SOMFY Sunis WireFree RTS Light Sensor Manual de usuario

Sunis indoor

WireFree™ RTS

Ref : 5066683A

Installation guide

Guía de instalación

Guia de instalação





www.somfy.com

Somfy hereby declares that this product conforms to the essential

requirements and other relevant provisions of Directive 1999/5/EC.

A Declaration of Conformity is available at www.somfy.com/ce. Images are

not contractually binding.

Installation guide page 1

Por la presente, Somfy declara que este producto cumple con los requisitos

básicos y demás disposiciones de la Directiva 1999/5/CE. Podrá consultar

una declaración de conformidad en la página web www.somfy.com/ce.

Las imágenes no son contractualmente vinculantes.

Guía de instalación página 15

Pelo presente documento, a Somfy declara que o aparelho está em

conformidade com as exigências fundamentais e outras disposições

pertinentes da directiva 1999/5/CE. Está disponível uma Declaração de

Conformidade em www.somfy.com/ce. As imagens não têm vinculação

contratual.

Guia de instalação página 29

   43

 " ,#) #", Somfy +  ) %) " ,#"() %μμ"#+ 

μ$ "%+$ ,$  $ ",$ &$ !$ $

$ 1999/5/. ' %μμ)#'$   *% 

www.somfy.com/ce.  ) $    %μ μ%$.

Installation guide

Sunis indoor WireFree™ RTS

1. Introduction 2

2. Safety 2

2.1. Safety and liability 2

2.2. Speciﬁc safety advice 3

3. Contents 4

4. The Sunis indoor WireFree™ RTS in detail 4

5. Commissioning 5

5.1. (OFF/ ) selector switch 5

5.2. Adding/Deleting a Sunis Indoor WireFree™ RTS 5

5.3. Positioning of the Sunis Indoor WireFree™ RTS 6

5.4. Sunlight simulation 7

5.5. (Mode) button 8

5.6. Setting the sunlight threshold 9

6. Use 10

7. Tips and recommendations 12

7.1. Questions about the Sunis Indoor WireFree™ RTS? 12

7.2. Replacing the battery 13

8. Technical data 14

CONTENTS

Installation guide

Sunis indoor WireFree™ RTS

1. Introduction

The Sunis Indoor WireFree RTS is a wireless solar sensor that

transmits radio signals using Radio Technology Somfy (RTS).

Depending on the detected level of sunlight intensity, the sensor

sends a raise or lower order to the motors or RTS receivers.

This permits automatic control of the sun protection end-products that

protect your interiors (e.g. your furniture, plants, etc.) and to assist

you in saving energy (in summer only).

2. Safety

2.1. Safety and liability

Before installing and using this product, please read this guide

carefully.

This Somfy product must be installed by a professional motorisation

and home automation installer, for whom this guide is intended.

Moreover, the installer must comply with the current standards and

legislation in the country in which the product is being installed, and

inform the customer of the operating and maintenance conditions for

the product.

Any use outside the sphere of application speciﬁed by Somfy is

prohibited. Doing so would void the warranty and releases Somfy of

all liability, as does any failure to comply with the instructions given

herein.

Never begin installing without ﬁrst checking the compatibility of this

product with the associated equipment and accessories.

Installation guide

Sunis indoor WireFree™ RTS

2.2. Speciﬁc safety advice

To avoid damage to the product:

1) Never immerse it in a liquid!

2) Avoid sharp bumps or blows!

3) Do not let it fall!

4) Never pierce it!

5) Do no use abrasive products or solvents to clean the product.

6) Keep out of the reach of children.

Installation guide

Sunis indoor WireFree™ RTS

3. Contents

1 Sunis indoor WireFree™ RTS

1 Suction cup

4. The Sunis indoor WireFree™ RTS in detail

Protective front covera) Sun sensorb) Batteryc) Rear coverd) Sunlight detection areae) Suction cupf) Potentiometer for setting the sunlight thresholdg) Sun LEDh) (OFF/i) ) selector switch

Programming button (PROG)j) (Mode) buttonk) b gdc jka h if

Installation guide

Sunis indoor WireFree™ RTS

5. Commissioning

5.1. (OFF/ ) selector switch

Slide the (OFF/ ) selector switch to to activate the sunlight

sensor functions.

OFF

Sunlight function inactive

(PROG) button inactive.

(Mode) button inactive.

Sun LED inactive (No energy

consumption).

Sunlight function active

(sun LED glows for 5 seconds).

(PROG) button active.

(Mode) button active.

Sun LED active.

5.2. Adding/Deleting a Sunis Indoor WireFree™ RTS

Theprocedureforaddingordeletingasensor

is the same.

To add or delete a Sunis Indoor WireFree™

RTS, use the RTS control point already

programmed to the end-product.

Slide the (OFF/1) ) selector to .

Press on the sides of the front protective2) cover and pull to remove it.

Installation guide

Sunis indoor WireFree™ RTS

Press and hold the (PROG) button on3) the already assigned RTS control point

until the end-product moves back and

forth: the motor or RTS receiver RTS

enters programming mode for 2 minutes.

Brieﬂy press the (PROG) button on the Sunis

Indoor WireFree™ RTS. The end-product

moves back and forth: the Sunis Indoor

WireFree™ RTS is programmed.

Repeat operations 3 and 4 for each of the end-

products to be assigned to this sensor.

5.3. Positioning of the Sunis Indoor WireFree™ RTS

Clean the surface on which the sensor is to be mounted.

Check that there is nothing that can cast a shadow on the sensor.

5.3.1. On an inside window sill

Screw the suction cup to the bottom of the1) sensor (A).

Moisten the suction cup.2)

Position the sensor with the sunlight intensity3) detection area (B) towards the exterior and

press on the sensor to ﬁx it in place.

Installation guide

Sunis indoor WireFree™ RTS

5.3.2. On the inside surface of a window

Screw the suction cup to the back of the1) sensor (C).

Moisten the suction cup.2) Position the sensor below the area to be3) protected by the end-product (D) and press

on the sensor.

5.4. Sunlight simulation

If you turn the potentiometer to the (-) position,

the sensor simulates continuous sunlight,

the LED glows green and the end-product is

lowered, stops level with the sensor and is then

raised slightly above the level of the sensor.

Do not leave the sunlight threshold setting at this level.

Installation guide

Sunis indoor WireFree™ RTS

5.5. (Mode) button

Brieﬂy press the (Mode) button to activate information mode.

Press and hold the (Mode) button to activate demonstration mode.

5.5.1. Information mode

- Brieﬂy press the (Mode) button to ﬁnd out the status of the sensor.

If the LED (red/green) ﬂashes: the sensor is in demonstration mode.

If the LED (red/green) is permanently lit: the sensor is in operating mode.

If the LED is red: the level of sunlight intensity is lower than the set

sunlight threshold.

If the LED is green: the level of sunlight intensity is greater than the

set sunlight threshold.

5.5.2. Demonstration mode

The very short response times in demonstration mode make it

possible to check the installation.

Do not change the sunlight threshold setting in demonstration

mode.

The same procedure is used to activate or deactivate

demonstration mode.

- Press and hold (>2 sec.) the (Mode) button to

activate or deactivate demonstration mode.

If the red/green LED ﬂashes for a few

seconds (30 sec.) then demonstration mode

is activated. > 2 s

Otros manuales para Sunis WireFree RTS Light Sensor

Tabla de contenidos

Idiomas:

Otros manuales de Accesorios de SOMFY

SOMFY

SOMFY animeo IB + Manual de usuario

SOMFY

SOMFY Sunis Manual de usuario

SOMFY

SOMFY inteo EOLIS RTS Manual de usuario

SOMFY

SOMFY SMART PLUG B-TYPE Manual de usuario

SOMFY

SOMFY SOLIRIS RTS Manual de usuario

SOMFY

SOMFY 1811482 Manual de usuario

SOMFY

SOMFY Sunea Screen 40 io Manual de usuario

SOMFY

SOMFY EOLIS WIREFREE RTS Manual de usuario

SOMFY

SOMFY Animeo LON Instrucciones de funcionamiento e instalación

SOMFY

SOMFY 2401219 Manual de usuario

SOMFY

SOMFY TaHoma 2401368 Manual de usuario

SOMFY

SOMFY inteo EOLIS RTS Manual de usuario

SOMFY

SOMFY EOLIS 3D Manual de usuario

SOMFY

SOMFY Freeroll RTS OSE Manual de usuario

SOMFY

SOMFY Sunis WireFree RTS Light Sensor Manual de usuario

SOMFY

SOMFY EOLIS WIREFREE IO Manual de usuario

SOMFY

SOMFY Animeo IB+ Manual de usuario

SOMFY

SOMFY SOLIRIS RTS Manual de usuario

SOMFY

SOMFY inteo EOLIS Manual de usuario

SOMFY

SOMFY CELL MASTER PRO BITECH Manual de usuario

SOMFY

SOMFY inteo Light sensor Manual de usuario

SOMFY

SOMFY Oximo WireFree Battery Stick Manual de usuario

SOMFY

SOMFY 6301051 Manual de usuario

SOMFY

SOMFY Soliris io Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario