SOGEDIS D Series Manual de usuario
DISHWASHER
(D SERIES)
1
2.ELECTRICAL COMPONENTS AND MEASUREMENTS
2.1 ON / OFF SWITCH
It can’t be measured from the electronical card.
C
T
DOOR SWITCH
CN2.9 - CN2.2 0 Ω
KN2.8 - KN2.10 0 Ω
Door is close
2.2 DOOR LOCK
It is a mechanical lock/release system that is closing the door, supplying the connection of electrical parts in
the machine and cutting off the connection.
From the electronical card:
C
T
DOOR SWITCH
CN2.9 - CN2.2 0 Ω
KN2.8 - KN2.10 0 Ω
Door is close
2.3 CIRCULATION PUMP
Single direction, single phase, asynchronus and two pole. It turns opposite clock direction. It is assambled
to the basement with rubber hangers.
From the electronical card:
You can only measure the primary winding value from the electronical card. Resistance value of the
primary winding must be;
4
C
T
CIRCULATION PUMP
CN2.3 - CN2.9
KN2.3 - KN 2.8
Primary winding
Secondary winding (from
the component)
Above sketch show the connectors of the washing pump on the electronical card. Probes of the tester should
be applied on to the related connectors.
From the component:
A) B)
A) Measurement of the primary windings of the washing pump.(118.2-135.9 Ω)
B) Measurement of the secondary windings of the washing pump (white cable – blue cable)(117.9-135.6 Ω)
Probes of the tester should be applied on to the related connectors as shown on the pictures.
2.4 FLOATER
From the electronical card:
C
T
FLOATER
CN2.1 - CN 2.5
0 Ω
KN2.5 - KN 2.10
0 Ω
Mıcroswıtch ıs ınactıve (no
water ) mıcroswıtch ıs actıve
∞Ω
(MICROSWITCH)
CN2.1 - CN 2.4
∞Ω
KN2.4 - KN 2.5
(there ıs water)
5
Position 1: You can check the floater by controlling the specified value intervals.
Position 2: If failure code is occured related with the floater within control the above values: You can figure
out whether leakage occurs or not.
2.5 CAPACITOR
Capacitor is permanently connected to the circulation pump coils.
6
2.6 DRAIN PUMP
From the electronical Card:
Above sketch show the connectors of the drain pump on the electronical card. Probes of the tester should be
applied on to the related connectors.
From the component:
Probes of the tester should be applied on the related connectors as shown on the pictures.
2.7 HEATER
It can’ be measured from the electronıcal card.
From the component:
7
2.8 NTC
2.9 PRESSURE SWITCH
From the electronical card:
C
T
PRESSURE SWITCH
CN2.10 - CN2.2
0 Ω
KN2.9 - KN2.10
0 Ω
Full fıll water
∞Ω
∞Ω
No water
From the component:
8
2.10 DIVERTER
From the electronical Card:
Sketch above show the connectors of the diverter on the electronical card. Probes of the tester should be
applied on to the related connectors.
From the component:
Probes of the tester should be applied on to the related connectors as shown on the pictures.
2.11 WATER INLET VALVE
Single inlet and single outlet standard single coil selenoid valve.
From the electronical card:
C
T
WATER INLET VALVE
CN2.6 - CN2.9 4200 Ω ± %10 (20°C)
KN2.6 - KN2.8 4200 Ω ± %10 (20°C)
9
Above sketch show the connectors of the water inlet valve on the electronical card. Probes of the tester should
be applies on to the related connectors.
From the component:
Probes of the tester should be applied on to the related connectors as shown on the pictures.
2.12 REGENERATION VALVE
From the electronical card:
C
T
REGENERATION VALVE
CN2.2 - CN2.7 3560 Ω ± %10(25°C)
KN2.2 - KN2.10 3560 Ω ± %10(25°C)
10
Above sketch show the connectors of rhe regenaration valve on the electronical card. Probes of the tester
should be applied on to the related connectors.
From the component:
2.13 PARASITE FILTER
2.14 TURBO FAN MOTOR
From the electronical card:
C
T
FAN MOTOR
CN 6.2 - CN 2.9
KN 6.2 - KN 2.8
11
Above sketch shows the connectors of the fan motor on the electronical card.
From the comonent:
2.15 RINSE AID SENSOR
From the electronical card:
C
T
RINSE AID SENSOR
CN 5.3 - CN 5.2
0Ω NO RINSE AID
KN 50.8 - KN 50.9
0Ω NO RINSE AID
RINSE AID OFF
∞Ω THERE IS RINSE AID
∞Ω THERE IS RINSE AID
RINSE AID ON
12
Turbo fan resistance value: 265 ± %10 Ω (The resistance of the torbo fan is measured with the resistor switch).
Este manual sirve para los siguientes modelos
15
Otros manuales de Lavavajillas de SOGEDIS
