ASSEMBLY
INSTRUCTIONS
For assistance in assembling product, missing or damaged parts,
or to place an order, please contact Customer Service at 800-328-1061.
Form# 179856A www.smithsystem.com 08.21.2015
ACROBAT™
BULLET, RECTANGLE, PENINSULA & CONTOUR
Rectangle Workstations
26443 Rectangle Instructor Desk 30” x 48”
26453 Rectangle Instructor Desk 30” x 60”
26526 Rectangle Instructor Desk 30” x 72”
26528 Rectangle Instructor Desk 30” x 60” w/ BBF Pedestal
Peninsula Workstations
26213 Peninsula Instructor Desk 36” x 72”
26233 Peninsula Instructor Desk 36” x 60”
Bullet Workstations
26515 Bullet Workstation 24” x 45”
26512 Bullet Workstation 30” x 45”
26516 Bullet Workstation 30” x 60”
26522 Bullet Workstation 30” x 72”
26536 Bullet Instructor Desk 30” x 60” (w/ BBF Ped + Lectern)
26538 Bullet Instructor Desk 30” x 72” (w/ BBF Ped + Lectern)
Contour Workstations
26203 Contour Instructor Desk 36” x 72”
26223 Contour Instructor Desk 36” x 60”
For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179856A 04/2014
For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179856A 04/2014
Replacement pack 69755 includes:
77471 (Qty. 16) 1/4-20X1/2” Combo Drive Machine Screw
70226 (Qty. 8) 10-32X1/2” Machine Screw
77482 (Qty. 2) Tinnerman Clip
70054 (Qty. 16) SM Screw #10X3/4 HI/LO PTH
Shapes and Sizes
Assembly Instructions
Step 1: Flip the top upside down on a clean dry surface. Align the leg sets with the predrilled holes on
the top.
Step 2: Adjust the legs to the desired height by taking out the (4) ¼-20X1/2” Machine screws per leg and
reinserting them at the desired height.
Install (1) Tinnerman Clip per leg in the square hole located inside of the leg.
*NOTE: The Tinnerman Clip is only used if the desk is raised to a high range, when set to a low
range, threaded holes in the lower leg will be used instead of the Tinnerman Clip.
