Power On/Off Operation
Click” ”key continually 3 times,to switch
on the SmrtMugg. The screen will display
real-time temperature, power consumption
and power words. If no operation after pow-
ering on, the screen will turn off and go into
standby mode. Wake up the screen when
you shake or touch the cup.
Power On Operation
When it is under standby mode, click “ “key
3 times continually, the screen displays
”GoodBye” and it is powered off. Under cir-
cumstances such as transportation, taking
a flight, etc., you may need to switch off all
its functions.
Power Off Operation
Heating Constant Temperature Mode
When In the standby mode, long press the
“ ” button ( 2 seconds), the screen dis-
plays “Set 860F” (the initial temperature or
set temperature of the last operation), press
the “ ” button to increase or decrease (long
press to increase quickly) Set the target
temperature. The temperature setting range
is 86°F~1500F. Click the “ “ button or leave
it for 3 to 5 seconds to enter the constant
temperature heating mode, and the screen
displays the real-time temperature.
When heated, the preset target temperature will increase rapidly and cycle if you long
press “ ” button. Click “ ” to adjust the heating temperature. The factory-set tem-
perature is 115°F, After the adjustment is completed, the preset target temperature will
be automatically saved when you boot the cup.
lf it is not operated, automatically enter the main interface of heating constant tempera-
ture after 3 seconds.
In the heating state, the screen shows “ 86°F”, which is the real-time temperature. “ ”
light on means constant temperature heating. “ ” flashing means actively heating. When
there are the following prompts, such as the cup tilts to one side, water shortage or pause
heating, please check whether the cup is placed vertically, and then continue heating.
Exit Heating Mode. When it is constant temperature heating, long press “ ” key for 2
seconds, then the screen displays “Cancel”. The cup exits heating and enters sleep mode.
When the water is heated, its upper and lower temperature is different. Assuming
water temperature is 113°F, there may be deviation on the temperature displayed after
shaking, which is normal.
When the real-time heating temperature is close to the target temperature (approxi-
mately 20°F), the heating will enter a constant temperature state.
1300F
Set
860FSet
1400F
Page | 03
