Snapper 1691827 Manual de usuario

Section A. General

This kit provides an add-on light and required

alternator for compact and large frame

snowthrowers with Tecumseh engines. Kit can be

installed on snowthrowers that are equipped with

cabs (hard or soft). See the appropriate section for

installation instructions:

Section Snowthrower Application

Section C.

Compact No Cab/Soft Cab

Section D. Large-Frame

No Cab/Soft Cab

Section E. Large-Frame

Hard Cab

Section B. Kit Parts

ITEM DESCRIPTION P/N

Alternator

1704.346

B. Self-Tapping Screw, l-114”

1704652

Self-Tapping Screw, :&I@“**

1704663

C. AC Ughtlng Connector

1704647

D. Spacer’

1704646

Centertng

Tube

1704649

F. Alternator Shaft, 3””

1704641

Alternator Shafl,

3-M”’

1704642

G. Headllght Assy.

1704644

H. Plastic Tie’

925094

CIIP

930222

HP Models “7, 6, 10 HP Models

QTY.

Figure 1.

INSTALLATION

INSTRUCTIONS

~~,

SNOWTHROWER HEADLIGHT KIT

MFG. NO. 1691827

Section C. Compact Snowthrower With

Sofi

Cab/

Without Cab.

1. Drill a 13/&Y hole, 5/8” from bottom and

centered (approx.

8-i/2”

from either end) on the

crossmember as shown in figure 2.

AD-815

:igure

2. Install light with capsorew, lockwasher, and nut

(lockwasher and nut towards rear).

3. Install alternator as provided in the Tecumseh

Installation Instructions. Use the appropriate

alternator shaft (F, figure 1) and self-tapping

screws (B).

4. Install clip and plastic ties as shown in figure 3.

This will prevent wire harness from interfering

with recoil starter.

‘1990

CLIP I I

”

-1

gure

FORM

1704651-02

PRlNTED IN U.S.A.

10190

‘I

Section D. Large Frame Snowthrower With Soft-

Cab/ No Cab. Section E. Large Frame Snowthrower With Hard

Cab.

1. Drill 13/32” hole in right-hand side channel, 3”

below auger drive handle and centered (approx.

i-3/4”),

as shown in figure 4.

_~~~

--.-

-._~~~~..

---~

.---

------l

NOTE

Hard cab should be installed first before

installing light kit.

Figure 4.

2. Install light with capscrew, lockwasher, and nut

(nut on inside).

3. Install alternator as provided in the Tecumseh

Installation Instructions. Make sure alternator is

installed with wire harness plug at the 3:00

position. Use the appropriate alternator shaft (F,

figure 1) and self-tapping screws

(B).

4. Install clip on upright as shown in figure 5 to

prevent wire from interfering with recoil starter.

Plastic ties provided with kit will not be used.

5. If soft cab is used, tuck the right-hand side of cab

around the light bracket

1. Drill 13/32” hole in the right hand side of thecab

frame, approx. 3/4” down and

l-1/2”

from

capscrew, as shown in figure 6.

2. Install light through cab frame with capscrew,

lockwasher, and nut (nut on inside).

3. Install clip on upright asshown in figure 5. Plastic

ties provided with the kit will not be used.

igure

,.’

,i,

Otros manuales de Soplador de nieve de Snapper

Snapper

Snapper 4220 Series Manual de operación y mantenimiento

Snapper

Snapper C3203 Manual de operación y mantenimiento

Snapper

Snapper 11305 Manual de operación y mantenimiento

Snapper

Snapper LE Manual

Snapper

Snapper XD ESXD20S82K Manual de usuario

Snapper

Snapper N10305E Manual de operación y mantenimiento

Snapper

Snapper 10305 Manual de operación y mantenimiento

Snapper

Snapper EI Manual de usuario

Snapper

Snapper XD 1696871 Manual de usuario

Snapper

Snapper 520E Manual de usuario

Snapper

Snapper ESS5220E Manual de usuario

Snapper

Snapper LE3171R (7085660 Manual de operación y mantenimiento

Snapper

Snapper 1694845 8560EI Manual

Snapper

Snapper mid frame Snowthrower Manual de usuario

Snapper

Snapper 1-4228 Manual de operación y mantenimiento

Snapper

Snapper 10305E Manual de usuario

Snapper

Snapper 105308E Manual de usuario

Snapper

Snapper L1226E Manual de usuario

Snapper

Snapper 3190E Manual

Snapper

Snapper Lady Garden 80426 Manual de usuario

Snapper

Snapper 10302 Manual de operación y mantenimiento

Snapper

Snapper 5201M Manual de usuario

Snapper

Snapper SS5200E Manual de usuario

Snapper

Snapper 1422 Manual de operación y mantenimiento

Manuales populares de Soplador de nieve de otras marcas

Murray

Murray 624504X4A Manual de usuario

Blizzard

Blizzard POWER PLOW 8100PP Manual de usuario

Craftsman

Craftsman 486.24837 Manual de usuario

Yard-Man

Yard-Man E2B5 Manual de usuario

ST ST 526 A Manual de usuario

MTD

MTD 3AA Manual de usuario

Toro

Toro Power TRX 1428 OHXE Manual de usuario

Ryobi

Ryobi RYAC800 Manual de usuario

Poulan Pro

Poulan Pro 416829 Manual de usuario

Poulan Pro

Poulan Pro 437986 Manual de usuario

MTD

MTD 319-180-00 Manual de usuario

Brute

Brute 1695565 Manual de usuario

Egholm

Egholm City Ranger 2250 Manual de usuario

Poulan Pro

Poulan Pro 420915 Manual de usuario

GreenWorks

GreenWorks SNF402 Manual de usuario

LOFTNESS

LOFTNESS 601D1 Manual de usuario

LOFTNESS

LOFTNESS 1082I Manual de usuario

LOFTNESS

LOFTNESS 481EL Manual de usuario