SAFETY IS OUR
MAIN CONCERN
General instructions before riding:
1. Tire pressures: Check the tires for correct inflation and for any signs
of physical damage.
2. Brake check: Squeeze the brake lever (front and rear) as hard as you
can, push the scooter forward and check the braking resistance.
3. Safety Circuit Breaker: It is a safety switch placed under the seat. It
might be turned off when delivery and technical service, and it must
be turned on before riding.
4. Battery Check: Make sure your scooter is sufficiently charged for
your ride and always check the battery indicator while you are riding.
Be sure that battery does not get too low too often. Sometimes the
voltage meter on left side of dashboard would be more accurate than
bars battery indicator, this is normal because of lithium battery
properties. Always charge the battery before using and after every
use. More frequently charging is better for battery life.
5. Ready to ride: Make sure the side stand is removed and the kill-
switch is in “GO” position before riding. If some of that sensors are
not ready the scooter will not respond to the accelerator.
6. Steering: Check the handlebar for any damage. Squeeze the front
brake and push the handlebar up and down to check for any unusual
noise. Move the handlebar in all directions to check for any loose
parts or obstructions. Any problems should be corrected before use.
