Soloshot SOLOSHOT2 Manual de usuario
base & tag user guide
Important Usage Instructions
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
This device meets the requirements for RF exposure to humans when worn on the upper arm or against the body. In order to comply with FCC standards, this device should not be used in any other application
other than that described in this manual.
This device complies with Part 15 of the FCC rules. Changes or modifications to the device not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
When the transmitter is worn on the body, there may be increased risk of injury if the remote strikes a solid object or the ground. The transmitter has been designed to be worn as an armband for use in surfing,
but for other sporting activities, it may be preferable to be placed elsewhere (such as on the outside of a helmet or attached to a vehicle if used in motor sports). There is no one recommendation as it depends on
the activity, terrain, aggressiveness of the activity, and specific use. By using SOLOSHOT, user agrees to assume all risk and not hold Soloshot Inc. liable for injuries or damages in any way.
WARNING - CHOKING HAZARD - CONTAINS SMALL PARTS. KEEP OUT OF REACH OF CHILDREN.
WARNING - STRANGULATION HAZARD - CONTAINS A LONG POWER CORD THAT MAY CAUSE STRANGULATION IF USED IMPROPERLY. KEEP OUT OF REACH OF SMALL CHILDREN.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. (SOLOSHOT BASE)
TO REDUCE THE RISK OF ELECTRICAL SHOCK AND TO PREVENT UNDESIRABLE INTERFERENCE, ONLY USE THE RECOMMENDED ACCESSORIES.
COPYRIGHT WARNING: Unauthorized recording of copyrighted materials may infringe on the rights of copyright owners and be contrary to copyright laws.
CAUTION: Do not expose this product to excessive heat such as the inside of a car under direct sunlight, fire etc. To reduce the risk of electrical shock, do not dis-assemble the base station. No user-serviceable
parts inside. Refer servicing to qualified service personnel. Warranty voided if unauthorized service is performed.
CAUTION: Do not place more than a well balanced 5 lb load on the SOLOSHOT base.
CAUTION: To prevent electric shock, fully insert plug while charging.
Contains li-polymer battery. Battery must be recycled or disposed of properly.
Important Safety Instructions
In these safety instructions the word “product” refers to SOLOSHOT2 including the BASE, TAG and all of it’s accessories.
1. Read Instructions - All safety and operating instructions should be read completely and understood completely before the product is operated.
2. Retain Instructions - These safety and operating instructions should be retained for future reference. The operator of this equipment should, from time to time, review the manufacturers website for any new or
revised instructions, warnings and safety information.
3. Heed Warnings - All warnings on the product and in the operating instructions should be read, understood and adhered to.
4. Follow all instructions.
5. Do not expose BASE directly to water.
6. Do not place any part of SOLOSHOT2 near any heat sources such as radiators, heat registers, ovens, stoves, or other apparatus (including amplifiers) that produce heat.
7. Only use attachments and accessories specified or approved by the manufacturer of SOLOSHOT2.
8. Unplug this apparatus during lightning storms or when unused for long periods of time.
9. Refer all servicing to qualified service personnel approved by the manufacturer. Servicing is required when the apparatus has been damaged in any way, including power-supply cord or plug damage, liquids have
been spilled into or around the BASE or CHARGER or objects have fallen into the apparatus, the BASE or CHARGER has been exposed to rain or moisture, does not operate normally, or has been dropped.
10. Follow Instructions - All operating and maintenance instructions should be followed.
11. Cleaning – Clean BASE and TAG separately. Clean BASE only with a dry cloth. Unplug BASE from the wall outlet and completely detach CHARGER from BASE before cleaning. Only use a clean dry cloth to clean
the external surfaces of BASE. Do no use liquid or aerosol cleaners on BASE. Clean the TAG only by rinsing in fresh water. The product should be cleaned only as recommended in this manual.
12. Accessories - Only use accessories recommended in this manual as all other accessories may be hazardous.
13. Avoid magnetic or electric fields - Do not use SOLOSHOT2 close to TV transmitters, portable communication devices or other sources of electric or magnetic radiation. They may cause interference or permanent
damage to your SOLOSHOT2.
14. Water and moisture - ELECTRIC SHOCK HAZARD - Do not expose BASE or CHARGER to wet environments. The TAG is waterproof up to 10 ft but BASE and CHARGER are NOT waterproof or water resistant.
15. The TYP60-0901500u Compact Power Adapter (CHARGER) should be operated only from the type of power source indicated on the marking label (AC100 to 240V). If you are not sure of the power supply in your
home, consult your local power company. ONLY USE CHARGER AS DESCRIBED IN THIS INSTRUCTION MANUAL.
16. Power Cord Protection - The power cord of the CHARGER should be routed such that it is NOT likely to be walked on or pinched by items placed upon or against it. Pay particular attention to plugs and the point
from which the cords exit the product.
17. Objects and Liquid Entry - Never push objects of any kind into or through openings of BASE or TAG as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock or
damage to product. Be careful not to spill liquids of any kind on BASE or CHARGER.
18. Servicing - Do not attempt to service any part of SOLOSHOT2 yourself as opening or removing covers or otherwise removing or altering any component of SOLOSHOT2 may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel. Any attempt to access internal components will void manufacturers warranty.
19. Rinse TAG, CLIP and ARMBAND in fresh water after use in salt water.
Safety and Handling Review full Safety and Handling information in the SOLOSHOT2 User Guide
Videos and Tutorials For SOLOSHOT videos and tutorials visit www.soloshot.com/videos
-------------
1. Equipment Overview .....................................................................................
2. Important Information .....................................................................................
3. Advanced Settings - Base ...............................................................................
6. Advanced Settings - Tag .................................................................................
7. Multi Systems ..................................................................................................
8. Batteries & Charging ......................................................................................
9. Firmware Updates ...........................................................................................
pgs 6 - 9
pgs 10 - 13
pgs 14 - 23
pgs 24 - 29
pgs 30 - 45
pgs 46 - 47
pgs 48 - 49
Table of Contents
BASE
1. Tracking LED
2. Tilt Drum
3. Accessory Port
4. Mounting Screw
5. Accessory Release Button
6. K-Lock Port
7. USB Ports
(Mini & USB 2.0)
front side
7
6
EQUIPMENT OVERVIEW
BASE
7. Power Button
8. Mode Button
9. Pairing Button
10. Pan/Tilt Buttons
11. Mode LEDs
12. Antenna
13. Tripod Socket
back side
bottom
7
EQUIPMENT OVERVIEW
TAG
1. Charging/Docking
Contact
2. Power Button
3. Pairing Button
4. Status LEDs
5. Top Surface
8
EQUIPMENT OVERVIEW
CHARGING CABLETRIPOD TOOL ARM BANDCLIP
9
EQUIPMENT OVERVIEW
IMPORTANT!
You MUST read and understand the Cheat Sheet that
came with your product so you understand BASIC set up,
pairing and calibration before attempting the advanced
settings described in this manual.
SOLOSHOT is a robot! It assumes that you have
FOLLOWED THESE INSTRUCTIONS. While robots FREE us
from repetitive and time-consuming tasks, they do not
replace HUMAN CREATIVITY. So, please enjoy your
freedom and get creative!
10
LISTEN!
Otros manuales para SOLOSHOT2
1
Tabla de contenidos
Otros manuales de Accesorios para cámaras de Soloshot
