARM ON-SCREEN LED COLOURS 29
5.8.2 COMPLEX ALARMS 29
5.9 MEASUREMENT BAR 30
5.9.1 MEASUREMENT DEFINITIONS 32
5.9.2 MEASUREMENTS REFERENCE TABLE 33
5.9.3 MEASUREMENT VALUES 37
5.9.4 MEASUREMENT COORDINATES REFERENCES 37
5.9.5 MEASUREMENTS UNITS 38
5.10 TOOLBAR MENU ITEM 38
5.10.1 FULL SCREEN MODE 38
5.10.2 SAVE A CONFIGURATION 39
5.10.3 QUIT AN APPLICATION 39
6THE PROBE SELECTION 40
7THE FILTERS 42
7.1 SETTING A FILTER 42
8THE PART WIZARD 44
8.1 PART TYPES 44
8.1.1 PART TYPE DIMENSIONS 44
8.2 WELD TYPES 45
8.2.1 WELD DIMENSIONS 47
8.3 WIZARD 48
8.3.1 PART VIEW 49
9THE SCAN PLAN VIEW 49
9.1 SCAN PLAN MENU ITEM 49
9.2 MOVING A PROBE 50
10 AUTO CAL AND SIZING METHODS 51
10.1 AUTO CAL 51
10.2 DAC 51
10.2.1 CREATE A DAC CURVE 51
10.2.2 DAC SIZING OPTIONS 53
10.2.3 ABSOLUTE AND RELATIVE DAC GAIN MODE 53
10.2.4 AMPLITUDE CORRECTED AND UNCORRECTED MEASUREMENTS 54
10.3 TCG 55
10.3.1 CREATE A TCG CURVE 55
10.3.2 TCG SIZING OPTIONS 57
10.4 DGS 57
10.4.1 PERFORMING A DGS CALIBRATION 57
10.4.2 DGS SIZING OPTIONS 59
10.5 AWS 59
