Disconnect source hose and pole
tubing.
Tip the system with inlet side up
and allow water to drain out of the
bypass.
Shut quick connect and attach the
outlet of the bypass to the system
inlet for water tight transport.
1. Shut o ow of pure water to
brush.
2. Fully open bypass. Allow bypass
to ush the system out for 3–5
minutes.
Shut Down Procedure 2
Shut Down Procedure 1
Optional
If your source water is over 200
TDS, or your output is over 10 TDS,
add a DI lter such as the Rover.
We recommend using 1/2” hose.
