6 LED Strobe user manual
Protection from burns and re
Do not operate the unit if the ambient temperature (Ta) exceeds 40° C (104° F).
The surface of the product casing can reach up to 55° C (131° F) during
operation. Avoid contact by persons and materials. Allow the unit to cool
for at least 10 minutes before handling.
Keepammablematerialswell away fromtheunit.Keep all combustible
materials (e.g. fabric, wood, paper) at least 10 cm (4 in.) away from the unit.
Ensurethatthereisfreeandunobstructedairowaroundtheunit.Provide
a minimum clearance of 10 cm (4 in.) around fans and air vents.
Do not use the unit to illuminate surfaces within 20 cm (8 in.) of the unit.
Do not attempt to bypass thermostatic switches or fuses.
Donotsticklters,masksorothermaterialsontoanyopticalcomponent.
Protection from eye injury
ThelightfromtheLEDlampispossiblyhazardousandmaybeharmfulto
the eyes. Do not stare directly into the product’s light output.
Donotlookatthelightoutputwithmagniers,telescopes,binocularsor
similar optical instruments that may concentrate the light output.
Ensure that persons are not looking directly into the front of the unit when
the product lights up suddenly. This can happen when power is applied.
Protection from injury
Do not operate the unit near stairways or in other locations where there
is a risk of falls, in corridors or near public exits.
Fastentheunitsecurelytoaxedsurfaceorstructurewheninuse.The
unit is not portable when installed.
Ensure that any supporting structure and/or hardware used can hold at
least 10 times the weight of all the devices they support.
If the unit is installed in a location where it may cause injury or damage
if it falls, install a secondary attachment such as a safety cable that will
hold the unit if a primary attachment fails.
