10
The Easyboard connects the input
and output parts. The lines on top
of the board show which parts
will respond to each other. The
Easyboard also ensures that input
and output parts are supplied with
energy (power). Both input and
output parts need power to function.
The Easyboard has a standard
DC connector. The kit contains a
cable which has a USB and a DC
connector. You can use this to power
the Easyboard.
With the Easyboard you can make 4
dierent pairs of input / output.
The easyboard has an edge
connector which allows a Micro:Bit©
chip to attach to the board. From the
moment the Micro:Bit© is attached to
the easyboard, it will respond to the
programming on the Micro:Bit©. The
Micro:Bit© chip is easy to program,
see the programming manual on the
website (support page). Remove the
Micro:Bit© from the Easyboard and it
will respond as before.
The Easyboard
Output connector
Power connector
Edge connector
Input connector
